海拉尔盆地贝尔凹陷的油气运聚分析

海拉尔盆地贝尔凹陷是一个以白垩系沉积为主的陆相断陷区。采用条件分析法,对贝尔凹陷的油气运聚条件及其成藏的基本模式进行了系统研究,认为,贝尔凹陷在剖面上有3套成藏组合,其中中部成藏组合最佳;在平面上可分为5个运聚系统,其中以位于凹陷西北部的3个系统为最佳。该凹陷不同构造部位的运聚条件相差较大,生烃洼陷深部位的油气运移以砂岩储集层和断裂为主要输导通道,构造高部位的油气运移以断裂为主,而两者之间的油气输导则以不整合面和断裂为主。在油气运聚和成藏模式分析的基础上,认为贝尔凹陷油气运聚的有利条件主要包括生油凹陷有充足的油源、生油区内有继承性发育的圈闭构造以及各运聚要素间存在良好的时空配置关系3个方面。     

生命线地震工程的研究进展

以我国、美国和日本的研究成果为依据，综述了生命线地震工程的研究概况、研究对象、震后恢复过程优化以及抗震防灾对策的新趋势。     

河南及邻区地震前中小地震活跃-平静的定量指标研究

以累计频度定量计算方法，分区讨论了河南及邻区1970年以来地震活动非线性度ZL值的时间进程曲线，系统计算了M≥5．0级地震前的ZL值，结果表明：开始出现活跃(平静)异常的时间集中在地震前1—2年，结束异常的时间在地震前一年内，集中于0—4个月。同时提出了异常的定量指标以及发震类型。     

Effect of asymmetry and irregularity of seismic waves on earthquake-induced differential settlement of buildings on natural subsoil

The effect of asymmetry and irregularity of the inputted seismic waves on the earthquake-induced differential settlement of the buildings on natural subsoil is investigated in terms of the earthquake damage phenomena, theoretical analyses, dynamic triaxial tests and shaking table tests. A conclusion can be drawn from the investigation results that, the asymmetrical and irregular character of the inputted seismic waves themselves may have a significant contribution to the differential settlement of subsoil and buildings in some cases, and this is a necessary factor to be considered in reasonable evaluation for the differential settlement and other problems relating to the soil deformation due to earthquakes.     

Drainage in finite-sized unsaturated zones

After the initiation of gravity drainage, water is often assumed to be either (a) draining under unit gradient, or (b) at capillary/gravity equilibrium. Both of these simplifications can be useful, but the regimes of validity of each assumption must be delineated. Water pressures are measured versus time and distance as water drains out of a 1.6 m long sand column to determine the relative effects of capillary and gravitational forces during drainage. For medium sized sands (0.15–0.3 mm in diameter), the capillary pressure is constant in space in a large region of the column for over 12 days, and the water continues to flow under unit gradient for relatively long time scales. Similar results are seen for finer sands, but with a much faster approach to equilibrium. Numerical simulations and analytical estimates are presented and compare favorably to the measurements. Together, the experimental, theoretical and analytical results are used to calculate when capillary/gravity equilibrium is reached as a function of porous media properties and length of the unsaturated zone. The ratio of the length of the unsaturated zone to the bubbling pressure is a key parameter in determining the drainage regime, and that even for relatively short unsaturated zones the equilibrium time scale can be on the order of years.     

The importance of plant root characteristics in controlling concentrated flow erosion rates

While it has been demonstrated in numerous studies that the aboveground characteristics of the vegetation are of particular importance with respect to soil erosion control, this study argues the importance of separating the influence of vegetation on soil erosion rates into two parts: the impact of leaves and stems (aboveground biomass) and the influence of roots (belowground biomass). Although both plant parameters form inseparable constituents of the total plant organism, most studies attribute the impact of vegetation on soil erosion rates mainly to the characteristics of the aboveground biomass. This triggers the question whether the belowground biomass is of no or negligible importance with respect to soil erosion by concentrated flow. This study tried to answer this question by comparing cross‐sectional areas of concentrated flow channels (rills and ephemeral gullies) in the Belgian Loess Belt for different cereal and grass plant densities. The results of these measurements highlighted the fact that both an increase in shoot density as well as an increase in root density resulted in an exponential decrease of concentrated flow erosion rates. Since protection of the soil surface in the early plant growth stages is crucial with respect to the reduction of water erosion rates, increasing the plant root density in the topsoil could be a viable erosion control strategy. Copyright © 2003 John Wiley & Sons, Ltd.     

Mechanisms of riverbank failure along the Arno River,central Italy

Riverbanks along the Arno River have been investigated with the aims of de?ning the main mechanisms of failure and retreat, their spatial distribution, and their causes. Geomorphological aspects were investigated by a reconnaissance of riverbank processes, for a number (26) of representative sites. Laboratory and in situ tests were then performed on a selected number of riverbanks (15). Based on the material characteristics, six main typologies of riverbanks have been de?ned, with homogeneous ?ne‐grained and composite banks representing the most frequent types. Slab‐type failures are the most frequent mechanism observed on ?ne‐grained banks, while cantilever failures prevail on composite banks. The role of river stage and related pore water pressure distributions in triggering the main observed mechanisms of failure has been investigated using two different types of stability analysis. The ?rst was conducted for 15 riverbanks, using the limit equilibrium method and considering simpli?ed hypotheses for pore water pressure distribution (annulment of negative pore pressures in the portion of the bank between low water stage and peak stage). Stability conditions and predicted mechanisms of failure are shown to be in reasonably good agreement with ?eld observations. Three riverbanks, representative of the main alluvial reaches of the river, were then selected for a more detailed bank stability analysis, consisting of: (a) de?nition of characteristic hydrographs of the reach with different return periods; (b) modelling of saturated and unsaturated ?ow using ?nite element seepage analysis; and (c) stability analysis with the limit equilibrium method, by adopting pore water pressure values derived from the seepage analysis. The results are compared to those obtained from the previous simpli?ed analysis, and are used to investigate the different responses, in terms of stability, to different hydrological and riverbank conditions. Copyright © 2003 John Wiley & Sons, Ltd.     

Atomistic simulation of the structure and elastic properties of pyrite (FeS2) as a function of pressure

Interatomic potential parameters have been derived at simulated temperatures of 0 K and 300 K to model pyrite FeS₂. The predicted pyrite structures are within 1% of those determined experimentally, while the calculated bulk modulus is within 7%. The model is also able to simulate the properties of marcasite, even though no data for this phase were included in the fitting procedure. There is almost no difference in results obtained for pyrite using the two potential sets; however, when used to model FeS₂ marcasite, the potential fitted at 0 K performs better. The potentials have also been used to study the high-pressure behaviour of pyrite up to 44 GPa. The calculated equation of state gives good agreement with experiment and shows that the Fe–S bonds shorten more rapidly that the S–S dimer bonds. The behaviour of marcasite at high pressure is found to be similar to that of pyrite.