Implications of Kali-Hindon inter-stream aquifer water balance for groundwater management in western Uttar Pradesh

The Kali-Hindon inter-stream region extends over an area of 395 km² within the Ganga-Yamuna interfluve. It is a fertile tract for sugarcane cultivation. Groundwater is a primary resource for irrigation and industrial purposes. In recent years, over-exploitation has resulted in an adverse impact on the groundwater regime. In this study, an attempt has been made to calculate a water balance for the Kali-Hindon inter-stream region. Various inflows and outflows to and from the aquifer have been calculated. The recharge due to rainfall and other recharge parameters such as horizontal inflow, irrigation return flow and canal seepage were also evaluated. Groundwater withdrawals, evaporation from the water table, discharge from the aquifer to rivers and horizontal subsurface outflows were also estimated. The results show that total recharge into the system is 148.72 million cubic metres (Mcum), whereas the total discharge is 161.06 Mcum, leaving a deficit balance of −12.34 Mcum. Similarly, the groundwater balance was evaluated for the successive four years. The result shows that the groundwater balance is highly sensitive to variation in rainfall followed by draft through pumpage. The depths to water level are shallow in the canal-irrigated northern part of the basin and deeper in the southern part. The pre-monsoon and post-monsoon water levels range from 4.6 to 17.7 m below ground level (bgl) and from 3.5 to 16.5 m bgl respectively. It is concluded that the groundwater may be pumped in the canal-irrigated northern part, while withdrawals may be restricted to the southern portion of the basin, where intense abstraction has led to rapidly falling water table levels.     

土壤中氟的形态分析

以宁夏盐池地区高氟土壤为例,采用连续提取法对土壤样品中各形态氟进行提取,离子色谱法测定各形态氟的含量。根据研究目的及土壤特点将氟的形态划分为水溶态、离子交换态、可还原态、可氧化态及残渣态5种形态;对各种形态连续提取过程中使用的提取液进行了选择。采用建立的方法获得提取土壤中F-的检出限为0.76μg/g;方法精密度(RSD,n=7)各形态氟为水溶态氟11.3%,离子交换态氟13.5%,可还原态氟10.7%,可氧化态氟8.9%。     

Use of sinkhole and specific capacity distributions to assess vertical gradients in a karst aquifer

The carbonate-rock aquifer in the Great Valley, West Virginia, USA, was evaluated using a database of 687 sinkholes and 350 specific capacity tests to assess structural, lithologic, and topographic influences on the groundwater flow system. The enhanced permeability of the aquifer is characterized in part by the many sinkholes, springs, and solutionally enlarged fractures throughout the valley. Yet, vertical components of subsurface flow in this highly heterogeneous aquifer are currently not well understood. To address this problem, this study examines the apparent relation between geologic features of the aquifer and two spatial indices of enhanced permeability attributed to aquifer karstification: (1) the distribution of sinkholes and (2) the occurrence of wells with relatively high specific capacity. Statistical results indicate that sinkholes (funnel and collapse) occur primarily along cleavage and bedding planes parallel to subparallel to strike where lateral or downward vertical gradients are highest. Conversely, high specific capacity values are common along prominent joints perpendicular or oblique to strike. The similarity of the latter distribution to that of springs suggests these fractures are areas of upward-convergent flow. These differences between sinkhole and high specific capacity distributions suggest vertical flow components are primarily controlled by the orientation of geologic structure and associated subsurface fracturing.     

A modified DRASTIC model for Siting Confined Animal Feeding Operations in Williams County,Ohio, USA

Three of DRASTIC’s parameters (Depth to Water, Soil Media, and Topography) were modified and another parameter was added (land use/land cover) to the model to determine the potential impact on groundwater from Confined Animal Feeding Operations (CAFO) manure lagoon settings and manure application as fertilizer. Williams County is a mostly agricultural county located in northwest Ohio, USA. It currently has three CAFOs, all dairy, with the possibility of the construction of a multi-million chicken egg CAFO in the near future. A Geographic Information System (GIS) was utilized to modify the Ohio Department of Natural Resources (ODNR) DRASTIC map for the county to fully assess the county-wide pollution potential of CAFOs. The CAFO DRASTIC map indicates that almost half of Williams County has elevated groundwater pollution potential. The rest of the county, primarily the southeast corner, has lower CAFO groundwater pollution potential. Future CAFO development within the county should focus on the southeastern portion of the county where the groundwater table is deeper, and the aquifer is composed of shale substrate with low hydraulic conductivity. The CAFO DRASTIC results are intended to be used as a screening tool and are not to replace site-specific hydrogeologic investigations.     

