Erosion and deposition by debris flows at Mt Thomas,North Canterbury,New Zealand

The grass-covered slopes on the southern flank of Mt Thomas, an upfaulted block of highly sheared sandstone and argillite 40 km NW of Christchurch, New Zealand, are presently undergoing severe erosion by a combination of mass-wasting processes. Gully erosion, soil slips, and debris flows have carved out a number of steep, deeply incised ravines, from which coarse debris is transported (primarily by debris flows) to alluvial fans below. Geologic and historical evidence indicates that debris flows have been episodically active here for at least the last 20,000 years and have been the dominant process in fan building. This demonstrates that catastrophic geomorphic processes, rather than processes acting at relatively uniform rates, can be dominant in humid-temperate areas as well as in arid and semi-arid regions. In April 1978, debris flows were triggered in one of two unstable ravines in the Bullock Creek catchment by a moderate intensity, long duration rainstorm with a return period in excess of 20 years. Surges of fluid debris, moving at velocities up to 5 m/s, transported a dense slurry of gravel, sand, and mud up to 3·5 km over a vertical fall of 600 m. Deposition on the alluvial fan occurred when the flows left the confines of an entrenched fan-head channel and spread out as a 0·16 km² sheet averaging 1·2 m thick. In all, 195,000 m³ were deposited, roughly a third of that being reworked sediments from the head of the fan. Sediment yield from this one event would be equivalent to several thousand years worth of erosion at average sediment discharge rates for small South Island mountain catchments. Samples of viscous fluid debris during surges contained up to 84 per cent solids, composed of 70 per cent gravel, 20 per cent silt, and 4 per cent clay. Fluid density of the material ranged between 1·95 and 2·13 g/cm³, and it was extremely poorly sorted. Between surges the fluid was less viscous, less dense, and unable to carry gravel in suspension. Severe fan-head entrenchment of the stream channel (approximately 10 m in less than 24 hours) was accomplished by the erosive action of the surges. Tectonic uplift of the Mt Thomas block and the weak, crushed condition of the bedrock appear to be ultimately responsible for the catastropic erosion of slopes in the Bullock Creek catchment. However, forest clearing within the last few centuries appears to have greatly increased the rate of mass wasting and gully erosion on these slopes.     

Determination of predevelopment denudation rates of an agricultural watershed (Cayaguás River, Puerto Rico) using in-situ-produced Be in river-borne quartz

Accurate estimates of watershed denudation absent anthropogenic effects are required to develop strategies for mitigating accelerated physical erosion resulting from human activities, to model global geochemical cycles, and to examine interactions among climate, weathering, and uplift. We present a simple approach to estimate predevelopment denudation rates using in-situ-produced cosmogenic ¹⁰Be in fluvial sediments. Denudation processes in an agricultural watershed (Cayaguás River Basin, Puerto Rico) and a matched undisturbed watershed (Icacos River Basin) were compared using ¹⁰Be concentrations in quartz for various size fractions of bed material. The coarse fractions in both watersheds bear the imprint of long subsurface residence times. Fine material from old shallow soils contributes little, however, to the present-day sediment output of the Cayaguás. This confirms the recent and presumably anthropogenic origin of the modern high denudation rate in the Cayaguás Basin and suggests that pre-agricultural erosional conditions were comparable to those of the present-day Icacos.     

Siltation analysis in the Neyyar reservoir and forest degradation in its catchment: a study from Kerala state, India

 Impact of catchment erosion and the resultant reservoir siltation from a tropical environment is reported here to discuss the effect of a reservoir in the natural degradation of an evergreen-forested segment. While an area of 8.01 km² has been affected by direct inundation at the full reservoir level, another 2.6 km² area once under thick forest cover, had also lost its identity over the last 38 years by indirect degradation. This zone mainly falls in the confluence of tributaries, namely Neyyar and Mullayar, with the reservoir. The capacity of the reservoir was found to be reduced by 28.8 Mm³ during this period and the annual average loss is calculated as 0.75 Mm³ (0.71%), indicating the intensity of erosion from the catchment zone. In case the proposed upper dam in the reservoir comes into existence, an additional area of 2.4 km² from the virgin forest would be submerged and more area would face degradation around the inundated zone. Received: 29 July 1998 · Accepted: 16 November 1998     

