We estimated Moho depth beneath the southern Tanlu fault zone and its adjacent area using common-conversion-point(CCP)stacking of receiver fun-ctions,which were computed from teleseismic records of the CEArray.Our estimated Moho depth matches well with 2-D profiles derived from active-source deep seismic reflection surveys,suggesting that the calculated the Moho depth map is likely accurate beyond the 2-D profiles.Overall,the estimated Moho depth map showed a high spatial correlation with tectonic provinces,i.e.,Moho topographic boundaries are in good agreement with geological boundaries.Beneath the Dabie orogenic belt and the mountainous areas in southern Anhui Province,the Moho lies relatively deep,and there is an obvious difference in Moho depth between the two sides of this segment of the Tanlu fault.We further selected four depth profiles with dense instrumentation to show Moho depth changes across different tectonic blocks in the study area.We saw two step-like changes in Moho depth beneath the Xiangfan-Guangji and Gushi-Feizhong,which run parallel along the WNW-ESE direction and delineate the southern and northern bounds of the northern Dabie orogenic belt,which is likely the suture zone between the North China Block and South China Block.Crust beneath the northeast corner of the study area is significantly thinner than other areas,which is consistent with the crustal detachment model proposed for suturing between the North and South China blocks in the region east to the Tanlu fault. 相似文献
Detecting subsurface fault structure is important for evaluating potential earthquake risks associated with active faults. In this study, we propose a new method to detect faults using reflected surface waves observed in ambient noise cross correlation functions. Ambient noise tomography using direct surface waves obtained from ambient noise interferometry has been widely used to characterize active fault zones. In cases where a strong velocity contrast exists across the fault interface, fault-reflected surface waves are expected. We test this idea using a linear array deployed in the Suqian segment of Tanlu fault zone in Eastern China. The fault-reflected surface waves can be clearly seen in the cross-correlation functions of the ambient noise data, and the spatial position of the fault on the surface is close to the stations where the reflected signals first appear. Potentially reflected surface waves could also be used to infer the dip angle, fault zone thickness and the degree of velocity contrast across the fault by comparing synthetic and observed waveforms. 相似文献
The Wenchuan MS8.0 earthquake occurred on the Longmenshan fault which inclines at a dip angle exceeding 60 degrees. Since most thrust earthquakes occur on faults with dip angles of about 30 degrees, it is enigmatic why the Wenchuan earthquake occurred on such a steep fault. In this study we use a simple finite element model to investigate how the stress state in the fault changes with the variation of Poisson's ratio. The results show that, with the Poisson's ratio in the fault increasing, the magnitudes of the principal stresses increase and the maximum shear stress decrease, and, especially, the angle between the maximum principal stress and the fault plane decreases, which will enhance the driving force to overcome the frictional resistance on the fault. The increase of Poisson's ratio in the fault may be an important factor to affect the occurrence of the fault earthquakes with large angles between maximum principal stress and fault plane.