Fluid salinities obtained by infrared microthermometry of opaque minerals: Implications for ore deposit modeling — A note of caution

Infrared microthermometry of opaque minerals has revealed that temperatures of phase changes vary with the infrared light source intensity, resulting in an overestimate of fluid salinities and an underestimate of homogenization temperatures. Failing to recognize this analytical artifact during infrared microthermometry may result in meaningless geological models. A fluid inclusion investigation on enargite from a high-sulfidation epithermal deposit is used as an example to document this. Fluid salinities obtained during an early investigation ranged between 6.3 and 20.4 wt.% NaCl, which were interpreted as intense boiling or as evidence for the involvement of a magmatic brine during ore formation. Fluid inclusion salinities obtained with improved analytical settings, i.e. low light intensities, fall between 1.1 and 1.7 wt.% NaCl and are in better agreement with fluid salinities obtained in quartz from similar deposits, and recent modeling suggesting vapor transport of Au and Cu from deep porphyry-Cu environments to shallower high-sulfidation epithermal deposits.     

The transition from peraluminous to peralkaline granitic melts: Evidence from melt inclusions and accessory minerals

Fractional crystallization of peraluminous F- and H₂O-rich granite magmas progressively enriches the remaining melt with volatiles. We show that, at saturation, the melt may separate into two immiscible conjugate melt fractions, one of the fractions shows increasing peraluminosity and the other increasing peralkalinity. These melt fractions also fractionate the incompatible elements to significantly different degrees. Coexisting melt fractions have differing chemical and physical properties and, due to their high density and viscosity contrasts, they will tend to separate readily from each other. Once separated, each melt fraction evolves independently in response to changing T/P/X conditions and further immiscibility events may occur, each generating its own conjugate pair of melt fractions. The strongly peralkaline melt fractions in particular are very reactive and commonly react until equilibrium is attained. Consequently, the peralkaline melt fraction is commonly preserved only in the isolated melt and mineral inclusions.

We demonstrate that the differences between melt fractions that can be seen most clearly in differing melt inclusion compositions are also visible in the composition of the resulting ore-forming and accessory minerals, and are visible on scales from a few micrometers to hundreds of meters.     

Atomistic calculations of structural and elastic properties of serpentine minerals: the case of lizardite

The physical properties of the hydrous phyllosilicate lizardite have been investigated by atomistic simulation using the GULP code based on transferable semi-empirical interatomic potentials. Lizardite behavior was first investigated during structure relaxation at room temperature. The Helmholtz free energy is minimum for an equilibrium structure that is in agreement with experiment. The bulk, shear, and Young modulii for lizardite were calculated along with the Poisson ratio. From the shear and bulk modulii, we also calculated translational and longitudinal acoustic wave velocities that are important quantities for tectonophysics models. As expected, lizardite is stiffer in the a direction parallel to the layers than in the c perpendicular direction; the variation of the unit cell parameters with pressure is in good agreement with experiment. The cohesive energy between two successive layers along c direction was calculated at 0.33 eV (i.e., 0.11 eV per OH bond) in good agreement with recent ab initio calculations. Upon pressure and temperature variations, we evidenced that structural changes are mainly pressure induced; pressure being accommodated by a decrease of the c parameter up to 10 GPa. We also found that the change of slope in the derivative of the c cell parameter with respect to pressure occurring around 2 GPa originates from the bending of the interlayer hydroxyl groups with respect to the layer normal direction.     

华南下寒武统镍钼矿层中铜铅锌矿物的发现及意义

华南扬子地块是我国古热水沉积成矿作用最为发育的地区之一,其热水沉积特性最早引起我国学者的关注。华南下寒武统黑色岩系中赋存多个与热水沉积成矿作用相关的大型、超大型重晶石矿床与N i-Mo-U-V多金属富集层。进一步研究分布在华南扬子地块黑色岩系中的金属、非金属矿床成因及其地球化学特征,对认识华南乃至全球晚震旦—早寒武世生物与环境演化有着十分重要的意义。本文对华南下寒武统镍-钼富集层矿石进行电子探针研究,识别出黄铜矿、黝铜矿等铜的独立矿物;闪锌矿等锌的独立矿物;方铅矿、白铅矿等铅的独立矿物。研究表明,在镍-钼矿石中这些矿物的发现为镍-钼矿层是热水沉积作用产物提供了直接的矿物学证据。     

