鄂尔多斯盆地北部塔巴庙地区与地层挠曲变形有关的构造裂缝分布定量预测

塔巴庙地区位于鄂尔多斯盆地北部伊陕斜坡构造带上,构造平缓,一般认为不具备裂缝发育条件.然而大量岩心观察、薄片分析、物性测试、测井及试井资料证实,研究区上古生界发育区域性分布的构造裂缝系统和与地层局部挠曲变形有关的局部构造裂缝系统.本文重点介绍与低幅度地层挠曲变形有关的裂缝预测方法,以及主要勘探层裂缝发育部位、发育程度和裂缝系统产状等成果.研究表明,地层挠曲变形主要发生于燕山期构造运动,喜马拉雅期对地层有一定改造作用.构造裂缝对致密储层储集性能作用意义不大,但对储层渗透率的改善作用明显.      

水泥土挡墙压顶梁对基坑变形影响研究

在分析水泥土挡墙变形机理基础上,对压顶梁的作用进行了研究,并深入探讨了压顶梁的有效利用范围和优化措施。工程实例表明,合适的压顶梁是控制挡墙变形的一种有效措施。     

东亚地区现代地壳运动特征与构造变形

根据“中国地壳运动观测网络”首次发布的GPS观测结果以及国际地球自转服务中心在 2 0 0 0年发布的ITRF97下的站速度矢量和“东南亚地球动力学项目”GPS网的观测结果 ,讨论了东亚地区现今地壳运动和构造变形特征。在ITRF97参考系下 ,中国大陆东部现今地壳运动以向南东方向(12 0 130°)运动为主 ,量值平均为 35mm/a ,西部受印度板块向北东碰撞的影响 ,运动方向发生偏转 ,呈显北东—近东西向运动 ,但这种影响涉及的范围达到了准噶尔盆地北缘一线 ,说明碰撞型板块边界对板内变形的影响远大于俯冲型板块边界。平均来看 ,75 %以上的印度板块相对于欧亚板块间的南北向缩短是通过地壳增厚变形来吸收的 ,这意味着在调节整个青藏高原构造变形的过程中 ,逆断和地壳增厚起了主要的作用。东南亚块体总体上与欧亚板块的运动有所差异 ,相对于欧亚大陆有 10mm/a左右向东的运动。菲律宾板块南部向西的运动速度只有 2 4mm/a。包括华南地块在内的东南亚块体的运动不仅仅是与印度板块的碰撞过程有关 ,也应当与沿着东南亚块体东边界的俯冲过程有关。     

Tectonic Evolution of the Himalayan Collision Belt

This paper discusses the tectonic divisions of the Himalayan collision belt anddeals with the tectonic evolution of the collision belt in the context of crustal accretion in thefront of the collision belt, deep diapirism and thermal-uplift extension and deep material flow-ing of the lithosphere-backflowing. Finally it proposes a model of the tectonic evolution-progressive intracontinental deformation model-of the Himalayan belt.     

基于TLS的滑坡形变分析方法研究

以四川理县一地质滑坡为例,分析扫描点空间位置的理论精度,探讨点云数据获取以及点云过滤、点云拼接、地理参考等数据预处理的关键技术,给出一套比较直观、全面的滑坡形变分析方法,包括基于点云比较的形变分析、基于TIN比较的形变分析、基于特征点的形变分析以及基于DEM的形变分析。为了充分利用非地面点云数据,提出一种提取滑坡区域电线杆、树干的几何特征来分析滑坡水平变化的新方法。通过分析得到的滑坡形变量与GNSS远程实时监测结果基本一致。     

喜马拉雅东构造结及周边地区地壳各向异性特征

利用喜马拉雅东构造结及周边地区的48个宽频带地震台站记录的远震波形数据,通过Pms波分裂测量得到了295对地壳各向异性横波分裂参数,获得了研究区的地壳各向异性图像.喜马拉雅东构造结的快波偏振方向主要为NE-SW方向,周边地区的快波偏振方向呈现出绕东构造结顺时针旋转的趋势.Pms波分裂的慢波延迟时间范围为0.11~0.30 s,平均值为0.24 s.对比分析研究区内Pms波分裂、近震直达S波分裂和远震SKS波分裂的结果发现,上地壳各向异性对Pms波分裂影响有限,地壳各向异性主要来自于中下地壳矿物和熔体的定向排列;地壳各向异性对SKS波分裂影响较小,SKS波分裂主要反映了上地幔的各向异性特征;Pms波分裂的快波偏振方向与近震直达S波分裂和远震SKS波分裂的快波偏振方向表现出较好的一致性,并且与地表构造和变形特征具有较好的相关性,反映了喜马拉雅东构造结及周边地区的岩石圈变形可能为垂直连贯变形模式.