Heavy metal release by peat erosion in the Peak District,southern Pennines,UK

Upper North Grain (UNG) is a heavily eroding blanket peat catchment in the Peak District, southern Pennines, UK. Concentrations of lead in the near‐surface peat layer at UNG are in excess of 1000 mg kg⁻¹. For peatland environments, these lead concentrations are some of the highest globally. High concentrations of industrially derived, atmospherically transported magnetic spherules are also stored in the near‐surface peat layer. Samples of suspended sediment taken during a storm event that occurred on 1 November 2002 at UNG, and of the potential catchment sources for suspended sediments, were analysed for lead content and the environmental magnetic properties of anhysteretic remanent magnetization (ARM) and saturation isothermal remanent magnetization (SIRM). At the beginning of the storm event, there is a peak in both suspended sediment and associated lead concentration. SIRM/ARM values for suspended sediment samples throughout the storm reveal that the initial ‘lead flush’ is associated with a specific sediment source, namely that of organic sediment eroded from the upper peat layer. Using the magnetic ‘fingerprinting’ approach to discrimination of sediment sources, this study reveals that erosion of the upper peat layer at UNG is releasing high concentrations of industrially derived lead (and, by inference, other toxic heavy metals associated with industrial particulates) into the fluvial systems of the southern Pennines. Climate‐change scenarios for the UK, involving higher summer temperatures and stormier winters, may result in an increased flux both of sediment‐associated and dissolved heavy metals from eroding peatland catchments in the southern Pennines, adversely affecting the quality of sediment and water entering reservoirs of the region. Copyright © 2005 John Wiley & Sons, Ltd.     

Enhancing RUSLE to include runoff‐driven phenomena

RUSLE2 (Revised Universal Soil Loss Equation) is the most recent in the family of Universal Soil Loss Equation (USLE)/RUSLE/RUSLE2 models proven to provide robust estimates of average annual sheet and rill erosion from a wide range of land use, soil, and climatic conditions. RUSLE2's capabilities have been expanded over earlier versions using methods of estimating time‐varying runoff and process‐based sediment transport routines so that it can estimate sediment transport/deposition/delivery on complex hillslopes. In this report we propose and evaluate a method of predicting a series of representative runoff events whose sizes, durations, and timings are estimated from information already in the RUSLE2 database. The methods were derived from analysis of 30‐year simulations using a widely accepted climate generator and runoff model and were validated against additional independent simulations not used in developing the index events, as well as against long‐term measured monthly rainfall/runoff sets. Comparison of measured and RUSLE2‐predicted monthly runoff suggested that the procedures outlined may underestimate plot‐scale runoff during periods of the year with greater than average rainfall intensity, and a modification to improve predictions was developed. In order to illustrate the potential of coupling RUSLE2 with a process‐based channel erosion model, the resulting set of representative storms was used as an input to the channel routines used in Chemicals, Runoff, and Erosion from Agricultural Management Systems (CREAMS) to calculate ephemeral gully erosion. The method was applied to a hypothetical 5‐ha field cropped to cotton in Marshall County, MS, bisected by a potential ephemeral gully having channel slopes ranging from 0·5 to 5% and with hillslopes on both sides of the channel with 5% steepness and 22·1 m length. Results showed the representative storm sequence produced reasonable results in CREAMS indicating that ephemeral gully erosion may be of the same order of magnitude as sheet and rill erosion. Copyright © 2010 John Wiley & Sons, Ltd.     

Assessment of intermediate fine sediment storage in a braided river reach (southern French Prealps)

This paper presents a field investigation on river channel storage of fine sediments in an unglaciated braided river, the Bès River, located in a mountainous region in the southern French Prealps. Braided rivers transport a very large quantity of bedload and suspended sediment load because they are generally located in the vicinity of highly erosive hillslopes. Consequently, these rivers play an important role because they supply and control the sediment load of the entire downstream fluvial network. Field measurements and aerial photograph analyses were considered together to evaluate the variability of fine sediment quantity stored in a 2·5‐km‐long river reach. This study found very large quantities of fine sediment stored in this reach: 1100 t per unit depth (1 dm). Given that this reach accounts for 17% of the braided channel surface area of the river basin, the quantities of fine sediment stored in the river network were found to be approximately 80% of the mean annual suspended sediment yields (SSYs) (66 200 t year^?1), comparable to the SSYs at the flood event scale: from 1000 t to 12 000 t depending on the flood event magnitude. These results could explain the clockwise hysteretic relationships between suspended sediment concentrations and discharges for 80% of floods. This pattern is associated with the rapid availability of the fine sediments stored in the river channel. This study shows the need to focus on not only the mechanisms of fine sediment production from hillslope erosion but also the spatiotemporal dynamics of fine sediment transfer in braided rivers. Copyright © 2010 John Wiley & Sons, Ltd.     

