坡麓相斜坡软土特性及其地质灾害防治研究

结合工程实例．提出“坡麓相斜坡软土”的概念,论述西南煤系地层地区斜坡软土的形成机理、分布规律、物理力学特征及其工程特性,研究斜坡软土对工程的危害及其地质灾害防治对策,最后列举三个典型斜坡软土工程整治实例,对指导工程实践具有重要意义。     

End Bearing Capacity of Drilled Shafts in Sand: A Numerical Approach

In this paper, a modeling procedure is carried out to numerically analyze the end bearing capacity of drilled shafts in sand. The Mohr–Coulomb elastic plastic constitutive law with stress dependent elastic parameters is used for all numerical analyses performed in this study. The numerical results are compared with the available experimental equations. It is seen that numerical results are in good agreement with experimental equations. The variation of the end bearing capacity of drilled shafts versus embedment depth is also studied. Numerical results show that with increase in pile embedment depth, the end bearing capacity increases. However, the rate of increase becomes smaller as the pile embedment depth increases. Also, numerical analyses show that, for equal settlement, the end bearing decreases with increase in the pile diameter. Finally, a sensitivity analysis is performed to obtain the separate effect of each sand parameter on the end bearing capacity of drilled shafts, and the parameters that are most influential are identified.     

地台活化与层控铅锌矿床

本文主要介绍大多数层控铅锌矿床是产在半封闭沉积盆地碳酸盐岩中,属同生沉积成因。在地台活化时期,由于扬子地台西南缘从稳定地块转向活化。在构造-岩浆作用时期,火山喷气导致了金属聚积。因此,所有的矿床均表现出受超壳大断裂控制,这些矿床可认为是同生沉积-火山喷气成因。     

Velocity structure and active fault of Yanyuan-Mabian seismic zone―The result of high-resolution seismic refraction experiment

The authors processed the seismic refraction Pg-wave travel time data with finite difference tomography method and revealed velocity structure of the upper crust on active block boundaries and deep features of the active faults in western Sichuan Province. The following are the results of our investigation. The upper crust of Yanyuan basin and the Houlong Mountains consists of the superficial low-velocity layer and the deep uniform high-velocity layer, and between the two layers, there is a distinct, and gently west-dipping structural plane. Between model coordinates 180-240 km, P-wave velocity distribution features steeply inclined strip-like structure with strongly non-uniform high and low velocities alternately. Xichang Mesozoic basin between 240 and 300 km consists of a thick low-velocity upper layer and a high-velocity lower layer, where lateral and vertical velocity variations are very strong and the interface between the two layers fluctuates a lot. The Daliang Mountains to the east of the 300 km coordinate is a non-uniform high-velocity zone, with a superficial velocity of approximately 5 km/s. From 130 to 150 km and from 280 to 310 km, there are extremely distinct deep anomalous high-velocity bodies, which are supposed to be related with Permian magmatic activity. The Yanyuan nappe structure is composed of the superficial low-velocity nappe, the gently west-dipping detachment surface and the deep high-velocity basement, with Jinhe-Qinghe fault zone as the nappe front. Mopanshan fault is a west-dipping low-velocity zone, which extends to the top surface of the basement. Anninghe fault and Zemuhe fault are east-dipping, tabular-like, and low-velocity zones, which extend deep into the base-ment. At a great depth, Daliangshan fault separates into two segments, which are represented by drastic variation of velocity structures in a narrow strip: the west segment dips westward and the east segment dips eastward, both stretching into the basement. The east margin fault of Xichang Mesozoic basin features a strong velocity gradient zone, dipping southwestward and stretching to the top surface of the basement. The west-dipping, tabular-like, and low-velocity zone at the easternmost segment of the profile is a branch of Mabian fault, but the reliability of the supposition still needs to be confirmed by further study. Anninghe, Zemuhe and Daliangshan faults are large active faults stretching deep into the basement, which dominate strong seismic activities of the area.     

The distribution rule and seepage effect of the fractures in the ultra-low permeability sandstone reservoir in east Gansu Province,Ordos Basin

