Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

东南极Lambert冰川-Amery冰架系统平衡通量分布的计算

通过对Lambert冰川盆地(LGB)考察路线上约1 700 km长的LGB剖面和距冰架末端约50 km、长150 km的A剖面, 分别利用GPS冰流速值及雷达测厚值进行冰通量的计算得出:每年流过LGB剖面的冰通量为43.95 Gta-1, 而通过A剖面的冰通量仅为26. 42 Gt*a-1, Amery冰架底部净融化量为7.8 Gt*a-1. 整个Lambert冰川-Amery冰架系统(LAS)地区的表面净物质平衡总量约为90 Gt*a-1; LGB地区的表面净物质平衡总量为46 Gt*a-1. 通过分析得出, 整个LAS地区及LGB地区均处于物质正平衡状态, 而LAS流域的上游区域S'则处于物质负平衡状态.     

渤海湾盆地北部奥陶纪岩相古地理

渤海湾盆地北部主要包括黄骅坳陷、沧县隆起、冀中坳陷和下辽河坳陷,区内奥陶系厚 6 0 0～ 80 0m,主要由石灰岩和白云岩组成。下奥陶统分为冶里组和亮甲山组,中奥陶统分为下马家沟组、上马家沟组和峰峰组,上统缺失。其中下马家沟组、上马家沟组和峰峰组又进一步划分为下段和上段。早奥陶世冶里期和亮甲山期,本区以局限海环境为主,其内散布着一些潮坪和滩。中奥陶世,本区岩相古地理面貌变化旋回极为明显,下马家沟期早期潮坪广布,晚期以局限海为主;上马家沟期早期又是潮坪广布,晚期以开阔海为主;峰峰期早期潮坪广布,晚期又以开阔海为主。在奥陶纪,本区经历了 4个大的海侵-海退旋回,其中上马家沟期晚期是本区乃至整个华北地台的最大海侵期。     

碳酸盐岩差异性风化成土特征及其对石漠化形成的影响

碳酸盐岩极低的酸不溶物含量使岩石风化产生的残积土壤物质数量极少，并产生巨大的体积缩小，促使早期形成的残积土在重力作用下不断向下塌陷。显著的差异性风化使基岩面强烈起伏，甚至形成大量的岩溶尘洼地、裂隙、地下管道、洞穴系统等。在重力和水的作用下，土粒沿垂直和水平方向上经微距离或短距离搬运到上述低洼或地下空间中，甚至由地下河带到更远的地方，这是碳酸盐岩地区土壤丢失的重要方式，也是形成石漠化最主要的地质因素。土壤在地表分布高度不均匀，是碳酸盐岩地区的地表少土的重要原因。对于酸不溶物含量相当的石灰岩和白云岩而言，由于白云岩的差异性风化明显弱于石灰岩，以及受各种应力作用后，白云岩形成的节理及裂隙密集而均匀，从而提高了近地表白云岩的含水能力，延长了风化过程中的水－岩反应时间，使风化作用可以相对集中于地表或近地表进行，有利于岩石的整体风化作用的进行，同时使白云岩风化壳基岩面起伏相对较小，风化残积形成的土壤分布也相对均匀。因此，白云岩区地表土层较厚，石漠化程度也稍弱于灰岩区。     

豫西地区铝土矿中镓的分布规律研究

镓是一种价格昂贵的稀散金属，其应用前景十分广阔。豫西地区的铝土矿石中含有丰富的镓资源。通过对区内铝土矿石中镓的分布特征做了多方面的对比研究，归纳出镓的分布规律：空间上，在不同铝土矿区的矿石中镓的平均质量分数变化显著，在矿体平均厚度最大的张窑院矿区，矿石中的镓高度富集。时间上，沉积成矿相对较早的铝土矿层，因其长期遭受强烈的表生富集作用，矿石中镓的平均品位较高。从矿石结构类型来看，土状和峰窝状矿石中的镓品位明显高于短、鲕状和致密状矿石。另外，矿石中镓平均含量的变化总与铝土矿富矿体的产出位置关系密切。并且，探讨了铝土矿中镓分布规律的控制因素。     

An experimental study of grain scale melt segregation mechanisms in two common crustal rock types