     

青藏高原隆升及伸展变形中的重力位能

青藏高原在南侧印度板块和北侧欧亚板块的双向挤压下整体抬升,边界挤压力所作的功增加了高原内部重力位能.但高位能态的物质会不断向重力势能最小的平衡态转移,并产生流变变形.由于受南北边界的挤压力约束,高原内部的高位能驱使喜马拉雅山和昆仑山之间的地体产生东西向伸展变形.利用三种不同方法对青藏高原重力位能进行计算,结果表明,一定流变学条件下,青藏高原目前所具有的重力位能可以产生各地体中观测到的地表构造变形速率.     

基坑支护结构水平变形预测的遗传神经网络方法

采用遗传算法和误差反向传播算法相结合的混合算法来训练前馈人工神经网络,先用遗传学习算法进行全局训练,再用BP算法进行精确训练。就遗传算法过程中的选择、变异进行了探索,提出了用BP网络训练产生变异的遗传算法。作为实例,将该方法应用于预测基坑支护结构水平变形中。结果表明,该方法有收敛速度较快、预测精度高等优点。     

Seismic geomorphology of cretaceous megaslides offshore Namibia (Orange Basin): Insights into segmentation and degradation of gravity-driven linked systems

This study applies modern seismic geomorphology techniques to deep-water collapse features in the Orange Basin (Namibian margin, Southwest Africa) in order to provide unprecedented insights into the segmentation and degradation processes of gravity-driven linked systems. The seismic analysis was carried out using a high-quality, depth-migrated 3D volume that images the Upper Cretaceous post-rift succession of the basin, where two buried collapse features with strongly contrasting seismic expression are observed. The lower Megaslide Complex is a typical margin-scale, extensional-contractional gravity-driven linked system that deformed at least 2 km of post-rift section. The complex is laterally segmented into scoop-shaped megaslides up to 20 km wide that extend downdip for distances in excess of 30 km. The megaslides comprise extensional headwall fault systems with associated 3D rollover structures and thrust imbricates at their toes. Lateral segmentation occurs along sidewall fault systems which, in the proximal part of the megaslides, exhibit oblique extensional motion and define horst structures up to 6 km wide between individual megaslides. In the toe areas, reverse slip along these same sidewall faults, creates lateral ramps with hanging wall thrust-related folds up to 2 km wide. Headwall rollover anticlines, sidewall horsts and ramp anticlines may represent novel traps for hydrocarbon exploration on the Namibian margin.The Megaslide Complex is unconformably overlain by few hundreds of metres of highly contorted strata which define an upper Slump Complex. Combined seismic attributes and detailed seismic facies analysis allowed mapping of headscarps, thrust imbrications and longitudinal shear zones within the Slump Complex that indicate a dominantly downslope movement of a number of coalesced collapse systems. Spatial and stratal relationships between these shallow failures and the underlying megaslides suggest that the Slump Complex was likely triggered by the development of topography created by the activation of the main structural elements of the lower Megaslide Complex.This study reveals that gravity-driven linked systems undergo lateral segmentation during their evolution, and that their upper section can become unstable, favouring the initiation of a number of shallow failures that produce widespread degradation of the underlying megaslide structures. Gravity-driven linked systems along other margins are likely to share similar processes of segmentation and degradation, implying that the megaslide-related, hydrocarbon trapping structures discovered in the Namibian margin may be common elsewhere, making megaslides an attractive element of deep-water exploration along other gravitationally unstable margins.     

藏东巴青县北部酉西岩组构造片理形成及构造意义

西藏巴青县以北酉西岩组主要由石英构造片岩、钠长石英构造片岩、白云母石英构造片岩组成,构造片理为近水平韧性剪切作用产物。宏观上构造片理构成了宽缓的背形、向形褶皱构造,构造片理上广布一期透入性拉伸线理,将构造片理展平,分布在透入性片理上的线理具明显优选方位,方向为280~100°。根据微观构造分析,韧性剪切指向为自西向东运动,构造片岩内发育多硅白云母。多硅白云母电子探针分析结果认为其形成环境为低温高压蓝片岩相,变质温度确定为320~500℃、压力0·6~1·1GPa。多硅白云母40Ar/39Ar测年结果为(230±1)Ma,为中三叠世末期。酉西岩组构造片理(韧性剪切作用)与查吾拉—吉塘印支期构造岩浆带形成密切相关。