The Loyalty—New Hebrides Arc collision: Effects on the Loyalty Ridge and basin system,Southwest Pacific (first results of the ZoNéCo programme)

The ZoNéCo 1 and 2 cruises of Ifremer's Research Vessel L'Atalante, collected new swath bathymetry and geophysical data over the southern and northern segments of the basins and ridges forming the Loyalty system. Between the two surveyed areas, previous studies found evidence for the resistance of the Loyalty Ridge to subduction beneath the New Hebrides trench near 22°S–169°E. On the subducted plate, except for seismicity related to the downbending of the Australian plate, recorded shallow seismicity is sparse within the Loyalty system (Ridge and Basin) where reliable focal mechanism solutions are almost absent.Swath bathymetry, seismic reflection and magnetic data acquired during the ZoNéCo 1 and 2 cruises revealed a transverse asymmetric morphology in the Loyalty system, and an along-strike horst and graben structure on the discontinuous Loyalty Ridge. South of 23°50S and at 20°S, the two WSW-ENE-trending fault systems, respectively, sinistral and dextral, that crosscut the southern and northern segments of the Loyalty system, are interpreted as due to the early effects of collision with the New Hebrides Arc. A NNW-SSE trend, evident along the whole Loyalty system and on the island of New Caledonia, is interpreted as an inherited structural trend that may have been reactivated through flexure of the Australian lithospheric plate at the subduction zone.Overall then, the morphology, structure and evolution of the southern and northern segments of the Loyalty system probably result from the combined effects of the Australian plate lithospheric bulge, the active Loyalty-New Hebrides collision and the overthrust of the New Caledonian ophiolite.     

鲜水河断裂带炉霍段的水平运动及地震的重复性研究

本文讨论了鲜水河活动断裂带炉霍段的水平断错、古地震遗迹与地震重复间隔等问题。晚更新世以来断裂的平均滑动速率为13毫米/年。全新世中期以来大震的重复间隔时间小于600年     

制图综合中移位算法概述分析

本文首先对移位算法的发展史进行简要介绍,然后,在其基础上,根据各移位算法的思想特征,对各移位算法进行归纳,将其划分为七类,并对每一类算法的核心思想进行详细论述,最后,对各类移位算法进行评价,分析其优缺点,总结各类算法中的可借鉴思想,为更好地实现移位奠定基础。     

祁阳山字型构造质疑

结合区域构造演化背景及构造变形特征,对祁阳弧形构造的形成机制进行研究。分析表明,传统山字型构造机制难以解释祁阳弧形构造的诸多特征,且前人认为变形动力来源于东西向挤压应力场,也与印支期区域构造应力场实为NWW向的构造背景不符,因此祁阳弧形构造并不属典型山字型构造。基于研究区构造活动的客观实际,提出祁阳弧形构造的可能形成机制:NW向基底隐伏断裂和NNE-NE向主干断裂分别于印支期和燕山期产生强烈左旋走滑活动,从而使区域NNE向构造线在中段产生左旋偏转成为NNW向,从而形成S形的祁阳弧形构造。这一机制可较好解释祁阳弧形构造的若干特征,如关帝庙穹窿呈NWW走向、北反射弧构造形迹不显著、北弧弧顶脱位及内弧曲率大于外弧、南弧弧顶脱位、紫云-中田-高峰串珠状穹窿的形成等。上述认识对华南地区弧形构造研究具有一定启示意义:除山字型构造作用和砥柱作用外,还应注意断裂走滑等其他构造活动对弧形构造的制约,以及多次构造活动叠加对构造形迹可能造成的影响。     

Probabilistic modeling of seismically triggered landslides using Monte Carlo simulations

The 2004 Chuetsu earthquakes of Niigata (Japan) triggered numerous landslides, and the most widespread types of landslides were highly disrupted, relatively shallow slides and soil (debris) flows. This paper presented a method to evaluate slope instability using Newmark displacement on a pixel-by-pixel basis in a given area. The proposed method was able to integrate Newmark displacement modeling and Monte Carlo simulations within geographical information systems. In the modeling, an empirical attenuation relationship was utilized to calculate Arias intensity over this study area, and the variability of geotechnical parameters was taken into account to calculate coseismic landslide displacement. Before deriving the displacement from related inputs, the Monte Carlo simulations ran 1,500 times and generated 1,500 displacement values for each grid cell, and then means and standard deviations of displacement were calculated and probabilistic distributions can be obtained. Finally, given 10 cm as a threshold value of displacement, estimated probabilities of displacement exceeding 10 cm were shown as a map of seismic landslide hazards. The resulting hazard map was classified into four categories from very low to high level.     

