海水盐度对牙鲆仔稚鱼的生长、存活率及白化率的影响

１９９３年１１月２０日自鹿儿岛养殖业购得自然产卵获得的牙鲆受精卵，经空运、陆驼至福冈的九州大学附属水产试验所，仔鱼翌日孵出，３ｄ后开口。以此材料观察研究试验室条件下不同海水盐度对牙鲆仔稚鱼的生长，存活率及白化率的影响。试验分４组，盐度分别为：１组（自然海水对照组），３０．５－３１．８；２组，２６．０：３组，２１．０；４组，１６．０。每组设２个重复，使用１００１透明玻璃钢水槽，每槽放２０００尾刚开口     

东亚岛弧地形横剖面与板块运动

通过对东亚岛弧横剖面形态的系统分析，并结合弧前的构造应力的分析，作者认为，东亚岛弧形成于板块东移的构造环境中，横剖面形态存在两种基本类型即内缓外陡型和内陡外缓型，这两种不同的横剖面具有不同的弧前应力，前者表现弧前挤压，后者表现弧前引张，这反映地貌形态与构造应力之间的密切关系。     

Regression Formulations for the Stress at Hot Spot of Multiplanar Tubular DT Joints

- Stress concentration analysis of multiplanar tubular DT joints plays an important role in the fatigue design of offshore platforms. A semi-analytic method for stress analysis under the condition of any loads is briefly introduced in the paper. Nineteen multiplanar tubular DT joints with one of two braces of the same dimension subjected to axial loads and out- of- plane bending moments are computed for parametric stress analysis by using the present method. The influence of geometrical parameters on the stresses of multiplanar tubular DT joints is discussed and compared with corresponding uniplanar T joints. The regression formulae for the stress at hot spot of multiplanar DT joints are found by modification of SCF of corresponding uniplanar T joints. The parametric formulae for the maximum stress by superposition. Finally, the influences of stiffening effect and load-interaction effect on the maximum stress of DT joints are discussed.     

应用六氯化苯测年法对厦门港现代沉积速率的测定

岩芯柱样用静力岩芯采样器于1986年采自福建省厦门港一九龙江口海域。通过对这些岩芯柱样中六氯化苯(BHC)的垂直分布状况和生物扰动类型的分析,应用 S_R=D_(BHC-D_(mix)/Y的计算模式,获得了这些岩芯的现代沉积速率数据。将这些数据、方法与原理完全不同的~(210)Pb放射性同位素测年法同岩芯测年数据比较,其结果在数据和数量级上有一定可比性。初步认为,再经进一步探索和改进,BHC测年法有可能应用于近岸河口港湾几十年来现代沉积速率的测定而与其它测年法互为补充。     

牙鲆鱼苗长途运输技术的试验研究

本实验对10个批次，总数为19047尾的不同规格和产地的牙鲆鱼苗长途运输效果进行了研究。结果表明，规格为9-12cm的鱼苗，在水温6－12℃，运输时间为35－50h，采用空运和低温活水车运输，运输死亡率为664尾，死亡率为3.39%，低温活水车短途运输是可行的，尽管长途车运方式成本较低，但由于应激强度较大，对鱼苗的生长性能影响较为严重，驯养10d累计死亡率最高达18.1%，这种模式不可取。低温（6℃）、小规格（9cm)的空运较适合牙鲆鱼苗长途运输。此外，本文还就运输应激反应、预防措施和药物防治进行详细的讨论。     

An Experi mental Study on Wave-Induced Dynamic Stresses in Seabed

1 .IntroductionEvery year ,Taiwanis subjectedtotwo or three typhoonintrusions in average which always causedisasters . Most of the disasters which occur around the coastal zone are due to seabed instability andcoastal structure destruction caused bytyphoo…     

厦门港真刺唇角水蚤的生长率

本文以实验室培养为主,结合自然种群调查,观测厦门港真刺唇角水蚤各发育阶段体长、体重的增长状况,并研究了其生长率与温度、发育期的关系。     

Nonlinear Static Finite Element Stress Analysis of Pipe-in-Pipe Risers

Owing to the complexity of the pipe-in-pipe (PIP) riser system in structure, load and restraint, many problems arise in the structural analysis of the system. This paper presents a new method for nonlinear static finite element stress analysis of the PIP riser system. The finite element (FE) model of the PIP riser system is built via software AutoPIPE 6.1. According to the specialties of a variety of components in the PIP riser system, different elements are used so as to model the system accurately. Allowing for the complication in modeling the effects of seabed restraint, a technique based on the bilinear spring concept is developed to calculate the soil properties. Then, based on a pipeline project, the entire procedure of stress analysis is discussed in detail, including creation of an FE model, processing of input data and analysis of results. A wide range of loading schemes is investigated to ascertain that the stresses remain within the acceptable range of the pipe material strength. Finally, the effects of the location of flanges, the thermal expansion of submarine pipelines and the seabed restraint on stress distribution in the riser and expansion loop are studied, which are valuable for pipeline designers.     

不同卵密度对太平洋牡蛎三倍体诱导效果影响的研究

本实验主要研究用70mg／L浓度的6－MDAP（二甲基氨基嘌呤）对太平洋牡蛎的受精卵进行三倍体诱导，研究受精卵的密度对诱导效果的影响，以及诱导后受精卵的孵化率和畸形率。实验结果表明：当受精卵的密度为4万个／ml时三倍体率最高，相应的孵化率最高，综合来看，4万/ml的卵密度是生产上较好的受精卵处理密度。