含水矿物在真空下的释Ar机制:Ar-Ar热年代学面临的新问题

地质体的实际情况、激光显微探针束研究、XRD和SEM观测以及真空加热下Ar的释放特征都表明体积扩散不是含水矿物在真空加热中释放Ar的唯一机制。在低温下 ,Ar的释放主要受由缺陷引起的短程扩散和体积扩散共同作用的多途径扩散机制制约 ;而在高温下 ,由于含水矿物在真空中不够稳定 ,Ar的释放受到脱羟基、脱氢、氧化反应、分层作用等造成的晶体结构改变的强烈影响。含水矿物在高温下的氧化分解会导致矿物中原始Ar浓度梯度的均一化 ,因而无法得到真实的Ar分布剖面 ,也无法据此计算矿物的封闭温度 ,并进而可能影响到ArAr年龄坪的地质意义。     

Pressure effect on Ti- or P-rich accessory mineral saturation in evolved granitic melts with differing K2O/Na2O ratios

The solubility of Ti- and P-rich accessory minerals has been examined as a function of pressure and K₂O/Na₂O ratio in two series of highly evolved silicate systems. These systems correspond to (a) alkaline, varying from alkaline to peralkaline with increasing K₂O/Na₂O ratio; and (b) strongly metaluminous (essentially trondhjemitic at the lowest K₂O/Na₂O ratio) and remaining metaluminous with increasing K₂O/Na₂O ratio (to 3). The experiments were conducted at a fixed temperature of 1000 °C, with water contents varying from 5 wt.% at low pressure (0.5 GPa), increasing through 5–10 wt.% at 1.5–2.5 GPa to 10 wt.% at 3.5 GPa. Pressure was extended outside the normal crustal range, so that the results may also be applied to derivation of hydrous silicic melts from subducted oceanic crust.

For the alkaline composition series, the TiO₂ content of the melt at Ti-rich mineral saturation decreases with increasing pressure but is unchanged with increasing K content (at fixed pressure). The P₂O₅ content of the alkaline melts at apatite saturation increases with increased pressure at 3.5 GPa only, but decreases with increasing K content (and peralkalinity). For the metaluminous composition series (termed as “trondhjemite-based series” (T series)), the TiO₂ content of the melt at Ti-rich mineral saturation decreases with increasing pressure and with increasing K content (at fixed pressure). The P₂O₅ content of the T series melts at apatite saturation is unchanged with increasing pressure, but decreases with increasing K content. The contrasting results for P and Ti saturation levels, as a function of pressure in both compositions, point to contrasting behaviour of Ti and P in the structure of evolved silicate melts. Ti content at Ti-rich mineral saturation is lower in the alkaline compared with the T series at 0.5 GPa, but is similar at higher pressures, whereas P content at apatite saturation is lower in the T series at all pressures studied. The results have application to A-type granite suites that are alkaline to peralkaline, and to I-type metaluminous suites that frequently exhibit differing K₂O/Na₂O ratios from one suite to another.     

战略环境评价若干问题研究

分析了传统环境影响评价制度的不足，回顾了战略环境评价的研究与实践进展，阐述了战略环境评价与环境可持续发展的关系，并对以实现环境可持续发展为目标的战略环境评价体系所存在的问题进行了分析。     

远东热点:朝鲜半岛形势分析

朝鲜半岛独特的地理位置，无论对周边的中，俄，日三国，还是对大洋彼岸的美国都具有十分重要的地缘战略意义。如果说这里是四大国利益相互交错的唯一地区，那么解决朝鲜半岛问题便不仅取决于半岛内部北，南双方的互动关系，而且取决于四大四的立场及东北亚政治地理格局的演变态势。近年来随着朝鲜北，南双方首脑的成功会晤，朝鲜半岛的和平统一进程迈出了实质性步伐。但由于朝鲜半岛问题牵涉面广，影响因素复杂，从而使半岛的和平统一进程出现了一波三折的复杂局面，本文从政治地理学角度对半岛形势进行了分析。供关心朝鲜半岛局势的同仁参考。     

多孔结构矿物（岩石）及其环境修复材料的实用性

具有多孔结构的矿物(岩石)作为一类特殊的工业原材料，在环境修复领域的应用前景正在成为研究热点。本文从微孔的尺度、结构、形态、成分等表面固体特征出发，概括性地论述了凹凸棒石、海泡石、蒙脱石、沸石、硅藻土等十几种多孔结构矿物(岩石)在环境修复工程中用作过滤材料、吸附剂、离子交换剂和催化剂等材料时的基本特征和使用时应注意的问题。