Laboratory Study for Influence of Clay Content (CC) on Wave-Induced Liquefaction in Marine Sediments

In this artice, the influence of clay content on the wave-induced liquefaction in marine sediments was reported. The one-dimensional (1-D) equipment was setup with a vertical cylinder and 1.8–m–thick clayey sandy deposit and 0.2–m–thick water above the deposit. Unlike the previous experimental study for a single soil layer, this study used sand-kaolin mixtures, sand-illite mixtures, and sand-bentonite mixtures as the experimental samples. A series of experiments with 3,000 wave cycles in each test were conducted under numerous wave and soil conditions, which allowed us to examine the influence of clay content (CC) on wave-induced liquefaction in marine sediments. The experimental results showed that the clayey sandy deposit will become prone to liquefaction with the increase of CC when CC is less than a critical value, which depends on the type of clay. However, when CC is greater than the critical value, liquefaction depth will decrease as CC increases. Furthermore, when the CC value reaches a certain level, liquefaction will not occur. For example, no liquefaction occurs when CC ≥ 33% for both kaolin-sand and illite-sand mixtures and CC ≥ 16.36% for bentonite-sand mixtures.     

Calibration of cyclic constitutive models by oscillating functions

Most structures are subjected to more cyclic loads during their life time than static loads. These cyclic action could be a result of either natural or man-made activities and may lead to soil failure. In order to understand the response of the foundation and its interaction with these complex cyclic loadings, various researchers have over the years developed different constitutive models. Although a lot of research is being carried out on these relatively new models, little or no details exist in literature about the model-based identification of the cyclic constitutive parameters which to a large extent govern the quality of the model output. This could be attributed to the difficulties and complexities of the inverse modeling of such complex phenomena. A variety of optimisation strategies are available for the solution of the sum of least-squares problems as usually done in the field of model calibration. However, for the back analysis (calibration) of the soil response to oscillatory load functions, this article gives insight into the model calibration challenges and also puts forward a method for the inverse modeling of cyclic loaded foundation response such that high-quality solutions are obtained with minimum computational effort.     

Effect of loading duration on uncertainty in creep analysis of clay

Some studies suggest that creep parameters should be determined using a greater quantity of creep test data to provide more reliable prediction regarding the deformation of soft soils. This study aims to investigate the effect of loading duration on model updating. One‐dimensional consolidation data of intact Vanttila clay under different loading durations collected from the literature is used for demonstration. The Bayesian probabilistic method is used to identify all unknown parameters based on the consolidation data during the entire consolidation process, and their uncertainty can be quantified through the obtained posterior probability density functions. Additionally, the optimal models are also determined from among 9 model candidates. The analyses indicate that the optimal models can describe the creep behavior of intact soft soils under different loading durations, and the adopted method can evaluate the effect of loading duration on uncertainty in the creep analysis. The uncertainty of a specific model and its model parameters decreases as more creep data are involved in the updating process, and the updated models that use more creep data can better capture the deformation behavior of an intact sample. The proposed method can provide quantified uncertainty in the process of model updating and assist engineers to decide whether the creep test data are sufficient for the creep analysis.     

静海地震台地磁加卸载响应比与邻区地震关系研究

研究分析了静海地磁台2002～2006年观测资料的加卸载响应比异常与邻区ML 4.0以上地震之间的关系,提出了适用于静海地磁台的地震分析预报异常形态特征和阈值判据.     

台风“利奇马”对钻孔体应变的扰动分析——以浙江地区为例

利用台风“利奇马”过境浙江期间,岱山地震台、东阳地震台钻孔体应变数据,采用数据滤波和线性回归等方法,分析了这2个台站钻孔体应变对台风的响应特征。结果表明,东阳地震台受台风引起的低气压的影响,钻孔体应变与气压同步变化;而岱山地震台受低气压和降水的共同影响,钻孔体应变与气压在变化的相关性和同步性上均有差异。气压和降水导致钻孔体应变的变化量可以通过负载力学模型进行估算求解。     

Drainage conditions around monopiles in sand

Large diameter monopiles are typical foundation solutions for offshore wind turbines. In design of the monopile foundations in sand, it is necessary to understand the drainage conditions of the foundation soil under the design loading conditions as the soil performance (strength and stiffness) is highly dependent on the drainage conditions. This paper presents a numerical investigation into this issue, with a purpose to develop a simple design criterion for assessing the soil drainage conditions around a monopile in sand. It is found that for typical monopile foundations in sand, the drainage condition during a single load cycle is generally expected to be undrained. However, the current state-of-practice uses p-y springs derived for drained soil responses for monopile design. The impact of this discrepancy on monopile foundation design was evaluated and found to be insignificant due to the relatively low level of loading as compared to the capacity of the soil.     

Experimental study on wide-shallow composite bucket foundation for offshore wind turbine under cyclic loading

As an appropriate type of foundation for offshore wind turbines (OWTs), wide-shallow composite bucket foundation (WSCBF) is cost-competitive, and it has a unique and special substructure that comprises seven internal rooms arranged in a honeycomb-like structure. In this study, the cyclic behavior of WSCBF for OWTs embedded in saturated clay was investigated using a large-scale model subjected to lateral cyclic loading. The responses of foundation under constant- and various-amplitude cyclic loadings were recorded in terms of displacements, rotations, and bending moments. The variations in stiffness and damping were obtained, and a collaborative bearing mechanical model between the bucket and soil was considered, which was beneficial for improving the stiffness of the whole structure. Accumulative deformation was found to have little effect on the bearing capacity of the foundation. Dynamic analysis in frequency domain was further performed on both moment and rotation data, and the complex, frequency-dependent impedance was also studied.     

广平地震台地磁异常与地震关系的研究

利用加卸载响应比、日变幅逐日比、空间相关分析法,研究分析了广平台1982-2006年地磁垂直分量观测资料与河北省及邻近地区Ms≥5.0地震之间的关系,发现它们之间有较好的对应关系;同时给出了适用于广平地磁台的地震分析预报参数,为今后广平台依磁报震提供了依据.     

三峡库首区重点断裂围限区蓄水的加卸载效应

通过对蓄水前后三峡库首区构造应力场进行三维数值模拟发现,相对于蓄水前,蓄水至135 m水位时,官渡口断裂-马鹿池断裂-牛口断裂围限区、秭归地理中心和九湾溪断裂带,出现了4个主应力下降区和共轭的主应力增长区,形成了差应力场;175 m水位与135 m水位相比,局部差应力场呈现逆向变化,即形成了加载效应与卸载效应的交替过程。这一过程,可能是水库诱发地震的诱震(或触震)因素。     

低周反复荷载下两跨两层轻钢框架抗震性能试验研究

本文通过两跨两层轻钢框架试件的低周反复加载试验,研究了轻钢框架结构在地震作用下的滞回性能、耗能机制、耗能能力、刚度退化和破坏形态,结果显示轻钢框架具有很好的抗震性能,节点域耗能能力强。论文结论可为多层轻钢框架的抗震设计提供依据。