Potential for localized groundwater contamination in a porous pavement parking lot setting in Rhode Island

The control of polluted surface runoff and the assessment of possible impacts on groundwater is a concern at the local and regional scale. On this background, a study investigates possible impacts of organic and inorganic pollutants (including bacteria) originating from a permeable asphalt parking lot on the water quality immediately beneath it. The functioning of the permeable pavement, including clogging and restricted vertical percolation, was also evaluated. Four nested sample ports (shallow and deep) were installed below low- and high-traffic areas, including one port outside the parking lot. At least initially there was a good hydraulic connection between the parking surface and the shallow sample ports. The presence of a geotextile layer at the base of the parking lot structure, however, was identified in lab tests as one factor restricting vertical percolation to the deeper ports. Clogging of the permeable surface was most pronounced in heavy traffic areas and below snow pile storage areas. Corroborated by high electric conductivity and chloride measurements, sand brought in by cars during winter was the principal cause for clogging. No bacteria or BOD were found in percolating water. Polycyclic aromatic hydrocarbons (PAH) were present at concentrations near minimum detection limit. Nutrients (nitrate and phosphate) were being leached into the ground via the permeable parking lot surface at annual flux rates of 0.45–0.84 g/m²/year. A multi-species tracer test demonstrated a retention capacity of the permeable parking lot structure of >90% for metals and 27% for nutrients, respectively.     

Environmental contamination of Zn,Cd, Ni,Cu, and Pb from industrial areas in Hamadan Province,western Iran

Eleven surface soil samples from calcareous soils of industrial areas in Hamadan Province, western Iran were analyzed for total concentrations of Zn, Cd, Ni, Cu and Pb and were sequentially extracted into six fractions to determine the bioavailability of various heavy metal forms. Total Zn, Cd, Ni, Cu and Pb concentrations of the contaminated soils were 658 (57–5,803), 125.8 (1.18–1,361), 45.6 (30.7–64.4), 29.7 (11.7–83.5) and 2,419 (66–24,850) mg kg⁻¹, respectively. The soils were polluted with Zn, Pb, and Cu to some extent and heavily polluted with Cd. Nickel values were not above regulatory limits. Copper existed in soil mainly in residual (RES) and organic (OM) fractions (about 42 and 33%, respectively), whereas Zn occurred essentially as RES fraction (about 69%). The considerable presence of Cd (30.8%) and Pb (39%) in the CARB fraction suggests these elements have high potential biavailability and leachability in soils from contaminated soils. The mobile and bioavailable (EXCH and CARB) fractions of Zn, Cd, Ni, Cu, and Pb in contaminated soils averaged (7.3, 40.4, 16, 12.9 and 40.8%), respectively, which suggests that the mobility and bioavailability of the five metals probably decline in the following order: Cd = Pb > Ni > Cu > Zn.     

The relationship between hydrodynamic properties and weathering of soils derived from volcanic rocks,Galapagos Islands (Ecuador)

The aim of this interdisciplinary study is to examine a component of the hydrological cycle in Galapagos by characterizing soil properties. Nine soil profiles were sampled on two islands. Their physical and hydrodynamic properties were analyzed, along with their mineralogical composition. Two groups of soils were identified, with major differences between them. The first group consists of soils located in the highlands (>350 m a.s.l.), characterized by low hydraulic conductivity (<10⁻⁵ m s⁻¹) and low porosity (<25%). These soils are thick (several meters) and homogeneous without coarse components. Their clay fraction is considerable and dominated by gibbsite. The second group includes soils located in the low parts of the islands (<300 m a.s.l.). These soils are characterized by high hydraulic conductivity (>10⁻³ m s⁻¹) and high porosity (>35%). The structure of these soils is heterogeneous and includes coarse materials. The physical properties of the soils are in good agreement with the variations of the rainfall according to the elevation, which appears as the main factor controlling the soil development. The clayey alteration products constrain soils physical and hydrodynamic properties by reducing the porosity and consequently the permeability and also by increasing water retention.     

