煤矿采空区场地建筑适宜性工程地质研究方法

简述了煤矿采空区场地存在的工程地质问题；提出了查明采空区场地工程地质条件的现场勘察和室内模拟研究方法。并结合采空区活化特点，对采空区场地建筑适宜性作了分析；提出了地基处理和建筑物防护措施     

跨孔条件下椭球模型的视电阻率异常特征

在跨孔条件下，利用积分方程法计算了孔区内外不同位置、不同产状的三维椭球体模型视电阻率异常。根据所得的典型数值模拟结果，借助视电阻率异常信息剖面图，对异常进行研究，总结了异常特征及其变化规律，并以此为基础分析和认识了其他模型的异常特征。     

塔里木盆地北缘库车盆地白垩系风成砂岩研究--以库车河剖面为例

库车盆地的早白垩世地层为一套干旱气候条件下的红层沉积，包括洪积扇砾岩、间歇性河流砂砾岩、风成细砂岩和粉砂岩、沙漠湖相紫红色泥岩等类型的沉积，组成一个较为典型的沙漠沉积体系。在库车河剖面，下白垩统红层中发育一些厚层至块状的“高能细砂岩和高能粉砂岩”，多为岩屑长石石英砂岩和长石岩屑石英砂岩。它们以良好的分选性和较高的结构成熟度、较细的粒度、较低的成分成熟度和大型交错层理的发育为特征，显示出较为明显的风成沉积特点。     

A comparative study on the illite crystallinity and the clay mineral reflectance spectral index for subdividing the very low-grade metamorphic belt along the Lizhou-Hekou geological section in the Youjiang sedimentary basin, Guangxi, China

To examine the application potential of hyperspectral remote sensing techniques in classifying very low-grade metamorphic belts, the composition of clay minerals and the cyrstallinity of illite from mudstones were measured using XRD and VIS-SWIR (400-2500 nm) reflectance spectroscopy. Based on the illite cyrstallinity, Kubler Index (KI), the Early Triassic LuoLou Group and the Middle Triassic lower Baifeng Formation were classified as the lower Epizone with KI△2θ° ranging from 0.22 to 0.25, the upper Baifeng Formation as upper anchizone with KI△2θ°ranging from 0.26 to 0.33, and the Hekou Formation as lower anchizone with KI△2θ° ranging from 0.38 to 0.40. According to a KI△2θ° value of 0.43, it is possible that there may exist a local diagenetic zone in the upper strata. The illite cyrstallinity Kubler index and the metamorphic grade increase from the bottom to the top of the stratigraphic sequence. The metamorphic grade boundaries nearly match the stratigraphic boundaries, indicating a burial metamorphism nature for the stratigraphic sequence. From the bottom to the top of the sequence, the spectral absorption band center of clay minerals from fresh rocks is around 2200 nm. The absorption band centers change towards shorter wavelengths: the Luolou Group being at 2220 nm, the Baifeng Formation at 2217-2213 nm, the lower member of the Hekou Formation at 2214-2206 nm, and the upper member of the Hekou Formation at 2205-2197 nm. The spectral absorption band center of illite shows the same change pattern. These results indicate that very low-grade metamorphic belts can be subdivided using spectral indices of clay minerals, which are measured by using field portable spectroradiometers. However, it may not work well with satellite and airborne sensors.     

Dynamic response of a pile considering the interaction of pile variable cross section with the surrounding layered soil

Assuming that the pile variable cross section interacts with the surrounding soil in the same way as the pile toe does with the bearing stratus, the interaction of pile variable cross section with the surrounding soil is represented by a Voigt model, which consists of a spring and a damper connected in parallel, and the spring constant and damper coefficient are derived. Thus, a more rigid pile–soil interaction model is proposed. The surrounding soil layers are modeled as axisymmetric continuum in which its vertical displacements are taken into account and the pile is assumed to be a Rayleigh–Love rod with material damping. Allowing for soil properties and pile defects, the pile–soil system is divided into several layers. By means of Laplace transform, the governing equations of soil layers are solved in frequency domain, and a new relationship linking the impedance functions at the variable‐section interface between the adjacent pile segments is derived using a Heaviside step function, which is called amended impedance function transfer method. On this basis, the impedance function at pile top is derived by amended impedance function transfer method proposed in this paper. Then, the velocity response at pile top can be obtained by means of inverse Fourier transform and convolution theorem. The effects of pile–soil system parameters are studied, and some conclusions are proposed. Then, an engineering example is given to confirm the rationality of the solution proposed in this paper. Copyright © 2017 John Wiley & Sons, Ltd.     

