人造热带气旋垂直结构问题初探

在人造热带气旋中引入了倾斜垂直结构，并将其用于西折后9806号热带气旋登陆路径的数值模拟。结果表明：应用该方案所得到的模拟结果优于应用正压结构的人造热带气旋方案的模拟结果要准确。因此，此类热带气旋的预报中，其初始涡旋可采用倾斜垂直结构，从而提出改进热带气旋初始涡旋的一种新思路。若对其作进一步研究、推广，则具有广阔的业务应用前景。     

可控深度电法对水平柱体和垂直界面的计算和实验

球状地球体可控深度电法的效应系数可近似地全面表达可控深度电法和各种效应。通过点源二度体的电算模拟实验，证明了该方法在水平柱状体和地下存在电阻率垂直界面的条件下，也是有效的。     

基于GM(1,1)优化模型的岩石边坡变形预报

岩石边坡系统是一典型灰色系统，其变形发展过程可以用灰色预测模型完成。尽管传统GM（1，1）模型预测有很多成功的实例，但是也存在一些预测偏差过大的情况，必须对其进行优化。逐步迭代法GM（1，1）模型不仅收敛速度快，而且与原始数据库序列的凹凸性保护一致。利用自编的计算程序对马步坎边坡预测测点G1沉降和开裂进行预测分析，结果表明逐步迭代法GM（1，1）优化模型计算精度较传统GM（1，1）模型和背景构造法GM（1，1）优化模型高，较好地反映了岩石边坡的变形趋势。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

Behaviour of a rupture of the 21 June 2000 earthquake in South Iceland as revealed in an asphalted car park

A major earthquake (M=6.6) occurred on 21 June 2000, in South Iceland. This paper presents an unusual example of left-lateral strike-slip displacement recorded in a newly asphalted car park surface through a mechanically consistent pattern of open fissures and pressure ridges resulting from simple shear and rotation. Measurement of these features allows accurate reconstruction of the local deformation. The behaviour of the asphalt layer resembles that of analogue physical models, especially in terms of rotations induced by shear deformation. It is finally shown that through a wide range of scales some basic patterns associating rotation and opposite senses of strike-slip exist in the South Iceland Seismic Zone.     

Numerical Analysis of Space–Time Finite Element Formulations for Miscible Displacements

A finite element formulation is proposed to approximate a nonlinear system of partial differential equations, composed by an elliptic subsystem for the pressure–velocity and a transport equation (convection–diffusion) for the concentration, which models the incompressible miscible displacement of one fluid by another in a rigid porous media. The pressure is approximated by the classical Galerkin method and the velocity is calculated by a post-processing technique. Then, the concentration is obtained by a Galerkin/least-squares space–time (GLS/ST) finite element method. A numerical analysis is developed for the concentration approximation. Then, stability, convergence and numerical results are presented confirming the a priori error estimates.     

桥梁限位器抗震设计方法研究

本文建立了两跨简支梁桥和五跨多跨刚架桥两结构模型，针对限位器的种类、刚度、强度、安装位置，输入地震动等进行了大量工况下的数值模拟研究。研究表明限位器与柱（框架）的刚度比在0.5-2之间较优。将现有的限位器设计方法应用于两算例结构，对现有限位器设计方法进行了比较研究。     

依据剖面资料求解断层的水平位移

提出依据开挖剖面中的楔形体在受到断层作用时其厚度的变化量求解断层水平位移的方法。分析表明断层水平位移量S与楔形体在断层两侧厚度变化量Δh满足关系式S＝Δh/ρsinβ。式中ρ为楔形体在断层走向上的尖灭系数，β为断层的倾角，该关系式不仅能满足纯走滑运动的断层，而且也满足一般斜滑断层，同时提出了在剖面上判断断层水平运动性质的方法。     

Recent developments in seismically isolated buildings in Japan

The Building Standard Law of Japan and related Enforcement Order and Notifications have been substantially revised since the year 2000 to introduce a performance-based regulatory and deregulation system for building control systems. Up to then, time-history analyses were mandatory for isolated buildings and had to be specially approved by the Minster of the Ministry of Construction (MOC). Simplified design procedures based on the equivalent linear method for seismically isolated buildings have been issued as “Notification 2009 — Structural calculation procedure for buildings with seismic isolation” from MOC, and are now integrated into the Ministry of Land, Infrastructure, and Transportation (MLIT). Along with Notification 2009, “Notification 1446 of year 2000 — Standard for specifications and test methods for seismic isolation devices” was also issued. Buildings with heights equal to or less than 60m and that are designed according to these Notifications, including base isolated buildings, only need approval from local building officials, and no longer require the special approval of the Minister of MLIT. This paper summarizes: 1) some statistics related to buildings with seismic isolation completed up to the end of 2001; 2) simplified design procedures required by Notification 2009 of year 2000; and 3) performance of seismic isolation devices required by Notification 1446 of year 2000.