To study the impact of the fractures on development in the ultra-low permeability sandstone reservoir of the Yangchang Formation of the Upper Triassic in the Ordos Basin,data on outcrops,cores,slices,well logging and experiments are utilized to analyze the cause of the formation of the fractures,their distribution rules and the control factors and discuss the seepage flow effect of the fractures. In the studied area developed chiefly high-angle tectonic fractures and horizontal bedding fractures,inter-granular fractures and grain boundary fractures as well. Grain boundary fractures and intragranular fractures serve as vital channels linking intragranular pores and intergranular solution pores in the reservoir matrix,thus providing a good connectivity between the pores in the ultra-low perme-ability sandstone reservoir. The formation of fractures and their distribution are influenced by such external and internal factors as the palaeo-tectonic stress field,the reservoir lithological character,the thickness of the rock layer and the anisotropy of a layer. The present-day stress field influences the preservative state of fractures and their seepage flow effect. Under the tec-tonic effect of both the Yanshan and Himalayan periods,in this region four sets of fractures are distributed,respectively assuming the NE-SW,NW-SE,nearly E-W and nearly S-N orientations,but,due to the effect of the rock anisotropy of the rock formation,in some part of it two groups of nearly orthogonal fractures are chiefly distributed. Under the effect of the present-day stress field,the fractures that assume the NE-SW direction have a good connectivity,big apertures,a high permeability and a minimum starting pressure,all of which are main advantages of the seepage fractures in this region. With the development of oilfields,the permeability of the fractures of dif-ferent directions will have a dynamic change.     

断裂带土中氡浓度影响因素分析及特征曲线应用

土壤中的氡气（Rn）是研究断裂的一个有效手段,通过氡浓度变化曲线可以大致确定断裂带的位置、范围和产状等。一般而言,断裂带上方呈现Rn峰值异常,远离断裂带逐渐衰减至正常水平。土壤中氡浓度变化取决于断裂的规模、倾角、岩性、破碎带宽度、充填物透气性、覆盖层、地下水、稀释效应和放射性平衡等因素。     

南水北调西线一期工程坝址处径流量计算与分析

南水北调西线一期工程调水区所涉及的6条河流(泥曲、达曲、色曲、杜柯河、玛柯河、阿柯河)坝址处均无实测的径流资料,开展该地区的水文研究属于无资料水文预报问题(PUBs)。利用年径流量的变差系数Cv值、年际变化绝对比率P和不均匀系数α对坝址下游的朱倭、朱巴、足木足、绰斯甲4站的实测年径流的年际变化进行分析,计算结果为各坝址径流年际变差系数Cv为0.15~0.26,表明调水区的多年径流量变化不大;年际变化绝对比率P为1.88~3.00,其中朱倭站的径流年际变化最大,最大径流量是最小径流量的3倍,绰斯甲站的最大径流量是最小径流量的1.88倍,4站的径流变化都不剧烈;径流不均匀系数α为0.58~0.75,表明该流域径流量的年际变化较为均匀;利用水文比拟法对坝址处的径流进行了计算,并根据R/S分析法对坝址处径流序列的未来趋势进行了初步分析,各坝址处的年径流序列的赫斯特系数均大于0.5,说明各径流序列的未来趋势具有持续性,即未来趋势与历史呈正相关,6个调水坝址中只有扎洛和克柯处的径流未来是减少的,其余坝址处径流都是增加的,这样西线一期工程调水区的河流有利于水资源的可持续开发利用。     

The earthquake sequence of May 1951 at Jucuapa, El Salvador

Three earthquakes that happened over two days in May 1951 caused extensive damage to villages in a small area of eastern El Salvador (Central America). Contemporary hypocentral solutions indicated focal depths, confirmed by re-calculations using available seismic data, of the order of 90 km, suggesting events associated with the subducted Cocos plate. Macroseismic observations strongly indicate that the earthquakes were of very shallow focus and this is supported by wave-form modeling and the appearance of seismograms recorded in Guatemala. A re-evaluation of the location and source characteristics for these events is presented, together with a fault plane solution and additional macroseismic evidence. The implications for seismic hazard and risk assessment in Central America, where shallow earthquakes of moderate magnitude, frequently occurring in clusters, pose the greatest threat to settlements which, like the area affected by these events, are concentrated along the axis of Quaternary volcanoes.     

二元函数逼近在斜坡可靠度分析中的应用研究

极限平衡分析方法是斜坡稳定性评价中的常用方法,在长期的工程实践中积累了丰富的经验,但其不能考虑斜坡岩土体中实际存在的不确定性,在应用中具有一定的局限性。可靠度分析方法可有效地考虑斜坡系统内的不确定性和相关性,但因状态函数偏导数的求解比较困难,使可靠度分析方法在实际中应用不便。为解决上述问题,根据二元函数插值逼近原理,在矩形区域上构造拉格朗日不完全双二次多项式逼近状态函数,从而近似地计算状态函数的偏导数,求得状态函数的均值和方差,并利用精度较高的一次二阶矩方法来计算斜坡的可靠指标和破坏概率。据鄂西恩施地区马堡营滑坡实例分析表明,引入二元函数插值逼近的一次二阶矩方法计算结果与剩余推力法及Monte-carlo模拟方法结果一致,其精度可满足工程需求。