Measurement of stream cross section using ground penetration radar with Hilbert–Huang transform

This study presents a new method to measure stream cross section without having contact with water. Compared with conventional measurement methods which apply instruments such as sounding weight, ground penetration radar (GPR), used in this study, is a non‐contact measurement method. This non‐contact measurement method can reduce the risk to hydrologists when they are conducting measurements, particularly in high flow period. However, the original signals obtained by using GPR are very complex, different from studies in the past where the measured data were mostly interpreted by experts with special skill or knowledge of GPR so that the results obtained were less objective. This study employs Hilbert–Huang transform (HHT) to process GPR signals which are difficult to interpret by hydrologists. HHT is a newly developed signal processing method that can not only process the nonlinear and non‐stationary complex signals, but also maintain the physical significance of the signal itself. Using GPR with HHT, this study establishes a non‐contact stream cross‐section measurement method with the ability to measure stream cross‐sectional areas precisely and quickly. Also, in comparison with the conventional method, no significant difference in results is found to exist between the two methods, but the new method can considerably reduce risk, measurement time, and manpower. It is proven that the non‐contact method combining GPR with HHT is applicable to quickly and accurately measure stream cross section. Copyright © 2013 John Wiley & Sons, Ltd.     

Geochemical and isotopic characterization of trace fossil infillings: New insights on tracemaker activity after the K/Pg impact event

Geochemical and isotopic analyses of the Cretaceous–Paleogene (K/Pg) boundary deposits were conducted at the Caravaca section (External Subbetic, southeast of Spain) in order to evaluate the recovery of the macrobenthic tracemaker community and the bioturbational disturbance. Samples from the infilling material of several lower Danian dark-colored trace fossils (Chondrites, Planolites, Thalassinoides and Zoophycos) located in the uppermost 8-cm of the light upper Maastrichtian strata, as well as samples from the host sedimentary rock of these trace fossils, were analyzed and compared with data from the lower Danian deposits. The values of element ratios indicative of extraterrestrial contamination (Cr/Al, Co/Al and Ni/Al) are higher in the infilling trace fossil material than in the upper Maastrichtian and lower Danian deposits, which suggests a contribution of the ejecta layer. Regarding the isotope composition, the δ¹³C values are lower in the infilling material than in the Maastrichtian host sedimentary rocks surrounding the traces, while the δ¹⁸O are higher in the infilling material. The geochemical and isotopic compositions of the infilling material evidence the unconsolidated character of the sediment, including the red boundary layer. Softground conditions confirm a relatively rapid recovery by the macrobenthic tracemaker community, starting a few millimeters above the K/Pg boundary layer. The mixture of the infilling material of the trace fossils moreover reveals a significant macrobenthic tracemaker activity affecting K–Pg boundary transition sediments that may have significantly altered original signatures.     

断面成果数据输出软件的开发及实现

断面测量的成果一般采用CASS软件绘制成图,但无法输出不同格式的数据文件。以武夷新区崇阳溪保护性开发河道断面测量数据成果为例,对断面数据进行分析,进行技术方法研究,在AutoCAD平台上综合运用Visual LISP和Visual BASIC进行软件开发,编程解决断面成果不同数据格式的输出问题。软件简单实用,并具有批处理功能,具有较好的推广使用价值。     

激电测量在苏吉泉东金矿勘查中的应用

对苏吉泉东金矿进行激电测量,获得激电异常数据(电阻率ρ_s和视极化率η_s)。把不同测线上性质相同的电阻率ρ_s和视极化率η_s的反交点按对应关系联接起来,分别作为相应的破碎带和极化体位置,同时结合地质资料多次反馈,逐步逼近真实地质体。圈定了PSD1,PSD2两个破碎带和Jht1,Jht2,Jht3三个极化体,通过ρ_s和η_s的一维反演及二维反演,拟合出破碎带和极化体的形态特征及相对深度,为矿产勘探提供了较为明确的地球物理依据。     

北京平原区地质剖面的初步建立——太古宙结晶基底和元古宙地层

北京平原目前尚未建立系统的地质剖面。1867年庞培莱将北京西山分为3大系,1871年李希霍芬提出震旦系、划分12层。1922年葛利普将震旦系限定在前寒武系,1923年田奇镌将南口剖面划分为7个岩组,1934年高振西将震旦系3分(南口群、蓟县群、青白口群)。1976年乔秀夫3分青白口群(下马岭组、龙山组和景儿峪组),1980年汪长庆等将十三陵剖面分为4系12组,1991版《北京市区域地质志》将十三陵剖面分为3系12组。本文初步建立平原区地层表,详细描述太古宙结晶基底和元古宙地层剖面,在京南大兴区的榆垡(兴热-1井)和安定(兴热-2井)发现太古宙片麻岩,在京热-70井、京热-59井、京热-71井和京热-75井编录蓟县纪地层,利用亦庄小学钻孔厘定待建系下马岭组、青白口纪龙山组和景儿峪组。