Geo-effectiveness of solar wind extremes

Examples of extreme events of solar wind and their effect on geomagnetic conditions are discussed here. It is found that there are two regimes of high speed solar wind streams with a threshold of ∼ 850 km s^-1. Geomagnetic activity enhancement rate (GAER) is defined as an average increase in Ap value per unit average increase in the peak solar wind velocity (Vp) during the stream. GAER was found to be different in the two regimes of high speed streams with +ve and-ve IMF. GAER is 0.73 and 0.53 for solar wind streams with +ve and -ve IMF respectively for the extremely high speed streams (< 850 km s^-1). This indicates that streams above the threshold speed with +ve IMF are 1.4 times more effective in enhancing geomagnetic activity than those with -ve IMF. However, the high speed streams below the threshold with -ve IMF are 1.1 times more effective in enhancing geomagnetic activity than those with +ve IMF. The violent solar activity period (October–November 2003) of cycle 23 presents a very special case during which many severe and strong effects were seen in the environment of the Earth and other planets; however, the z-component of IMF (Bz) is mostly positive during this period. The most severe geomagnetic storm of this cycle occurred when Bz was positive.     

瞬变电磁法探测公路隧道工程中的不良地质构造

为了给公路设计部门提供选线依据,运用瞬变电磁法在山西境内的某两条高速公路隧道工程设计线路段上进行探测,以查明下覆不良地质构造的发育情况.通过对瞬变电磁法的探测能力进行理论上的讨论,对不同地电断面情况下的异常体电磁响应的定性分析,得出用瞬变电磁法探测不良地质体的可行性结论.经过资料处理,查出不良地质构造赋存的位置,解释结果与钻探资料完全吻合.     

Hysteresis‐based analysis of overland metal transport

Introducing a concept of equivalent mass depth of flow, this study describes the phenomenon of non‐point source pollutant (metal) transport for pavement (or overland) flow in analogy with wave propagation in wide open channels. Hysteretic and normal mass rating curves are developed for runoff rate and mass of 12 dissolved and particulate‐bound metal elements (pollutants) using the rainfall‐runoff and water quality data of the 15 × 20 m² instrumented pavement in Cincinnati, USA. Normal mass rating curves developed for easy computation of pollutant load are found to be of a form similar to Manning's, which is valid for open channel flows. Based on the hysteresis analysis, wave types for dissolution and mixing of particulate‐bound metals are identified. The analysis finds that the second‐order partial‐differential equation normally used for metal transport does not have the efficacy to describe fully the strong non‐linear phenomena such as is described for various metal elements by dynamic waves. In addition, the proportionality concept of the popular SCS‐CN concept is extended for determining the potential maximum metal mass M_p of all the 12 elements transported by a rain storm and related to the antecedent dry period (ADP). For the primary metal zinc element, M_p is found to increase with the ADP and vice versa. Copyright © 2003 John Wiley & Sons, Ltd.     

Modelling the effect of low soil temperatures on transpiration by Scots pine

For ecosystem modelling of the Boreal forest it is important to include processes associated with low soil temperature during spring‐early summer, as these affect the tree water uptake. The COUP model, a physically based SVAT model, was tested with 2 years of soil and snow physical measurements and sap flow measurements in a 70‐year‐old Scots pine stand in the boreal zone of northern Sweden. During the first year the extent and duration of soil frost was manipulated in the field. The model was successful in reproducing the timing of the soil warming after the snowmelt and frost thaw. A delayed soil warming, into the growing season, severely reduced the transpiration. We demonstrated the potential for considerable overestimation of transpiration by the model if the reduction of the trees' capacity to transpire due to low soil temperatures is not taken into account. We also demonstrated that the accumulated effect of aboveground conditions could be included when simulating the relationship between soil temperature and tree water uptake. This improved the estimated transpiration for the control plot and when soil warming was delayed into the growing season. The study illustrates the need of including antecedent conditions on root growth in the model in order to catch these effects on transpiration. The COUP model is a promising tool for predicting transpiration in high‐latitude stands. Copyright © 2006 John Wiley & Sons, Ltd.     

