Aerodynamic Characteristics of the Crest with Membrane Attachment on Cretaceous Pterodactyloid Nyctosaurus

The Nyctosaurus specimen KJ1 was reconstructed under the hypothesis that there is a membrane attached to the crest; the so-called headsail crest. The aerodynamic forces and moment acting on the headsail crest were analyzed. It was shown that KJ1 might adjust the angle of the headsail crest relative to the air current as one way to generate thrust (one of the aerodynamic forces, used to overcome body drag in forward flight) and that the magnitude of the thrust and moment could vary with the gesture angle and the relative location between the aerodynamic center of the headsail crest and body’s center of gravity. Three scenarios were tested for comparison: the crest with membrane attachment, the crest without membrane attachment and the absence of a cranial crest. It was shown that the aerodynamic characteristics (increasing, maintaining and decreasing thrusts and moment) would have almost disappear in flight for the crest without membrane attachment and was non-existent without the cranial crest. It is suggested from aerodynamics evidence alone that Nyctosaurus specimen KJ1 had a membrane attached to the crest and used this reconstructed form for auxiliary flight control.     

2003年9月27日中、俄、蒙边界Ms7.9地震震源机制及破裂过程研究

从IRIS全球数字地震台网长周期记录中, 选取震中距位于30deg;~90deg;的垂直向远震P波资料, 反演了2003年9月27日中、 俄、 蒙边界MS7.9地震及10月1日MS7.3强余震的地震矩张量解, 研究了MS7.9地震的时空破裂过程. 参考余震的空间分布及周围断层走向, 确定MS7.9地震发震断层走向127deg;、倾角为79deg;、滑动角为171deg;. MS7.9地震震源破裂过程反演结果表明,整个破裂过程持续了37 s,释放标量地震矩0.97times;1020 Nmiddot;m. 破裂主要发生在长110 km, 宽30 km的中地壳以上,最大位错3.6 m. 起始破裂处不是滑动量最大的地方. 断层面上显示出两个显著的、滑动量超过2.0 m的破裂区. 破裂传播至MS7.3震源区附近时, 滑动量迅速减小,显示出破裂传播过程的受阻停止, 反映了障碍体引起的破裂过程的不均匀性.      

Earthquakes in Switzerland and surrounding regions during 2006

This report of the Swiss Seismological Service summarizes the seismic activity in Switzerland and surrounding regions during 2006. During this period, 572 earthquakes and 91 quarry blasts were detected and located in the region under consideration. Of these earthquakes, two occurred in conjunction with the construction of the new Gotthard railway tunnel and 165 were induced artificially by the stimulation of a proposed geothermal reservoir beneath the city of Basel. With 20 events with M _L ≥ 2.5, five of which were artificially induced, the seismic activity in the year 2006 was far below the average over the previous 31 years. Nevertheless, six events were felt by the public, most prominently the strongest of the induced Basel events (M _L 3.4), which caused some non-structural building damage. Noteworthy are also the two earthquakes near Cortaillod (M _L 3.2), on the shore of Lake Neuchatel, and in Val Mora (M _L 3.5), between the Engadin and Val Müstair, as well as the 42 aftershocks of the M _L 4.9 Vallorcine earthquake, between Martigny and Chamonix, of September 2005. Editorial handling: Stefan Bucher     

Some aspects of head‐variance evaluation

We compare two methods of evaluating head covariance for two‐dimensional steady‐state flow in mildly heterogeneous bounded rectangular aquifers. The quasi‐analytical approach, widely used in stochastic subsurface hydrology, is based on the Green's function representation, and involves numerical four‐fold integration. We compare this approach with a numerical solution of the two‐dimensional boundary‐value problem for head covariance. We show that the finite differences integration of this problem is computationally less expensive than numerical four‐fold integration of slowly‐convergent infinite series. This revised version was published online in July 2006 with corrections to the Cover Date.     

Effect of Multipoint Heterogeneity on Nonlinear Transformations for Geological Modeling： Porosity-Permeability Relations Revisited

An analysis of statistical expected values for transformations is performed in this study to quantify the effect of heterogeneity on spatial geological modeling and evaluations. Algebraic transformations are frequently applied to data from logging to allow for the modeling of geological properties. Transformations may be powers, products, and exponential operations which are commonly used in well-known relations (e.g., porosity-permeability transforms). The results of this study show that correct computations must account for residual transformation terms which arise due to lack of independence among heterogeneous geological properties. In the case of an exponential porosity-permeability transform, the values may be positive. This proves that a simple exponential model back-transformed from linear regression underestimates permeability. In the case of transformations involving two or more properties, residual terms may represent the contribution of heterogeneous components which occur when properties vary together, regardless of a pair-wise linear independence. A consequence of power- and product-transform models is that regression equationswithin those transformations need corrections via residual cumulants. A generalization of this result isthat transformations of multivariate spatial attributes require multiple-point random variable relations. This analysis provides practical solutions leading to a methodology for nonlinear modeling using correct back transformations in geology.     

用扭剪试验成果求剪切模量的计算公式

土的剪切模量是土工计算重要参数之一，通常是用弹性模量与们松比间接求得。本文结合扭转翼板仪的工作原理及其边界条件，推出用扭转力矩M和扭转剪切角θ直接求取剪切模量的计算公式。     

Predicting bending failure of CDM columns under embankment loading

The mechanism of bending failure and the magnitude of the bending moment in a column formed by cement deep mixing (CDM) under an embankment load were investigated by a series of three-dimensional (3D) finite element analyses. Based on the numerical results, a design method to consider the bending failure of the CDM column has been established. The usefulness of the proposed methods was verified using the results of two centrifuge model tests of the embankments on the CDM column improved soft model ground model reported in the literature, and the columns had tensile cracks or showed complete failure.     

研究底板突水的结构力学方法

介绍了研究底板突水的结构力学方法，并用极限弯矩的理论计算得出确定底板隔水层有效厚度之计算公式。