联合GPS和GRACE数据分析陕甘宁地区地表垂直形变

采用甘肃省CORS网和中国大陆构造环境监测网络中共48个台站的GPS观测数据，解算得到观测台站的垂直位移，并与GRACE时变重力场Mascon模型解CSR RL05M数据计算得到的垂直形变进行比较，分析区域地表垂直形变特征。结果表明，研究区内台站垂直形变存在局部特征，甘肃庆阳和平凉地区垂直形变与其他地区存在明显差异，相关系数、均方根减少量和周年信号减少量均高于其他地区；扣除趋势项后，观测台站GPS垂直位移与GRACE垂直形变时间序列相关系数均值为0.72，GPS和GRACE周年信号振幅均值分别为6.00 mm和3.70 mm，周年信号减少量和均方根误差减少量均值分别为0.51和0.29；研究区内GPS垂直位移和GRACE垂直形变时间序列一致性较强，GRACE垂直形变能有效解释50%以上的GPS垂直位移周年信号，GPS垂直位移时间序列包含的非构造形变中平均约29%来源于环境负载变化所引起的负荷形变。     

Modelling spatial variations in dissolved oxygen in fine‐grained streams under uncertainty

This paper presents a novel triple‐layer model, called VART DO‐3L, for simulation of spatial variations in dissolved oxygen (DO) in fine‐grained streams, characterized by a fluid mud (fluff or flocculent) layer (an advection‐dominated storage zone) as the interface between overlying stream water and relatively consolidated streambed sediment (a diffusion‐dominated storage zone). A global sensitivity analysis is conducted to investigate the sensitivity of VART DO‐3L model input parameters. Results of the sensitivity analysis indicate that the most sensitive parameter is the relative size of the advection‐dominated storage zones (A_s/A), followed by a lumped reaction term (R) for the flocculent layer, biological reaction rate (μ_o) in diffusive layer and biochemical oxygen demand concentration (L) in water column. In order to address uncertainty in model input parameters, Monte Carlo simulations are performed to sample parameter values and to produce various parameter combinations or cases. The VART DO‐3L model is applied to the Lower Amite River in Louisiana, USA, to simulate vertical and longitudinal variations in DO under the cases. In terms of longitudinal variation, the DO level decreases from 7.9 mg l at the Denham Springs station to about 2.89 mg l^?1 at the Port Vincent station. In terms of vertical variation, the DO level drops rapidly from the overlying water column to the advection‐dominated storage zone and further to the diffusive layer. The DO level (C_F) in the advective layer (flocculent layer) can reach as high as 40% of DO concentration (C) in the water column. The VART DO‐3L model may be applied to similar rivers for simulation of spatial variations in DO level. Copyright © 2014 John Wiley & Sons, Ltd.     

Critical Top Tension for Static Equilibrium Configuration of A Steel Catenary Riser

This paper aims to present the critical top tension for static equilibrium configurations of a steel catenary riser（SCR） by using the finite element method. The critical top tension is the minimum top tension that can maintain the equilibrium of the SCR. If the top tension is smaller than the critical value, the equilibrium of the SCR does not exist. If the top tension is larger than the critical value, there are two possible equilibrium configurations. These two configurations exhibit the nonlinear large displacement. The configuration with the smaller displacement is stable, while the one with larger displacement is unstable. The numerical results show that the increases in the riser＇s vertical distances, horizontal offsets, riser＇s weights, internal flow velocities, and current velocities increase the critical top tensions of the SCR. In addition, the parametric studies are also performed in order to investigate the limit states for the analysis and design of the SCR.     

Analysis of rectangular piles subjected to lateral loads in nonhomogeneous soil using a Winkler model approach

An analytical approach using a Winkler model based on two lateral soil displacement components in a three‐dimensional soil is investigated to provide analytical solutions of horizontal response of a rectangular pile subjected to lateral loads in nonhomogeneous soil. The two lateral displacement components of a soil surrounding the rectangular pile are represented by the Fourier series of displacement potential functions in the elastic three‐dimensional analysis. The lateral stiffness coefficient of the rectangular pile shaft in nonhomogeneous soil is derived from the rocking stiffness coefficient taking into account rocking rotation of a rigid pile shaft. The relationship between horizontal displacement, rotation, moment, and shear force for the rectangular pile subjected to horizontal loads in nonhomogeneous soil is obtainable in the form of the recurrence equation. The formulation of lateral displacement and rotation for a rectangular pile subjected to lateral loads on the pile base in nonhomogeneous soil is proposed by taking into account Mindlin's equation and the equivalent thickness for soil layers in the equivalent elastic method. The difference of lateral behavior between square and circular piles subjected to lateral loads is insignificant. The effect of aspect ratio of the rectangular pile on the lateral behavior is great for the lower stiffness ratio between pile and soil and the larger length–equivalent diameter ratio. The effect of the value of Poisson's ratio of soil on lateral stiffness coefficient is relatively small except Poisson's ratio close to 0.5. The comparison of the results calculated by the current method for a rectangular pile subjected to lateral loads in nonhomogeneous soil has shown good agreement with those obtained from the analytical methods and the finite element method. Copyright © 2015 John Wiley & Sons, Ltd.     

Displacement analytical prediction of shallow tunnel based on unified displacement function under slope boundary

For slope condition of ground surface, the asymmetrical deformation about the vertical center line and the horizontal center line of the tunnel cross section can be formed. A unified displacement function expressed by the Fourier series is presented to express the asymmetrical deformation of the tunnel cross section. Five basic deformation modes corresponding to the expansion order 2 are a complete deformation mode to reflect deformation behaviors of the tunnel cross section under slope boundary. Such this complete displacement mode is implemented into the complex variable solution for analytically predicting tunneling-induced ground deformation under slope boundary. All of these analytical solutions are verified by good agreements of the comparison between the analytical solutions and finite element method results. A parameter study is carried out to investigate the influence of deformation modes of the tunnel cross section, geometrical conditions of the tunnel and the slope angle, and “Buoyancy effect” on the displacement field. Finally, the proposed method is consistent with measured data of the Hejie tunnel in China qualitatively. The presented solution can provide a simplified indication for evaluating the ground deformation under slope condition of ground surface.     

