基坑支护结构施工技术要点与工程实例分析(下)

４地下连续墙施工技术方法４．１要点（１）导墙的修筑精度（宽度、平直度、垂直度和标高等）和强度对成槽施工质量有直接影响,高质量的导墙是高质量槽段的基础,常用的导墙形式如图２所示。图２导墙断面形式示意图（ａ）板型;（ｂ）Ｌ型;（ｃ）倒Ｌ型;（ｄ）槽型导墙...     

软土层施工桩基的新方法滚压法

介绍软土层用新型孔底工具－滚压器施工桩基的工作原理、施工工艺,滚压器基本结构及不同直径滚压器的技术特征。     

反射波法检测桩身完整性的一种数据处理方法

本文以纵波在杆中传播的理论为根据,介绍一种用于确定反射波往返时及视反射系数等参数的方法。将视反射系数经过一定的校正后,可定量分析反射界面的波阻抗差异的大小,进而确定桩身缺陷的严重程度;反射波往返时则用来推算桩身缺陷的位置。     

Damage distribution during the 1994 Northridge, California, earthquake relative to generalized categories of surficial geology

The spatial distributions of severely damaged buildings (red-tagged) and of breaks in the water distribution system following the 1994 Northridge, California, earthquake (M_L = 6·4) are investigated relative to the local characteristics of surficial geology. The pipe breaks are used as an indicator of nonlinear soil response, and the red-tagged buildings as indicator of severe shaking. The surficial geology is described by several generalized categories based on age, textural character and thickness of the near surface layer. Two regions are studied: the San Fernando Valley and Los Angeles-Santa Monica. The analysis shows that there is no simple correlation between damage patterns and surficial geology. Single family wood-frame buildings were damaged less when built on fine silt and clay (0–3 m thick) from the late Holocene.     

钢管高强混凝土叠合柱的抗震性能研究

通过周期性往复试验,研究了钢管高混凝土叠合柱柱的破坏形态,耗能能力、延性、承载力以及各种组成部分共同工作等内容,并与钢管高强混凝土核心柱进行了对比;随后通过计算,讨论了叠合柱中有关参数对其极限承载力和影响;最后给出了叠合柱正截面极限承载力的简化计算方法。     

滁州市会峰大厦桩基垂直静荷载试验研究

本文根据滁州市会峰大厦人工挖孔扩底桩的垂直静荷载试验成果,分析研究了滁州市红砂岩地基嵌岩桩的荷载有受力特征。     

深基坑锚杆护坡桩支护结构稳定性评价

锚杆护坡桩是深基坑工程常用的一种支护结构。文中对设计中所涉及到的结构稳定性评价问题进行了探讨,利用Ｋｒａｎｚ理论一些假设和条分法原理,提出了深基坑锚杆抗护坡桩稳定性评价的方法。该方法克服了Ｋｒａｎｚ理论中的一些不足,简化了条分法的计算并通过支护工程验证,具有一定的实用价值。     

Magma traps: Part II,application

A model of the lithostatic control of the ascent of magma, described in Part I (this volume), is tested against data from the Upper Cretaceous-Lower Tertiary sedimentary and volcanic region of central West Greeland: the thickness of sedimentary rock; the thickness of the pillow breccias; the total thickness of the lava pile; the depth of the post volcanic paleosurface. The local development is largely determined by a single parameter, the proportion of crustal thinning, and requires a magma source at 75 km depth with differentiation at 11 km depth. The model is applied in outline to the development of continental and orogenic volcanism in New Zealand.     

Experimental and computational validation and verification of the Stokes–Darcy and continuum pipe flow models for karst aquifers with dual porosity structure

In our previous study, we developed the Stokes–Darcy (SD) model was developed for flow in a karst aquifer with a conduit bedded in matrix, and the Beavers–Joseph (BJ) condition was used to describe the matrix–conduit interface. We also studied the mathematical well‐posedness of a coupled continuum pipe flow (CCPF) model as well as convergence rates of its finite element approximation. In this study, to compare the SD model with the CCPF model, we used numerical analyses to validate finite element discretisation methods for the two models. Using computational experiments, simulation codes implementing the finite element discretisations are then verified. Further model validation studies are based on the results of laboratory experiments. Comparing the results of computer simulations and experiments, we concluded that the SD model with the Beavers–Joseph interface condition is a valid model for conduit–matrix systems. On the other hand, the CCPF model with the value of the exchange parameter chosen within the range suggested in the literature perhaps does not result in good agreement with experimental observations. We then examined the sensitivity of the CCPF model with respect to the exchange parameter, concluding that, as has previously been noted, the model is highly sensitive for small values of the exchange parameter. However, for larger values, the model becomes less sensitive and, more important, also produces results that are in better agreement with experimental observations. This suggests that the CCPF model may also produce accurate simulation results, if one chooses larger values of the exchange parameter than those suggested in the literature. Copyright © 2011 John Wiley & Sons, Ltd.     

Three‐dimensional nonlinear finite element analysis of pile groups in saturated porous media using a new transmitting boundary

The dynamic behaviour of pile groups subjected to an earthquake base shaking is analysed. An analysis is formulated in the time domain and the effects of material nonlinearity of soil, pile–soil–pile kinematic interaction and the superstructure–foundation inertial interaction on seismic response are investigated. Prediction of response of pile group–soil system during a large earthquake requires consideration of various aspects such as the nonlinear and elasto‐plastic behaviour of soil, pore water pressure generation in soil, radiation of energy away from the pile, etc. A fully explicit dynamic finite element scheme is developed for saturated porous media, based on the extension of the original formulation by Biot having solid displacement (u) and relative fluid displacement (w) as primary variables (u–w formulation). All linear relative fluid acceleration terms are included in this formulation. A new three‐dimensional transmitting boundary that was developed in cartesian co‐ordinate system for dynamic response analysis of fluid‐saturated porous media is implemented to avoid wave reflections towards the structure. In contrast to traditional methods, this boundary is able to absorb surface waves as well as body waves. The pile–soil interaction problem is analysed and it is shown that the results from the fully coupled procedure, using the advanced transmitting boundary, compare reasonably well with centrifuge data. Copyright © 2007 John Wiley & Sons, Ltd.