Bearing capacity of unsaturated expansive soils

It is difficult to determine the bearing capacity of a foundation in unsaturated expansive soil, although this is most important. The bearing capacity of unsaturated expansive soil is related to the drying and wetting environment. Swelling pressure occurs when the soil volume change is constrained as an expansive soil is inundated. The expansive lateral pressure, induced by the swelling pressure is similar to the passive earth pressure. By considering the effect of the expansive lateral pressure in Terzaghi's bearing capacity formula, the bearing capacity of unsaturated expansive soil is derived. Because it is very difficult to measure suction in situ, the bearing capacity is expressed using the expansive lateral pressure offers a feasible approach to calculate the bearing capacity of a foundation in unsaturated expansive soil, when suction is not measured. Plate load tests to measure the bearing capacity in situ were performed for the foundation in natural soil and saturated soil immersed by water. The verification of the bearing capacity formulae presented in this paper is conducted by comparing the predicted results with the results of the plate load tests on unsaturated expansive soils in Handan and Bingxia, China.     

Pressure State in Deep Crust and Formation Depth of UHP Metamorphic Rocks

INTRODUCTIONSincethediscoveryofeclogiteswithcoesiteanddia mondinclusionsrelatedtothecontinent continentcollision orogenyenvironment,theultrahigh pressuremetamorphism(UHPM )intheDabie Suluhasarousedgreatinterestinmanygeologists (Liouetal .,1994 ;Xuetal.,1992 ) .Experimentalstudieshaveprovedthatsuchmineralsasdia mond ,coesiteandomphaciteoccurredat 2 - 5GPa (andatthecorrespondingtemperatures) (Stevenetal.,1982 ;MirwaldandMasonne ,1980 ) .However,itdoesnotmeanthatthemetamorphicrockscanbe…     

复合注浆法在基础加固中的应用

复合注浆法是将静压注浆法和高压旋喷注浆法进行时序上的结合，分别发挥两种注浆加固方法各自的优点，又可克服各自的技术和工艺缺陷的一种基础加固新方法，它可以较好地对既有建筑物地基和新建建筑基础出现质量问题进行加固处理。简述了复合注浆法的加固作用机理、设计及计算模型，在此基础上通过工程实例介绍其施工技术并分析其加固效果和经济性。     

Dynamic theory of rigid-plasticity

This paper deals with an analysis method for the response and motion of soil-like rigid-plastic bodies under seismic loading conditions. A continuity condition to determine the acceleration distribution within the rigid-plastic body when the failure occurs during seismic motions is proposed. Combining this continuity condition of acceleration and the ‘Generalized Limit Equilibrium Method (GLEM)’, the responses of the earth structure during seismic motions as well as the permanent displacements can be obtained, where GLEM is one of the limit equilibrium methods proposed by the authors for static problems and providing the approximate solution for Kötter's equation. The theoretical formulation of the method, the illustrative examples, and some comparisons between the analytical and experimental results are demonstrated.     

Experimental and theoretical study of stability of dense hydrous magnesium silicates in the deep upper mantle

Fluid-undersaturated experiments were conducted to determine the phase relations in the simplified peridotite system MgO-SiO₂-H₂O (MSH) at 11.0-14.5 GPa and 800-1400 °C. Stability relations of dense hydrous magnesium silicates (DHMSs) under fluid-undersaturated conditions were experimentally examined. From the fluid-absent experimental results, we retrieved thermodynamic data for clinohumite, phase A, phase E, and hydrous wadsleyite, consistent with the published data set for dry mantle minerals. With this new data set, we have calculated phase equilibria in the MSH system including dehydration reactions. The dehydration reactions calculated with lower water activities of 0.68-0.60 match the fluid-present experiments of this study above 11.0 GPa and 1000 °C, indicating that considerable amounts of silicate component were dissolved into the fluid phase. The calculated phase equilibria illustrate the stability of the post-antigorite phase A-bearing assemblages. In the cold subducting slab peridotite, phase A + enstatite assemblage survives into the transition zone, whereas phase A + forsterite + enstatite assemblage forms hydrous wadsleyite at a much shallower depth of about 360-km. The slab is subducted with no dehydration reactions occurring when entering the transition zone. The phase equilibria also show the high temperature stability of phase E. Phase E is stable up to 1200 °C at 13.5 GPa, a plausible condition in the mantle of relatively low temperature, i.e., beneath subduction zones. Phase E is a possible water reservoir in the mantle as well as wadsleyite and ringwoodite.     