Evaluation of approaches to calculate debris-flow parameters for hazard assessment

Many different runout prediction methods can be applied to estimate the mobility of future debris flows during hazard assessment. The present article reviews the empirical, analytical, simple flow routing and numerical techniques. All these techniques were applied to back-calculate a debris flow, which occurred in 1982 at La Guingueta catchment, in the Eastern Pyrenees. A sensitivity analysis of input parameters was carried out, while special attention was paid to the influence of rheological parameters. We used the Voellmy fluid rheology for our analytical and numerical modelling, since this flow resistance law coincided best with field observations. The simulation results indicated that the “basal” friction coefficients rather affect the runout distance, while the “turbulence” terms mainly influence flow velocity. A comparison of the velocity computed on the fan showed that the analytical model calculated values similar to the numerical ones. The values of our rheological parameters calibrated at La Guingueta agree with data back-calculated for other debris flows. Empirical relationships represent another method to estimate total runout distance. The results confirmed that they contain an important uncertainty and they are strictly valid only for the conditions, which were the basis for their development. With regards to the simple flow routing algorithm, this methods could satisfactorily simulate the total area affected by the 1982 debris flow, but it was not able to directly calculate total runout distance and velocity. Finally, a suggestion on how different runout prediction methods can be applied to generate debris-flow hazard maps is presented. Taking into account the definition of hazard and intensity, the best choice would be to divide the resulting hazard maps into two types: “final hazard maps” and “preliminary hazard maps”. Only the use of numerical models provided final hazard maps, because they could incorporate different event magnitudes and they supplied output-values for intensity calculation. In contrast, empirical relationships and flow routing algorithms, or a combination of both, could be applied to create preliminary hazard maps. The present study only focussed on runout prediction methods. Other necessary tasks to complete the hazard assessment can be looked up in the “Guidelines for landslide susceptibility, hazard and risk zoning” included in this Special Issue.     

Low-pressure,water-assisted anatexis of basic dykes in a contact metamorphic aureole,Fuerteventura (Canary Islands): oxygen isotope evidence for a meteoric fluid origin

Migmatites produced by low-pressure anatexis of basic dykes are found in a contact metamorphic aureole around a pyroxenite–gabbro intrusion (PX2), on Fuerteventura. Dykes outside and inside the aureole record interaction with meteoric water, with low or negative δ¹⁸O whole-rock values (+0.2 to −3.4‰), decreasing towards the contact. Recrystallised plagioclase, diopside, biotite and oxides, from within the aureole, show a similar evolution with lowest δ¹⁸O values (−2.8, −4.2, −4.4 and −7.6‰, respectively) in the migmatite zone, close to the intrusion. Relict clinopyroxene phenocrysts preserved in all dykes, retain typically magmatic δ¹⁸O values up to the anatectic zone, where the values are lower and more heterogeneous. Low δ¹⁸O values, decreasing towards the intrusion, can be ascribed to the advection of meteoric water during magma emplacement, with increasing fluid/rock ratios (higher dyke intensities towards the intrusion acting as fluid-pathways) and higher temperatures promoting increasing exchange during recrystallisation. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Assessment of disaster resilience capacity of hillslope communities with high risk for geological hazards

This study presents a novel preparedness assessment method for assessing hazard mitigation and environmental planning of hillslope communities. A professional questionnaire was utilized to weight each indicator. Communities in Hsinchu, Taichung and Nantou counties with debris flow hazards were taken as study samples. Debris flow risk and landslide susceptibility for each community were determined using Geographic Information System (GIS) technology and logistic regression analysis. Thus, a novel risk assessment method for evaluating disaster resilience capacity of hillslope communities was established. This method was then applied to assess casualties caused by Typhoon Herb in 1996 and Typhoon Mindulle in 2004. Additionally, the analytical results generated by this assessment method were discussed with the aim of developing references for implementation of risk analysis, increasing the effectiveness of disaster mitigation, and reducing future loss of life and property.