Post-solidification cooling and the age of Io's lava flows

The modeling of thermal emission from active lava flows must account for the cooling of the lava after solidification. Models of lava cooling applied to data collected by the Galileo spacecraft have, until now, not taken this into consideration. This is a flaw as lava flows on Io are thought to be relatively thin with a range in thickness from ∼1 to 13 m. Once a flow is completely solidified (a rapid process on a geological time scale), the surface cools faster than the surface of a partially molten flow. Cooling via the base of the lava flow is also important and accelerates the solidification of the flow compared to the rate for the ‘semi-infinite’ approximation (which is only valid for very deep lava bodies). We introduce a new model which incorporates the solidification and basal cooling features. This model gives a superior reproduction of the cooling of the 1997 Pillan lava flows on Io observed by the Galileo spacecraft. We also use the new model to determine what observations are necessary to constrain lava emplacement style at Loki Patera. Flows exhibit different cooling profiles from that expected from a lava lake. We model cooling with a finite-element code and make quantitative predictions for the behavior of lava flows and other lava bodies that can be tested against observations both on Io and Earth. For example, a 10-m-thick ultramafic flow, like those emplaced at Pillan Patera in 1997, solidifies in ∼450 days (at which point the surface temperature has cooled to ∼280 K) and takes another 390 days to cool to 249 K. Observations over a sufficient period of time reveal divergent cooling trends for different lava bodies [examples: lava flows and lava lakes have different cooling trends after the flow has solidified (flows cool faster)]. Thin flows solidify and cool faster than flows of greater thickness. The model can therefore be used as a diagnostic tool for constraining possible emplacement mechanisms and compositions of bodies of lava in remote-sensing data.     

Motive force of Qinghai-Tibet Plateau moving to east

A calculation formula on spherical pattern of Qinghai-Tibet plateau moving model is established. Tibet massif moves norward by east in speed of 28 mm/a, Ganshu-Qinghai massif moves to northeast in speed of 15 mm/a, Qomolangma Feng moves northward by a few east in speed of 35 ～42 mm/a. The low latitude perimeter is longer than the nigh latitude perimeter. When the Tibet massif moves northward, its latitude perimeter must be contracted and the Tibet massif must move eastward by Coriolis. Coriolis force is inertial in earth rotation. It makes the fall body turning to east and the rising block turning westward. In the Northern Hemisphere, it makes the northward body turning to east and the southward block turning to west.This is the reason why the tectonic zones of western Pacific are different from those of eastern Pacific.     

The influence of macrophyte growth,typical of eutrophic conditions,on river flow velocities and turbulence production

The influence of emergent and submerged macrophytes on flow velocity and turbulence production is demonstrated in a 140 m reach of the River Blackwater in Farnborough, Hampshire, UK. Macrophyte growth occurs in patches and is dominated by Sparganium erectum and Sparganium emersum. In May 2001, patches of S. erectum were already established and occupied 18% of the channel area. The flow adjusted to these (predominantly lateral) patches by being channelled through a narrower cross‐section. The measured velocity profiles showed a logarithmic form, with deviations attributable to topographic control. The channel bed was the main source of turbulence. In September 2001, in‐stream macrophytes occupied 27% of the channel, and overhanging bank vegetation affected 32% of the area. Overall flow resistance, described by Manning's n, showed a threefold increase that could be attributed to the growth of S. emersum in the middle of the channel. Velocity profiles showed different characteristic forms depending on their position relative to plant stems and leaves. The overall velocity field had a three‐dimensional structure. Turbulence intensities were generally higher and turbulence profiles tended to mirror the velocity profiles. Evidence for the generation of coherent eddies was provided by ratios of the root mean square velocities. Spectral analysis identified deviations from the Kolmogorov ?5/3 power law and provided statistical evidence for a spectral short‐cut, indicative of additional turbulence production. This was most marked for the submerged vegetation and, in some instances, the overhanging bank vegetation. The long strap‐like leaves of S. emersum being aligned approximately parallel to the flow and the highly variable velocity field created by the patch arrangement of macrophytes suggest that the dominant mechanism for turbulence production is vortex shedding along shear zones. Wake production around individual stems of S. emersum close to the bed may also be important locally. Copyright © 2006 John Wiley & Sons, Ltd.     

