武汉市高层建筑岩土工程问题分析

武汉市是华中地区最大的城市,改革开放以来,兴建了许多高层建筑。高层建筑尤其是超高层建筑的主要特点是高度大、重心高、基底压力大及基础埋深大等。而武汉地区的地质条件又比较复杂,就第四纪地层而言,从最新沉积的各类软土如人工填土、淤泥类土、软塑状粘性土等,到全新世(Q4)沉积的各类砂土与卵砾石,直至晚更新世(Q3)及其以前沉积的老粘土均有分布。各类土层的厚度、深度及性质均变化较大。因此武汉地区高层建筑的岩土工程问题就显得复杂与多样,在众多复杂的岩土工程问题中,本文主要分析了比较突出的基础持力层与基础类型的确定,深基坑开挖中的边坡滑移、基坑涌水、流砂、突涌以及基坑防护等。通过对这些问题的分析,从中可以得出一些规律,对今后高层建筑的兴建具有一定的指导作用。     

应用RMi法估算岩体变形模量

RMR法与Q法是国内外八、九十年代岩体质量和参数估算的常用方法,然而RMR法和Q法对质量较差的岩体不太实用,而RMi法是一种既适用于软岩又适用于硬岩的岩体质量评价和参数估算方法。本文在介绍RMi法基本原理的基础上,对贵州省鱼简河水库坝基岩体变形模量进行确定。     

GPS-measured land subsidence in Ojiya City, Niigata Prefecture, Japan

Land subsidence caused by compression of clay layers in Ojiya City, Japan was measured by global positioning system (GPS) between 1 April 1996 and 31 December 1998.

Three baselines were selected in and around the city, and height difference on a WGS-84 ellipsoid was measured by GPS on each baseline. The ground at the GPS station in the city subsides and rebounds 7 cm every winter and spring, respectively. Measurement accuracy was 9.5 mm standard deviation. Ground water level was observed at a well near the GPS station. Regression analysis between total strain, calculated as ratio of the height difference displacement to the total thickness of the clay layers, and the layers' effective stress change with ground water level change gave good correlation. The slope of regression line 7.0×10⁻¹¹ m²/N was obtained as an average apparent coefficient of volume compressibility of the layers.     

Digital model of corrected accumulated flow for peak discharge data acquisition and drainage system design

The design of a drainage system for a roofing slate quarry was implemented by the enhancement of discharge peak estimation, and the uncertainty inevitably associated with the engineering model was reduced.

The development of a topographical, geological, and vegetation cover database developed from a Geographical Information System (GIS) allowed for the definition of the drainage network for a hydraulic system, along with the calculation of the runoff coefficient. This is applied to the digital model of accumulated flow (DMF) as a weight correction coefficient, using a matrix-based model at 5×5 m resolution. The new digital model of corrected accumulated flow (DMCF) is the result of combining the thematic maps with the map of slope <3%, which was previously created from the slope model. It is demonstrated that this new model allows to apply the “Rational Method” on cartographic units defined by the GIS.

The DMCF is compared with other traditional applications of the Rational Method based on the calculation of the discharge peak considering: (1) the drainage basin as a single watershed or (2) defining an average runoff coefficient in each sub-watershed. Both approaches have bigger discharge peaks than those obtained by the DMCF since the slope, lithology, and vegetation cover have average values, and the runoff coefficient is poorly defined, increasing the uncertainty in the discharge peak.     

An experimental investigation of LNAPL migration in an unsaturated/saturated sand

Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting.     

