Techniques to measure grain-size distributions of loamy sediments: a comparative study of ten instruments for wet analysis

Ten instruments for measuring the grain‐size distribution of loamy sediments in water were tested in a comparative study. Instruments tested were: the Malvern Mastersizer S, the Coulter LS 200, the Fritsch Analysette 22 (version C), the Horiba Partica LA‐950, the Sedigraph 5100, the Atterberg cylinder, the Coulter Multisizer 3, the CIS‐100, the EyeTech and the image analysis software Histolab. The first four instruments use laser diffraction. The Sedigraph and Atterberg cylinder are based on sedimentation. The Coulter Multisizer 3 uses impedance measurements and the last three instruments use optical techniques. Grain‐size analyses were carried out on four sediments with median grain diameters of approximately 35, 30, 12 and 9 μm, respectively, and with no particles >90 μm. The laser diffraction instruments produced the best results for the various criteria considered in this study, followed by the Coulter Multisizer 3 (electrical sensing zone technique), the sedimentation techniques and the optical methods. However, the study also showed that there is no such thing as an ‘ideal’ method because techniques may score differently according to the criterion tested. An appropriate evaluation thus requires that various criteria be considered. Issues to be taken into account are: type of sediment, quantity of sediment available, speed of measurement, complexity of the measurement protocol, processing of the data, reproducibility of the results and the specific aims of the study undertaken.     

Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Room-temperature equation of state of Li<Subscript>2</Subscript>VOSiO<Subscript>4</Subscript> up to 8.5 GPa

High-pressure single-crystal X-ray diffraction measurements of lattice parameters of the compound Li₂VOSiO₄, which crystallises with a natisite-type structure, has been carried out to a pressure of 8.54(5) GPa at room temperature. Unit-cell volume data were fitted with a second-order Birch-Murnaghan EoS (BM-EoS), simultaneously refining V ₀ and K ₀ using the data weighted by the uncertainties in V. The bulk modulus is K ₀ = 99(1) GPa, with K′ fixed to 4. Refinements of third order equations-of-state yielded values of K′ that did not differ significantly from 4. The compressibility of the unit-cell is strongly anisotropic with the c axis (K ₀(c) = 49.7 ± 0.5 GPa) approximately four times more compressible than the a axis (K ₀(a) = 195 ± 3 GPa).     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

辽东湾凝析气田超压成因及侧向传递机制初探

位于辽东湾西部低凸起北端的JZ20-2超压凝析气田,离供烃中心较远,压力系数却达到1.56~1.7,这在我国东部裂谷盆地比较少见。经过综合分析,作者认为JZ20-2凝析气田异常高压的形成与其所处的特殊地质背景紧密相关,辽中凹陷沙河街组三段超压凝析油气沿不整合面、砂体输导通道向辽东湾西部低凸起的运移、充注和能量的侧向传递是JZ20-2凝析气田异常高压形成的根本原因,而上覆东营组二段下亚段-东营组三段巨厚的强超压泥岩封盖和辽西3号边界断层侧向遮挡共同构成的优越封闭环境是超压保存的必要条件。本文分析了该气田超压特征及其远距离超压侧向传递的成因机制,不仅有助于揭示辽东湾西部低凸起超压流体运移聚集的规律和成藏作用,而且可能提供了一个超压远距离侧向传递的典型实例。     

江苏潮滩沉积物激光粒度仪与移液管-筛析分析结果的对比

激光粒度仪的广泛应用带来了与历史数据的对比问题,因此需要建立激光粒度仪与早期分析结果之间的关系。根据江苏海岸潮滩沉积物样品的激光粒度仪和移液管-筛析法分析,对粒度参数、粒度组分等进行了对比,对两种方法的差异进行了分析。结果表明,对于江苏潮滩沉积物粒度参数中平均粒径的激光粒度仪与移液管-筛析分析结果之间有良好的线性关系;筛分法测得的粗颗粒物质较激光法偏少,而移液管法法测得的细颗粒物质较激光法偏多;将样品分类之后再进行两种方法所获粒度参数的回归分析,相关性得以提高,说明不同粒度组成的沉积物对分析结果的对比有不同的影响。两种方法之间的换算关系不仅与研究区域有关,而且与沉积物本身的粒度组成有关。     

旋流除砂机理研究及自动旋流除砂器的开发

旋流除砂技术是利用离心力从泥浆中分离固相成分的技术,可广泛应用在地质钻探、有色、冶金工业及石油天然气工业领域。研制开发的自动旋流除砂器弥补了传统除砂器固相成分分离效果不佳、排砂口易堵的缺陷,显著提高泥浆或矿浆的净化质量与除砂效率,且能自动排堵,降低了除砂工作的时间消耗和成本。     

CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

高压技术在深海沉积物兼性嗜压菌的筛选和鉴定中的应用

通过自行改进的高压培养罐及高压设备,对深海沉积物进行可培养微生物的筛选,获得6株具有较强耐受压力的细菌.16SrDNA的测序结果表明这些细菌分别属于6个不同的菌属.压力生长试验的结果表明这6株细菌在40MPa的条件下仍然具有较强的生长能力,属于兼性嗜压菌.对不同压力下生长的细菌做显微镜检,结果显示,除了一株芽孢杆菌在40MPa下的菌体形态发生了明显的变化外,其它5株细菌在压力条件下的菌体的分裂均没有受到明显的影响.     

基于GIS的柘林湾生态信息系统

柘林湾生态信息系统以ArcGIS为开发平台，采用客户端／服务器的体系结构，基于ArcObjects的组件式二次开发而成，实现了柘林湾的三维实景模拟、生态数学模型与GIS的有效集成、分析评价结果与地理空间数据相结合等功能，具有可视化、智能化、易扩展、安全实用等特点．该系统的建成．极大地提高了柘林湾生态信息的现代化管理水平，并为制定柘林湾的污染防治与生态环境保护策略提供了强有力的支持．