Carbonate aeolianites of western Saurashtra,India: experimental decipherment of the depositional mechanisms

Granular carbonate deposits of Late Pleistocene to Early Holocene age, commonly referred to as ‘miliolite limestone’, occur in a linear belt, parallel to the southern coast of Saurashtra, India. In the present study area these carbonate deposits are found in select valleys between ridges and mounds of pyroclastic material present in the Deccan trap plateau. Two different depositional histories have been proposed for these sediments. The presence of marine bioclasts led to the postulation of a marine origin for these deposits. The second school of thought propounded redeposition of the coastal sediments by aeolian processes. Although a few features could not be explained by the proposed aeolian model, critical comparison of these two views favoured the aeolian origin. The mode of occurrence, lithological and structural attributes, and microscopic evidence presented here, also support a possible aeolian origin for these deposits. Experimental observation indicates that these carbonate aeolianites represent backflow deposits, which accumulated because of the flow separation caused by the presence of topographic highs. The conspicuous concave‐up geometry of the deposit conformed to the shape of the separation bulb. In view of the inferred depositional mechanism, the disposition of the deposits and the signature of the palaeoflow direction suggest that the carbonate particles were derived from the north‐western coast of Saurashtra by strong south‐easterly winds. Massive granular carbonates with outsized basement clasts appear to be the product of avalanching of granular material from the higher contours because of oversteepening of the primary deposit.     

RETRACTION: Numerical simulation of a wind-sand flow under different conditions of atmospheric stability

A theoretical model for wind‐sand flow is developed by considering the coupling between wind flow and sand particle motion, the latter subject to the Magnus effect, under different atmospheric stability conditions. Using this model, the characteristics of the wind‐sand flow are discussed in detail. The results show that the atmospheric stability and the Magnus effect both have a strong influence on wind profiles and on the trajectories of sand particles. This approach produces results with characteristics that differ from those previously reported; the latter only applying to atmospheric conditions of neutral stability. The saltating sand reaches a greater height under non‐neutral stability than under neutral stability, while the maximum horizontal distance is greater under unstable conditions and is smaller under stable conditions than under conditions of neutral stability.     

U–Pb SHRIMP zircon geochronology and T–t–d history of the Kampa Dome, southern Tibet

Structural, petrographic and geochronologic studies of the Kampa Dome provide insights into the tectonothermal evolution of orogenic crust exposed in the North Himalayan gneiss domes of southern Tibet. U–Pb ion microprobe dating of zircons from granite gneiss exposed at the deepest levels within the dome yields concordia ²⁰⁶Pb/²³⁸U age populations of 506 ± 3 Ma and 527 ± 6 Ma, with no evidence of new zircon growth during Himalayan orogenesis. However, the granite contains penetrative deformation fabrics that are also preserved in the overlying Paleozoic strata, implying that the Kampa granite is a Cambrian pluton that was strongly deformed and metamorphosed during Himalayan orogenesis. Zircons from deformed leucogranite sills that cross-cut Paleozoic metasedimentary rocks yield concordant Cambrian ages from oscillatory zoned cores and discordant ages ranging from ca. 491–32 Ma in metamict grains. Since these leucogranites clearly post-date the metasedimentary rocks they intrude, the zircons are interpreted as xenocrysts that are probably derived from the Kampa granite. The Kampa Dome formed via a series of progressive orogenic events including regional ~ N–S contraction and related crustal thickening (D₁), predominately top-to-N ductile shearing and crustal extension (D₂), top-to-N brittle–ductile faulting and related folding on the north limb of the dome, localized top-to-S faulting on the southern limb of the dome, and crustal doming (D₃), and continued N–S contraction, E–W extension and doming (D₄). Structural and geochronologic variability amongst adjacent North Himalayan gneiss domes may reflect changes in the magnitude of crustal exhumation along the North Himalayan antiform, possibly relating to differences in the mid-crustal geometry of the exhuming fault systems.