Large‐scale poroelastic fractured reservoirs modeling using the fast multipole displacement discontinuity method

An effective approach to modeling the geomechanical behavior of the network and its permeability variation is to use a poroelastic displacement discontinuity method (DDM). However, the approach becomes rather computationally intensive for an extensive system of cracks, particularly when considering coupled diffusion/deformation processes. This is because of additional unknowns and the need for time‐marching schemes for the numerical integration. The Fast Multipole Method (FMM) is a technique that can accelerate the solution of large fracture problems with linear complexity with the number of unknowns both in memory and CPU time. Previous works combining DDM and FMM for large‐scale problems have accounted only for elastic rocks, neglecting the fluid leak‐off from the fractures into the matrix and its influence on pore pressure and stress field. In this work we develop an efficient geomechanical model for large‐scale natural fracture networks in poroelastic reservoirs with fracture flow in response to injection and production operations. Accuracy and computational performance of the proposed method with those of conventional poroelastic DDM are compared through several case studies involving up to several tens of thousands of boundary elements. The results show the effectiveness of the FMM approach to successfully evaluate field‐scale problems for the design of exploitation strategies in unconventional geothermal and petroleum reservoirs. An example considering faults reveals the impact of reservoir compartmentalization because of sealing faults for both geomechanical and flow variables under elastic and poroelastic rocks. Copyright © 2015 John Wiley & Sons, Ltd.     

Variability in the vertical hyporheic water exchange affected by hydraulic conductivity and river morphology at a natural confluent meander bend

River confluences and their associated tributaries are key morphodynamic nodes that play important roles in controlling hydraulic geometry and hyporheic water exchange in fluvial networks. However, the existing knowledge regarding hyporheic water exchange associated with river confluence morphology is relatively scarce. On January 14 and 15, 2016, the general hydraulic and morphological characteristics of the confluent meander bend (CMB) between the Juehe River and the Haohe River in the southern region of Xi'an City, Shaanxi Province, China, were investigated. The patterns and magnitudes of vertical hyporheic water exchange (VHWE) were estimated based on a one‐dimensional heat steady‐state model, whereas the sediment vertical hydraulic conductivity (K_v) was calculated via in situ permeameter tests. The results demonstrated that 6 hydrodynamic zones and their extensions were observed at the CMB during the test period. These zones were likely controlled by the obtuse junction angle and low momentum flux ratio, influencing the sediment grain size distribution of the CMB. The VHWE patterns at the test site during the test period mostly showed upwelling flow dominated by regional groundwater discharging into the river. The occurrence of longitudinal downwelling and upwelling patterns along the meander bend at the CMB was likely subjected to the comprehensive influences of the local sinuosity of the meander bend and regional groundwater discharge and finally formed regional and local flow paths. Additionally, in dominated upwelling areas, the change in VHWE magnitudes was nearly consistent with that in K_v values, and higher values of both variables generally occurred in erosional zones near the thalweg paths of the CMB, which were mostly made up of sand and gravel. This was potentially caused by the erosional and depositional processes subjected to confluence morphology. Furthermore, lower K_v values observed in downwelling areas at the CMB were attributed to sediment clogging caused by local downwelling flow. The confluence morphology and sediment K_v are thus likely the driving factors that cause local variations in the VHWE of fluvial systems.     

Soil‐pile interaction in the pile vertical vibration considering true three‐dimensional wave effect of soil

The dynamic response of an end bearing pile embedded in a linear visco‐elastic soil layer with hysteretic type damping is theoretically investigated when the pile is subjected to a time‐harmonic vertical loading at the pile top. The soil is modeled as a three‐dimensional axisymmetric continuum in which both its radial and vertical displacements are taken into account. The pile is assumed to be vertical, elastic and of uniform circular cross section. By using two potential functions to decompose the displacements of the soil layer and utilizing the separation of variables technique, the dynamic equilibrium equation is uncoupled and solved. At the interface of soil‐pile system, the boundary conditions of displacement continuity and force equilibrium are invoked to derive a closed‐form solution of the vertical dynamic response of the pile in frequency domain. The corresponding inverted solutions in time domain for the velocity response of a pile subjected to a semi‐sine excitation force applied at the pile top are obtained by means of inverse Fourier transform and the convolution theorem. A comparison with two other simplified solutions has been performed to verify the more rigorous solutions presented in this paper. Using the developed solutions, a parametric study has also been conducted to investigate the influence of the major parameters of the soil‐pile system on the vertical vibration characteristics of the pile. Copyright © 2013 John Wiley & Sons, Ltd.     

测斜技术原理与作业要点探讨

深层水平位移监测(即测斜)能直接反映土体或支护结构的变形特征,是高风险建筑基坑工程安全的重要保证。本文对测斜技术原理进行了阐述,并根据工程实践经验对测斜监测的作业要点进行了探讨与总结。     

地面三维激光扫描仪测量误差检定

在利用三维激光扫描仪进行测量工作前,我们首先应了解其实际测量精度是否符合标称精度,而可靠的评价方式对得到精确的数据结果至关重要。本文利用北京卓立汉光TSA50-C型电动位移台作为评价标准,通过其精确的位移功能,准确地评价了RIGEL VZ-400三维激光扫描仪在测量单点位移时的误差,从而得到了其最佳工作距离。