自然铜、铜合金矿物及其矿床形成机理新探索

描述了自然铜、铜合金矿物及其矿床形成的新机制。在岩浆及热液中，铜及铜合金可呈氢化物、羧基配合物及纳米粒子活性、迁移、富集形成自然铜矿床，或经以后的地质事件，长期、多次迁移富集，叠加形成富而大的自然铜矿床。在表生条件下，铜的硫化矿物被氧化分解，可形成亚铜的硫代硫酸盐及氯配合物，部分可形成铜的硫酸盐配合物迁移，由于硫代硫酸盐被氧化，亚铜岐化可形成高纯度的自然铜，但它易氧化形成孔雀石、蓝铜矿、赤铜矿、黑铜矿、硅孔雀石等，因此很难形成自然铜矿床。     

进口爆破孔钻机配套钻塔的研制

进口DMH90型爆破孔钻机配套钻塔整体性强,起落塔快捷方便,钻塔高度满足不换杆一次成孔,即钻塔有效高度略大于钻孔深度,承受振动冲击力大,施工工作环境恶劣。基于这些特点和难点,爆破塔长期依赖进口,导致成本增高、周期加长,为此进行了进口DMH90型爆破孔钻机配套钻塔的替代进口研究工作。本文介绍了DMH90型爆破孔钻机配套ZT27-45型爆破孔钻塔的研制过程,主要对ZT27-45型爆破孔钻塔的设计要点、结构型式、塔体选材、焊接工艺、防止变形、消除应力、质量检验等方面进行了探索、试验和总结。生产施工实践表明,ZT27-45型钻塔制造质量达到了设计要求,满足爆破孔施工的需要,实现了替代进口,达到了降低成本、缩短工期和提高机械性能的目的。     

石墨炉原子吸收光谱法测定镁基合金中的铍和镍

采用石墨炉原子吸收光谱法测定镁基合金中的铍和镍.研究并校正了基体对待测元素的影响.方法简单、快速.对含铍11.4×10-6、镍9.25×10-6的样品11份测定,相对标准偏差分别为3.5%、4.3%,铍、镍回收率分别为98.8%、97.5%.     

轻量化坑道钻机的研制及应用

为解决坑道钻机质量大,在巷道中搬迁运输困难的问题,采用轻型结构设计与模块化组装思路,结合轻质材料应用,研制了由5052-H38态高强度铝合金作为主材的ZDY1200G型轻量化坑道钻机,钻机快速拆解后单部件最大质量292.5 kg。采用三维DIC散斑变系统对钻机铝合金给进机身在极限载荷下的应变与位移进行了测量分析,测得最大回转负载工况最大主应变为0.87%,最大起拔工况机身关键部位最大位移6.317 mm,未产生塑性变形,满足使用需求。钻机研制成功后在云南省沧源县某矿进行了现场工业性试验,完成了斜向下43°、深度512.68 m的取心钻孔。试验结果表明,采用铝合金的坑道钻机在强度、刚度、可靠性上与碳钢为主材的坑道钻机相当,并且具有搬迁运输方便的优点,能较好地应用于坑道钻探施工。     

Deep CTD Casts in the Challenger Deep,Mariana Trench

On 1 December 1992, CTD (conductivity-temperature-depth profiler) casts were made at three stations in a north-south section of the Challenger Deep to examine temperature and salinity profiles. The station in the Challenger Deep was located at 11°22.78′ N and 142°34.95′ E, and the CTD cast was made down to 11197 db or 10877 m, 7 m above the bottom by reeling out titanium cable of 10980 m length. The southern station was located at 11° 14.19′ N and 142°34.79′ E, 16.1 km from the central station, where water depth is 9012 m. CTD was lowered to 7014 db or 6872 m. The northern station was located at 11°31.47′ N and 142° 35.30′ E, 15.9 km from the central station, and CTD was lowered to 8536 db or 8336 m, 10 m above the bottom. Below the thermocline, potential temperature decreased monotonously down to 7300–7500 db beyond a sill depth between 5500 m and 6000 m, or between 5597 db and 6112 db, of the trench. Potential temperature increased from 7500 db to the bottom at a constant rate of 0.9 m°C/1000 db. Salinity increased down to 6020–6320 db, and then stayed almost constant down to around 9000 db. From 9500 db to the bottom, salinity increased up to 34.703 psu at 11197 db. Potential density referred to 8000 db increased monotonously down to about 6200 db, and it was almost constant from 6500 db to 9500 db. Potential density increased from 9500 db in accordance with the salinity increase. Geostrophic flows were calculated from the CTD data at three stations. Below an adopted reference level of 3000 db, the flow was westward in the north of Challenger Deep and eastward in the south, which suggests a cyclonic circulation over the Challenger Deep. Sound speed in Challenger Deep was estimated from the CTD data, and a relation among readout depth of the sonic depth recorder, true depth, and pressure was examined.     

LF4铝合金在海水中的腐蚀性能研究

对艇用铝材LF4及其它多种管系金属材料进行静态和动态条件下的自然电位、自然腐蚀率、电化学性能、电偶腐蚀行为等进行多方面的腐蚀试验，得出这些材料在静态和动态海水中的腐蚀性能指标以及变化规律。随着海水流速的增加，LF4铝合金耐蚀性迅速降低。LF4在天然海水中有钝化的趋势，但是钝化膜不完整易破坏。在与其它常用管系金属材料组成的电偶对中，LF4均作为阳极受到加速腐蚀。     

非晶态Ni-S合金在碱液中析氢反应(HER)机理的研究

本文研究了非晶态 Ni- S合金的析氢反应机理。用稳态极化曲线研究非晶态 Ni- S合金的极化行为 ,得到其反应的动力学参数塔菲尔斜率和表观反应活化能。用断电流法和循环伏安法研究氢原子的吸附和中间态粒子。考察电极表面粗糙度、活性粒子表面吸附浓度等因素 ,综合分析得出 Ni- S合金电极具有高催化活性的原因及其 HER电催化机理     

复合片取心钻头的研制及其应用

由金刚石共晶体与硬质合金基座制成的复合体是一种新型超硬研磨材料，用它和特制的钻头胎体制成的复合片取心钻头适用于可钻性小于Ⅶ级岩石的钻进，它的应用可大大提高煤系地层（特别是煤心）的采取率。     

Dynamic behavior and applicability of lead alloy absorber

Introduction As the result of economic development, metropolitans spring out in China. In metropolitans,the cities contact with each other through life line systems, the density of population is larger thanother areas, and social treasure in the unit area is much higher than other cities (GAO, 2003). Atthe same time, the risk of potential earthquake disaster in metropolitans increases greatly. One ofcharacters of metropolitan earthquake damage is that each city in the metropolitan will …     

乙酰胺-尿素-NaBr熔体中Ce-Sm-Co合金膜的电化学制备

应用循环曲线法研究了在353 K的乙酰胺-尿素-NaBr熔体中Co2+在Cu电极上的电化学行为,获知Co2+电还原为金属Co是一步不可逆过程,测得a=0.25和Do=3.24×10-6cm2.s-1;而Ce(Ⅲ)、Sm(Ⅲ)不能单独还原为Ce和Sm,但可以被Co(Ⅱ)诱导而共沉积;由恒电位电解法得到非晶态的Ce-Sm-Co合金膜,合金膜中Ce和Sm的含量随电位、时间和浓度的变化而变化。其合金膜中Sm的最高质量分数可以达到47.98%,Ce的最高质量分数可以达到47.32%。