致密砂岩的形成机制及其地质意义——以塔里木盆地英南2井为例

砂质岩的孔隙和喉道被网格状粘土矿物和次生加大矿物充填成微细孔喉状结构时,形成具有较高毛细管压力的致密砂岩。它与地层水发生水锁效应,可大大降低渗透率,成为致密砂岩盖层。当含水饱和度在50%以下时,束缚水饱和度比较低,致密砂岩储层可以产气;当含水饱和度在50%～90%区间时,具有较高的束缚水饱和度,相对渗透率非常低,它既不能产气也不能产水,反映为渗透率瓶颈区(具有盖层性质);当含水饱和度大于90%以上时,致密砂岩储层仅微量产水。塔里木盆地英南2井侏罗系气藏盖层由致密砂岩构成,不含水时的气体渗透率在(0.027～0.081)×10-3μm2,不能构成封堵;当含水饱和度达到60%以上时,相对渗透率几乎为零,构成有效盖层。     

Primary Ore Mineral Assemblage and Fluid Inclusion Study of the Batu Hijau Porphyry Cu-Au Deposit, Sumbawa, Indonesia

Abstract. The Batu Hijau porphyry Cu‐Au deposit, Sumbawa Island, Indonesia, is associated with a tonalitic intrusive complex. The temperature‐pressure condition of mineralization at the Batu Hijau deposit is discussed on the basis of fluid inclusion microthermometry. Then, the initial Cu‐Fe sulfide mineral assemblage is discussed. Bornite and chalcopyrite are major copper ore minerals associated with quartz veinlets. The quartz veinlets have been classified into ‘A’ veinlets associated with bornite, digenite, chalcocite and chalcopyrite, ‘B’ veinlets having chalcopyrite bornite along vuggy center‐line, rare ‘C’ chalcopyrite‐quartz veinlets, and late ‘D’ veinlets consisting of massive pyrite and quartz (Clode et al., 1999). Copper and gold mineralization is associated with abundant ‘A’ quartz veinlets. Abundant fluid inclusions are found in veinlet quartz consisting mainly of gas‐rich inclusions and polyphase inclusions throughout the veinlet types. The hydrothermal activity occurred in temperature‐pressure conditions of aqueous fluid immiscibility into hypersaline brine and dilute vapor. The halite dissolution (Tm[halite]) and liquid‐vapor homogenization (Th) temperatures of the polyphase inclusions in veinlet quartz range from 270 to 472d?C and from 280 to 454d?C, respectively. The estimated salinity ranges from 36 to 47 wt% (NaCl equiv.). The apparent pressures lower than 300 bars are estimated to have been along the liquid‐vapor‐halite curve for the fluid inclusions having the Th lower than the Tm that trapped the brine saturated with halite, or at slightly higher pressure relative to liquid‐vapor‐halite curve for the fluid inclusions having the Th higher than the Tm that trapped the brine unsaturated with halite. The actual temperature and pressure during the hydrothermal activity at the Batu Hijau deposit are estimated to have been around 300d?C and 50 bars. At such temperature‐pressure conditions, the principal and initial Cu‐Fe sulfide mineral assemblages are thought to be chalcopyrite + bornite solid solution (bnss) for the chalcopyrite‐bearing assemblage, and chalcocite‐digenite solid solution and bnss for the chalcopyrite‐free assemblage.     

Geologic and geotechnical effects of an impact caused by an airplane crash

A Turkish Airlines (THY) Boeing 737-400 plane crashed into alluvial soils creating an approximately 13 m deep and 30 m wide crater near the village of Adatepe, Ceyhan in southern Turkey. Effects of the impact on the soils in and around the crater were investigated from both the geological and soil mechanics point of view.

The results show that the impact caused severe deformations in the soils in and around the crater. The soils deformed similar to metamorphic rocks seen at many terrestrial hypervelocity impact craters around the world and became overconsolidated up to a distance of about 10 m from the crater wall as a result of the impact.

Also, the crash was recorded as a 2.7 magnitude earthquake by a nearby microtremor seismograph which provided both the location (epicenter) and time of the crash which was not known immediately after the crash.     

钻孔灌注桩后压浆作用机理与应用

通过对桩侧和桩底后压浆,可大幅度提高钻孔灌注桩单桩承载力.应用桩-土理论分析了后压浆中浆液对土体及桩体的作用,并从分析影响桩基承载力的因素出发,研究了后压浆的作用机理.在渗透率小的地层中后压浆以压密注浆为主,在渗透率大的地层中后压浆以渗透注浆为主.为避免过分压裂土层,在压浆过程中应控制灌浆压力.压浆量是影响后压浆质量和提高单桩承载力的关键因素之一.