Process of Housing Damage Assessment: The 1995 Hanshin-Awaji Earthquake Disaster Case

Rebuilding of victims' livelihoods was a crucial issue in the restoration process in the1995 Hanshin-Awaji Earthquake Disaster. Housing damage assessment influencedmost of the rebuilding of the livelihood in the long term, because the Victim Certificatesissued by the local governments based on the results of the Housing damage assessmentwas required to receive most of the individual assistance measures. In the process ofHousing damage assessment, many complex problems arose, leading to extensivework on the part of the disaster responders. Consequently, a considerable number ofvictims were dissatisfied with the assessment and applied for a resurvey. Due to a floodof requests for resurvey, disaster responders had to work on damage assessment, leavingrelief activities aside.In order to facilitate Housing damage assessment, this paper discusses thefollowing five points: (1) the processes and the problems of assessments performedin the Hanshin-Awaji Earthquake Disaster, (2) the changes in the nature of informationneeded by the victims, (3) the improvements over the present damage assessment, (4)the housing situation in Japan, and (5) the international situation on damage assessment.It is obvious from the results that a poor damage assessment system and the size ofthe disaster produced a very large work load. Differences in appreciation among theinvestigators also contributed to unfair assessments and led to the victims beingincreasingly dissatisfied by the survey results. Finally, a design concept for acomprehensive damage assessment system, which has been derived from theabove five points, is proposed for post-disaster management.     

Reliability based risk index for the design of reinforced earth structures

The design methods currently used for earth reinforcement are mostly based on deterministic properties of both the soil and the construction materials used. Nowadays, however, the general trend is designing at a specific degree of reliability. This is even more true where the raw data such as soil properties exhibit significant variation. Deterministic solutions, in this case, may not suffice. Therefore, this paper will attempt to use probabilistic formulations thereby modifying the existing design procedure of reinforced earth retaining walls to account for uncertainties and variabilities. Through a first order Taylor's series expansion about the mean, the mean and variance of the strip reinforcing components, namely width and length, are derived in terms of the variations in the soil properties. Design charts that enable estimation of both mean and variance are developed to avoid extensive partial differentiation involved in the computations. Using appropriate probability distributions along with the mean and variance, the final design outputs are determined for a selected failure probability by introducing what is refered to as 'risk index'. The results indicate that the risk index increases with an increase in the coefficient of variations and a decrease in failure probability. Furthermore, it is shown that in some cases, depending on the variabilities of the soil properties, the classical design technique produced a relatively high failure probability. This revised version was published online in July 2006 with corrections to the Cover Date.     

STRUCTURAL CHARACTERISTICS OF THE NIUSHOU MOUNTAIN AND ITS GEOLOGICAL SIGNIFICANCE IN CENTRAL NINGXIA

There are many thrust-related structures occurring in the Paleozoic strata of the Niushou Mountain in the central part of Ningxia Hui Autonomous Region. The fault-related folds are the typical structures in this area. Based on the analysis about these structures and their relationships, the processes by which these structures of the Miboshan Formation were formed are reconstructed, and the strata underwent about three stages of deformation: (1) horizontal shortening, (2) folding, and (3) thrusting. And the fact that the Niushou Mountain is the leading edge of an old thrust sheet was proved, the Niushou Mountain, the Daluo Mountain and the Xiaoluo Mountain together constitute the front part of this old thrust zone, so the Niushou Mountain and the Ordovician strata in the central and southern parts of Ningxia now are likely allochthons. In the period from middle Ordovician to Devonian, the areas of the central and southern Ningxia belonged to the back-arc foreland basin of North Qilianshan orogen, which was adjacent to the continent in the north. In the later part of the early Paleozoic period, the Niushou Mountain was formed after the closure of the back-arc foreland basin.     

Magnetotelluric Investigation of the Hydrothermal System and Heat Source in the Muine-Toyoha Geothermal Area, Hokkaido, Japan

Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area.     

承台外区土阻力群桩效应及效应系数的有限元分析

利用三维弹塑性有限元方法,对复合桩基承台外区土阻力群桩效应及其效应系数进行了研究,讨论了土类、桩长、桩距、桩数等对承台外区土阻力群桩效应及其群桩效应系数的影响,结果表明(1)承台外区土阻力随承台宽与桩长之比 (B/L)的增大而增大,但增幅不大;随桩距S增大而增大;受桩数n的影响不大。(2)承台外区群桩效应系数随B/L增大几乎无变化;随S增大而增大;不随n变化而变化。(3)承台外区群桩效应系数与土类有关。