用于多频电磁波测井的负阻抗变换式有源接收天线

本文对用负阻抗变换电路同小圆锥螺旋天线相结合,构成的有源接收天线进行了理论分析,并给出了该有源天线稳定工作的条件。结果表明,用该方法设计的有源接收天线具有较宽的频带、较高的灵敏度和较小的尺寸。是多频电磁波测井较理想的接收天线。     

X射线荧光测井井液的影响与校正

X射线荧光测井中 ,井液位于井下探管与井壁之间 ,它的影响不但表现在对特征X射线的吸收 ,而且表现在对源初级射线和特征 X射线的散射。井液的校正采用硬件与软件相结合的方法 ,在硬件上 ,使含有探测器的部分制成单独的短臂 ,有效地保证了探测窗与井壁的良好接触 ;在软件上 ,提出的双散射峰法和散射峰 -逃逸峰法 ,能够校正 0 - 10 mm厚的井液对 X射线荧光测井结果的影响     

一种分析砂岩沉积相的新方法——测井相分析

本文分析了以地层倾角测井资料为核心的各种测井相标志，提出了应用测井资料进行沉积相分析的方法和步骤，并在塔里木盆地三个油田进行了测井地质相分析。     

X射线荧光测井的井液效应及其校正

本文从Ｘ射线的性质，以及Ｘ射线与物质作用的机理出发，对井液效应进行了研究，并对其影响过程进行模拟。在理想井液模型上，推导出Ｘ射线活度与钻孔参数的数理关系。在此基础上，进一步研究得到了能适应野外多变情况的井液效应校正公式（ＣＢＷＥ）和方法。     

用土的分形结构确定土的水份特征曲线

运用筛析法和比重计法，分析了宁夏膨胀土的颗粒分布，发现粒径介于0．002～0．1mm的粒度分布是分形的，分维介于2．46～2．67；运用上孔隙分布的分维确定水份特征曲线，得到了很好的结果。此外，还探讨了粒度分形分布的机制。     

地震和测井资料联合反演储层物性参数的方法

为了充分利用测井资料较高的纵向分辨率及其反映井壁周围物性直接准确的特点和地震资料良好的横向可追踪性，针对厚储层和薄储层地震—地质模型分别提出了利用测井和地震资料联合反演纵横波速度和密度参数的方法。理论模型的计算结果表明，反演方法是切实可行的     

Attenuation differences in layer 2A in intermediate- and slow-spreading oceanic crust

In situ seismic attenuationQ⁻¹logs are derived from borehole velocity profiles and reveal sharp boundaries between morphologies of the extrusive volcanic layers in intermediate- and slow-spreading oceanic crust.Q⁻¹logs are calculated from the scattering attenuation associated with vertical velocity heterogeneity in Ocean Drilling Program Holes 504B and 896A and in Hole 395A, located in 5.9–7.3 Ma crust on the Pacific and Atlantic plates, respectively. Our results strongly tie crustal properties to seismic measurables and observed geological structures: we find that the scattering attenuation can be used to identify the extrusive volcanic sequence because it is closely related to changes in the degree of vertical heterogeneity. We interpret a distinct decrease in the Q⁻¹log at the transition below the extrusive volcanic layer to correspond with the seismic layer 2A/2B boundary. The boundary is located at 465 m depth below the sea floor in both Hole 395A and 504B, although this is likely to be a coincidence of the sediment thickness at these sites. Layer 2A is estimated to be approximately 150 m thick in Hole 504B and > 300 m thick in Hole 395A. Cyclic sequences of high-porosity pillows and low-porosity massive units in the uppermost 100 m of volcanics in Hole 395A result in large velocity heterogeneities which cause > 5 times more attenuation in this layer than in Hole 504B. In Hole 896A, by contrast, fewer pillows, more massive flows, and a greater volume of carbonate veins decrease the velocity heterogeneity and attenuation significantly over only 1 km distance from Hole 504B. We conclude that the attenuation in the extrusive volcanics of the ocean crust is largely controlled by variation in local heterogeneity and morphology as well as by subsequent hydrothermal alteration. The observed differences inQ⁻¹profiles and layer 2A thickness at these sites may be attributed to variations in the volume and duration of volcanic activity at mid-ocean spreading centers for these Pacific and Atlantic ridge segments.     

Observations of particle movement in a monitoring well using the colloidal borescope

The colloidal borescope consists of a set of lenses and miniature video cameras capable of observing natural particles in monitoring wells. Based on field observations of these particles, it appears possible to measure in situ groundwater velocity in a well bore. Field observations have shown that directional measurements using the colloidal borescope are generally in good agreement with expected flow directions. However, the magnitude of flow velocity is higher compared with values based on conventional test methods. High relative flow velocities, even after correction factors have been applied to compensate for well bore effects, are believed to be due to preferential flow zones in the surrounding aquifer. Low flow zones exhibit swirling multidirectional flow that does not allow for a linear velocity measurement. Consequently, groundwater flow velocities measured by the colloidal borescope in heterogeneous aquifers will be biased toward the maximum velocity values present in the aquifer. A series of laboratory experiments was conducted to assess the reliability of the instrument. Based on this work, a seepage velocity correction factor ( ) of 1–4 was found for quantifying groundwater seepage velocity in the adjacent aquifer from observations in a well bore. Laboratory measurements also indicate that preferential flow in the surrounding aquifer dominates flow in the well. Results of this work suggest the possibility of quantifying higher-flow velocities associated with preferential flow zones in the subsurface.     

油田中,高含水期小层剩余油研究

综合利用岩心分析、测井及动态开发资料研究了扶余油田西一、二区北的剩余油分布规律，所研制的油田中、高含水期确定小层剩余油分布图，解决了油田开发中的动态预测小层剩余油分布的难题，并且对１９８２年和１９９２年底的剩余油分布规律作了分析。     

利用前兆事件对云南地区地震进行中短期预测研究

对某些类型的主震事件, 进行中短期预测也许是可能的. 利用Varnes, Bufe和Varnes提出的破裂时间法模拟前兆地震能量加速释放模型,通过实际观测资料与理论公式的拟合, 可以建立主地震事件的中短期预测技术, 用以确定表示主震的地点、时间和震级大小. 本文使用的是云南区域台网的地震目录资料，覆盖的时间段为1965~2002年. 统计分析表明，在此37年时间内，等于或大于2.5级地震资料是相当完整的. 本文对云南地区的30次主震事件进行了模拟，其中25次主震事件由前兆序列模拟得到的预测时间和震级与实际值相当接近，主震震级预测精度约0.57个震级单位，假定已知前兆序列中最后一次事件，则预测主震发生时间误差约0.64年.对另外的5次主震事件，由于没有足够的前兆事件来充分确定前兆能量加速曲线或是存在对能量加速释放曲线的干扰事件，而不能进行破裂时间法模拟.本文的研究结果还表明，由于云南是破坏性地震和中小地震活跃的地区，因此，主地震与前兆事件最佳搜索半径不存在明显的线性关系.主震矩与系数k，m之间存在强烈的相关性，利用主震地震矩与系数的关系和限制指数m的取值范围，可进一步缩小预测时间和预测震级的最佳拟合区范围，提高了模拟主震事件的预测精度. 本文采用破裂时间法对30次主震事件进行拟合，80％以上获得了较好的结果. 显示出该方法在预测已知主震事件序列的能力方面大有希望，因此，利用前兆事件对未来主震事件进行中短期预测的前景是令人鼓舞的.