基于改进Snake模型的道路网空间冲突处理

在对Snake模型研究分析的基础上,结合地图制图的需求,从3个方面对Snake模型进行改进：首先建立Snake模型中参数与道路曲线形态特征的关系,以更好地保持移位前后道路形态的相似性;其次控制Snake模型中外力的传播范围,以尽量保持要素位置的准确性;最后,通过道路交叉点的权重属性控制,保证移位后各交叉点的连通性以及道路的整体拓扑关系不发生变化。在此基础上,提出道路网移位整体思路,并采用改进的Snake模型对其进行移位,解决空间冲突。     

有限元法模拟开挖引起的基坑水平位移和邻近建筑物沉降

以徐州某采用水泥土墙支护的基坑为例,采用有限元数值模拟的方法,对基坑开挖引起的水平位移量和邻近建筑物沉降量进行了计算,并与实际监测值进行了对比分析,得到了一些关于如何控制基坑水平位移和减少基坑周边建筑沉降的结论。     

钻孔灌注桩施工对邻近运营隧道变形影响研究

桩基施工将引起周边地层位移和邻近隧道结构变形,以南京龙津桥改建项目桩基工程为背景,通过现场实测,分析研究钻孔灌注桩施工全过程各工况条件对地层位移场和邻近既有隧道结构变形的影响规律。结果表明:由于钢套管的护壁作用,钻孔灌注桩施工过程中产生的最大地层位移和隧道结构变形较小,说明采用“钢套管边旋压边取土”、“群桩间跳施工”等工艺,对周围土体扰动影响程度较小,建议近隧桩基工程采用全套管灌注桩的施工方法,监测分析结果可为类似工程提供技术参考。     

大变形有限元法分析边坡稳定性

边坡稳定性分析的重要任务是确定边坡潜在滑面的位置及相应的安全系数,鉴于坡体位移可在现场监测中直接得到,提出边坡潜在滑面确定的位移判据,采用大变形有限元首先计算出边坡的位移场,然后在开挖面的不同高度作塑性区内的水平位移参考线,依次连接参考线上的位移突变点即得到边坡失稳的潜在滑面位置,分析滑面上的应力以及岩体抗剪强度即得到边坡的整体安全系数。     

Effect of sampling and linkage on fault length and length–displacement relationship

The power-law exponent (n) in the equation: D=cL ⁿ , with D = maximum displacement and L = fault length, would be affected by deviations of fault trace length. (1) Assuming n=1, numerical simulations on the effect of sampling and linkage on fault length and length–displacement relationship are done in this paper. The results show that: (a) uniform relative deviations, which means all faults within a dataset have the same relative deviation, do not affect the value of n; (b) deviations of the fault length due to unresolved fault tip decrease the values of n and the deviations of n increase with the increasing length deviations; (c) fault linkage and observed dimensions either increase or decrease the value of n depending on the distribution of deviations within a dataset; (d) mixed deviations of the fault lengths are either negative or positive and cause the values of n to either decrease or increase; (e) a dataset combined from two or more datasets with different values of c and orders of magnitude also cause the values of n to deviate. (2) Data including 19 datasets and spanning more than eight orders of fault length magnitudes (10⁻²–10⁵ m) collected from the published literature indicate that the values of n range from 0.55 to 1.5, the average value being 1.0813, and the peak value of n _d (double regression) is 1.0–1.1. Based on above results from the simulations and published data, we propose that the relationship between the maximum displacement and fault length in a single tectonic environment with uniform mechanical properties is linear, and the value of n deviated from 1 is mainly caused by the sampling and linkage effects.