Creation of pathways for melt to migrate from its source is the necessary first step for transport of magma to the upper crust. To test the role of different dehydration‐melting reactions in the development of permeability during partial melting and deformation in the crust, we experimentally deformed two common crustal rock types. A muscovite‐biotite metapelite and a biotite gneiss were deformed at conditions below, at and above their fluid‐absent solidus. For the metapelite, temperatures ranged between 650 and 800 °C at P_c=700 MPa to investigate the muscovite‐dehydration melting reaction. For the biotite gneiss, temperatures ranged between 850 and 950 °C at P_c=1000 MPa to explore biotite dehydration‐melting under lower crustal conditions. Deformation for both sets of experiments was performed at the same strain rate (ε.) 1.37×10^?5 s^?1. In the presence of deformation, the positive ΔV and associated high dilational strain of the muscovite dehydration‐melting reaction produces an increase in melt pore pressure with partial melting of the metapelite. In contrast, the biotite dehydration‐melting reaction is not associated with a large dilational strain and during deformation and partial melting of the biotite gneiss melt pore pressure builds more gradually. Due to the different rates in pore pressure increase, melt‐enhanced deformation microstructures reflect the different dehydration melting reactions themselves. Permeability development in the two rocks differs because grain boundaries control melt distribution to a greater extent in the gneiss. Muscovite‐dehydration melting may develop melt pathways at low melt fractions due to a larger volume of melt, in comparison with biotite‐dehydration melting, generated at the solidus. This may be a viable physical mechanism in which rapid melt segregation from a metapelitic source rock can occur. Alternatively, the results from the gneiss experiments suggest continual draining of biotite‐derived magma from the lower crust with melt migration paths controlled by structural anisotropies in the protolith.     

Cation distribution and structure modelling of spinel solid solutions

 This paper presents an improved generalisation of cation distribution determination based on an accurate fit of all crystal-chemical parameters. Cations are assigned to the tetrahedral and octahedral sites of the structure according to their scattering power and a set of bond distances optimised for spinel structure. A database of 295 spinels was prepared from the literature and unpublished data. Selected compositions include the following cations: Mg²⁺, Al³⁺, Si⁴⁺, Ti⁴⁺, V³⁺, Cr³⁺, Mn²⁺, Mn³⁺, Fe²⁺, Fe³⁺, Co²⁺, Ni²⁺, Zn²⁺ and vacancies. Bond distance optimisation reveals a definite lengthening in tetrahedral distance when large amounts of Fe³⁺ or Ni²⁺ are present in the octahedral site. This means that these cations modify the octahedral angle and hence the shared octahedral edge, causing an increase in the tetrahedral distance with respect to the size of the cations entering it. Some applications to published data are discussed, showing the capacity and limitations of the method for calculating cation distribution, and for identifying inconsistencies and inaccuracies in experimental data. Received: 19 February 2001 / Accepted: 1 June 2001     

1987年8月2日江西省寻乌MS5.5级地震的震害与烈度分布

从寻乌5.5级地震的地震地质构造背景，宏观震害考察结果。结合近场强地面运动观测中几次较大地震的加速度峰值。分析宏观烈度分布特征。认为烈度分布特征除了受构造控制外，还与地形，地基土质条件有关，极震区长轴方向显示鸡笼嶂-寻乌-八尺北西向断裂是寻乌地震的主要发震断层，发震构造受控于华南块体构造应力场，发震区处于北北东向河源-邵武断裂中段和东西向断裂交汇部位。     

《CT理论与应用研究》杂志新刊标和地幔速度模型的说明

在《ＣＴ理论与应用研究》杂志１９９４~２００１年本杂志“刊标”的基础上,在其上方增加了象征三维体视学成像的三角形四面体的透视图;该刊标的右下侧为医学断面成像扫描仪(包括各种Ｘ－ＣＴ机与核磁共振ＭＲＩ扫描仪等);其左下侧为三维地幔速度模型和地球核的示意图,切出有两个地幔剖面,表示纵波速度二维变化的剖面。该速度剖面系根据赵大鹏教授的理论和计算方法,按照地球上的两个大圆弧做计算和绘制的彩色图,排在本期封４:第一大圆弧,从北极经西巴基斯坦(２８°Ｎ, ６４°Ｅ)到马尔代夫群岛(３°Ｎ,７３°Ｅ);第二大圆弧从马尔代夫群岛点(３°Ｎ,７３°Ｅ)连接巴布新几内亚之南点(１２°Ｓ,１５０°Ｅ),来计算两剖面速度分布并作图的结果,其具体分布参见封４的两条彩色剖面和相应的地理位置图。由于赵教授这篇论文[１]在中国国内只有很少数图书馆收藏,在Ｅｌｓｅｖｉｅｒ Ｓｃｉｅｎｃｅ的ＥＰＳＬ网站上一般人只能查到摘要,本刊对于该地幔速度模型的制作方法和所用数据资料,该模型的优越性和特征进行了叙述,他所用的地震事件数目,多达７１２８个;用于层析反演成像的震相到时数多到近一百万条。该速度如下的特点:在所采用的速度结构中,包含用几个复杂形状的地质速度界面,如莫霍面,以及下沉板块的分界