Solution for a plane strain rough‐walled hydraulic fracture driven by turbulent fluid through impermeable rock

The impact of turbulent flow on plane strain fluid‐driven crack propagation is an important but still poorly understood consideration in hydraulic fracture modeling. The changes that hydraulic fracturing has experienced over the past decade, especially in the area of fracturing fluids, have played a major role in the transition of the typical fluid regime from laminar to turbulent flow. Motivated by the increasing preponderance of high‐rate, water‐driven hydraulic fractures with high Reynolds number, we present a semianalytical solution for the propagation of a plane strain hydraulic fracture driven by a turbulent fluid in an impermeable formation. The formulation uses a power law relationship between the Darcy‐Weisbach friction factor and the scale of the fracture roughness, where one specific manifestation of this generalized friction factor is the classical Gauckler‐Manning‐Strickler approximation for turbulent flow in a rough‐walled channel. Conservation of mass, elasticity, and crack propagation are also solved simultaneously. We obtain a semianalytical solution using an orthogonal polynomial series. An approximate closed‐form solution is enabled by a choice of orthogonal polynomials embedding the near‐tip asymptotic behavior and thus giving very rapid convergence; a precise solution is obtained with 2 terms of the series. By comparison with numerical simulations, we show that the transition region between the laminar and turbulent regimes can be relatively small so that full solutions can often be well approximated by either a fully laminar or fully turbulent solution.     

Modelling the poroelastoplastic behaviour of soils subjected to internal erosion by suffusion

Granular soils subjected to seepage flow may suffer suffusion, ie, a selective internal erosion. Extending the classical approach of poromechanics, we deduce a new form of the Clausius-Duhem inequality accounting for dissipation due to suffusion, and we deduce restrictions on the constitutive laws of the soil. We suggest (a) a possible coupling between the seepage forces and the suffusion kinetics and (b) an extension of an existing elastoplastic model for the skeleton mechanical behaviour. Numerical integrations of the elastoplastic model are carried out under drained axisymmetric triaxial and oedometric conditions. As a result, we prove that the extended model is able to qualitatively reproduce the suffusion induced strains and the strength reduction experimentally observed. Predictions on the oedometric behaviour of suffusive soils are also provided.     

A modified numerical model for moisture-salt transport in unsaturated sandy soil under evaporation

Soil salinization, caused by salt migration and accumulation underneath the soil surface, will corrode structures. To analyze the moisture-salt migration and salt precipitation in soil under evaporation conditions, a mathematical model consisting of a series of theoretical equations is briefly presented. The filling effect of precipitated salts on tortuosity factor and evaporation rate are taken into account in relevant equations. Besides, a transition equation to link the solute transport equation before and after salt precipitation is proposed. Meanwhile, a new relative humidity equation deduced from Pitzer ions model is used to modify the vapor transport flux equation. The results show that the calculated values are in good agreement with the published experimental data, especially for the simulation of volume water content and evaporation rate of Toyoura sand, which confirm the reliability and applicability of the proposed model.     

High energy phenomena in eta carinae

We have investigated with BeppoSAX the long term behaviour of the harder X-ray component of the supposed supermassive binary system η Car along its 5.52 year cycle. We have found that in March 1998 during egress from the last December 1997 eclipse, this component was the same as outside eclipse, but for a large (×3.5) increase of NH _h , that can be attributed to the presence or formation of opaque matter in front of the source near periastron. Unexpectedly, at that time the iron 6.7 keV emission line was 40% stronger. BeppoSAX has for the first time found ahard X-ray tail extending to at least 50 keV, that cannot be adequately fitted with an additional hotter thermal component. The 2–100 keV spectrum of η Car is instead well fitted with an absorbed powerlaw spectrum with photon index 2.53, suggesting non-thermal emission as an alternative model for the core source.     

黑子磁流体静力学的一个模型

本文对Ｏｓｈｅｒｏｖｉｃｈ的黑子返回磁通量模型作了适当的修改，使用黑子中心作为边界条件，用五种观测结果，导出了理论模型所需的五个主要参量，用半经验方法求得了黑子静力学模型的磁场、压力和温度等物理量．将此模型应用于一个中等大小的圆形对称黑子，可得到一个特解，结果发现我们的模型既能满足黑子的磁性质，同时又能满足合理的热力学量分布．     

Evolutionary Processes in Low-Mass Binary Systems

We consider the evolution of certain low-mass binaries, incorporating models of (a) internal evolution, (b) tidal friction, (c) dynamo activity driven by an elementary α,Ω dynamo, (d) stellar wind driven by the activity, and (e) magnetic braking as a consequence of wind and poloidal dynamo-generated magnetic field. In some circumstances the stellar wind is found to remove mass on a nuclear timescale, as is necessary to explain some observed systems. We can hope that various uncertainties in the model may be clarified by a careful comparison of the models with such observed quantities as rotation periods. These are modified by processes (a), (b) and (e). Assuming that stellar evolution is slow, rotation rate should in some circumstances represent a balance between magnetic braking trying to slow the star down and tidal friction trying to spin it up. Preliminary attempts are promising, but indicate that some fine tuning is necessary. When there is a third body present, in an orbit which is inclined but not necessarily of short period, the eccentricity of a close binary can be strongly modified by ‘Kozai cycles’. We show that this may complicate attempts to account for spin rates of stars in close binaries.     

MATLAB在运用系统建模处理南海气象数据过程中应用

介绍了MATLAB语言特点和系统建模方法的基本理论.根据南海气象数据的实际建模处理过程,给出了建模的详细步骤及其MATLAB实现过程以及MATLABTM的主要实现程序.试验讨论和结果表明利用MATLAB语言可以方便地对南海气象数据用系统建模方法进行建模和处理,MATLAB在运用系统建模法处理南海气象数据方面具有明显的优越性.     

Simulations of multimode bolometric interferometers

We describe a procedure for the numerical modelling of astronomical interferometers, with particular relevance to far-infrared and submillimetre wavelengths. The scheme is based on identifying a set of modes that carry power from the sky to the detector. The procedure is extremely general, and can be used to model scalar or vector fields, in any state of coherence and polarization, the only limitation being that the propagation of a coherent field through the system be described by an integral transform, a constraint that is in practise always met.
We present simulations of ideal, multimode two-dimensional interferometers, and show that the modal theory reproduces the correct behaviour of both Michelson and Fizeau interferometers. We calculate simulated visibility data for a multimode bolometric Michelson interferometer, with a synthesized source, and produce a dirty map, recovering the original source with the usual artefacts associated with interferometers.     

Isotope hydrological study of mean transit time in the granitic Strengbach catchment (Vosges massif,France): application of the FlowPC model with modified input function

Measurements of ¹⁸O concentrations in precipitation, soil solution, spring and runoff are used to determine water transit time in the small granitic Strengbach catchment (0·8 km²; 883–1146 m above sea level) located in the Vosges Mountains of northeastern France. Water transit times were calculated by applying the exponential, exponential piston and dispersion models of the FlowPC program to isotopic input (rainfall) and output (spring and stream water) data sets during the period 1989–95. The input function of the model was modified compared with the former version of the model and estimated by a deterministic approach based on a simplified hydrological balance. The fit between observed and calculated output data showed marked improvements compared with results obtained using the initial version of the model. An exponential piston version of the model applied to spring water indicates a 38·5 month mean transit time, which suggests that the volume in the aquifer, expressed in water depth, is 2·4 m. A considerable thickness (>45 m) of fractured bedrock may be involved for such a volume of water to be stored in the aquifer. Copyright © 2005 John Wiley & Sons, Ltd.