Spatial and temporal variations in aboveground and belowground biomass of Spartina maritima (small cordgrass) in created and natural marshes

Spartina species are commonly used for salt marsh manipulative projects, where aboveground and belowground biomasses are functional traits that play important roles, showing high spatial and temporal variations. This work analyses variations in AGB and BGB of Spartina maritima and abiotic environmental parameters along a chronosequence of six marshes created from 1997 to 2003 with disparate sediment dynamics, and adjacent natural marshes and unvegetated tidal flats. S. maritima behaved as an autogenic engineer, as its colonization of bare sediments yielded abiotic environmental changes: specifically, bed level rise accompanied by higher oxygenation and salinity. These modifications of the environment were site-specific, depending mainly on sedimentary dynamics. At the same time, abiotic environmental changes determined biomass production rates of S. maritima that were higher in more-accreting marshes; however, AGB was kept constant from early in its development (2 years). The increase in BGB with elevation seemed to be related to the inhibition of subsurface tissue development in anoxic sediments. Biomass accumulation and production varied markedly, depending on the spatial scale, indicating the relevance of the plot size chosen for the analysis of biomass of cordgrasses. Our results show that managers of salt marshes should consider sedimentary dynamics carefully when setting realistic expectations for success criteria of created and restored wetlands.     

Streambank dewatering for increased stability

Streambank erosion is often the dominant source of sediment leaving modified watersheds. Mass failure of high, steep banks is one of the most serious forms of streambank erosion. The risk of a given bank experiencing mass failure is a function of bank height, angle, and soil strength, which is governed by soil moisture. Two methods for bank dewatering were tested in adjacent sections of streambank bordering a deeply incised channel in northern Mississippi: a low‐cost pump system and subsurface horizontal drains. Pore water pressures (both positive and negative pressures, or matric suction) were continuously monitored for 2 years at the pumped site, at an adjacent untreated control section, and for 1 year at the site stabilized with horizontal drains. Resulting data were used to calculate a time series of the factor of safety using a computer model. Over the course of two wet seasons, average bank retreats for the control and pumped plots were 0·43 and 0·21 m, respectively. More limited monitoring revealed that the site with passive drains retreated about 0·23 m. At the pumped site pore water pressure was 3–4 kPa lower than at the control site during the most critical periods. Accordingly, computed factors of safety were above the failure threshold at the pumped site, but fell below unity at the control site on 11 occasions over the period of observation. Similarly, the drained site displayed generally lower pore water pressure and higher safety factors except for two events when drains were evidently overwhelmed with the volume of local surface and subsurface flows. These results suggest, but do not prove, that bank dewatering promoted lower rates of bank retreat and higher levels of stability since the three sites had slight differences in soils, geometry and boundary conditions. Initial cost of the dewatering treatments were significantly less than orthodox bank stabilization measures, but operation and maintenance requirements may be greater. Published in 2009 by John Wiley & Sons, Ltd.     

First‐year post‐fire erosion rates in Bitterroot National Forest,Montana

Accelerated runoff and erosion commonly occur following forest fires due to combustion of protective forest floor material, which results in bare soil being exposed to overland flow and raindrop impact, as well as water repellent soil conditions. After the 2000 Valley Complex Fires in the Bitterroot National Forest of west‐central Montana, four sets of six hillslope plots were established to measure first‐year post‐wildfire erosion rates on steep slopes (greater than 50%) that had burned with high severity. Silt fences were installed at the base of each plot to trap eroded sediment from a contributing area of 100 m². Rain gauges were installed to correlate rain event characteristics to the event sediment yield. After each sediment‐producing rain event, the collected sediment was removed from the silt fence and weighed on site, and a sub‐sample taken to determine dry weight, particle size distribution, organic matter content, and nutrient content of the eroded material. Rainfall intensity was the only significant factor in determining post‐fire erosion rates from individual storm events. Short duration, high intensity thunderstorms with a maximum 10‐min rainfall intensity of 75 mm h^?1 caused the highest erosion rates (greater than 20 t ha^?1). Long duration, low intensity rains produced little erosion (less than 0·01 t ha^?1). Total C and N in the collected sediment varied directly with the organic matter; because the collected sediment was mostly mineral soil, the C and N content was small. Minimal amounts of Mg, Ca, and K were detected in the eroded sediments. The mean annual erosion rate predicted by Disturbed WEPP (Water Erosion Prediction Project) was 15% less than the mean annual erosion rate measured, which is within the accuracy range of the model. Published in 2007 by John Wiley & Sons, Ltd.