静力触探中土层界面效应试验研究

根据成层土模型试验结果,对静力触探中土层面效应进行试验研究和机理分析,取得了成层土界面效应的规律性,为利用静力触探划分土层提供了理论和实践依据。     

软土大变形固结计算中参数识别的遗传算法

含水量很高的饱和软土在外荷载作用下沉降很大,小变形分析误差太大,必须通过大变形非线性固结计算来模拟。遗传算法是一种全局优化和搜索的仿生算法。近年来随着工程领域中复杂的大规模非线性系统的出现,遗传算法日益得到青睐,目前已经广泛应用到各个领域中。本文对遗传算法做了改进,主要体现在杂交算子的选取和轮盘赌模型的模拟退火拉伸,并将其用于饱和软土的大变形固结分析,解决其中的关键参数识别问题。研究表明该方法是行之有效的,值得进一步研究探索。     

论上海软土地基⑦⑧⑨层压缩模量Es的定值问题

上海地区深部土层⑦⑧⑨层埋深在30～70m。对其压缩模量Es的定值问题,现行《上海市地基基础设计规范》(DGJ08 11 1999)(后文中简称《规范》)长期以来确定室内试验E0 1～0 2值为沉降计算值,导致沉降计算值与建(构)筑物实际沉降量之间相差2～8倍。为符合规范的变形要求,设计人员不得不采取桩加粗、加长、加密的办法,从而造成桩基投资的极大浪费。为了正确认识深部土层的Es值,上海岩土工程界进行了多种形式的试验研究。近年来,笔者结合上海高、大、深、重建(构)筑物的工程实践,深入进行上海深部⑦⑧⑨层压缩模量Es的试验研究,获得许多新的认识,对其定值问题作了研究,提出⑦⑧⑨层的建议值,供同行参考研讨。     

Measuring the k–S–p relations on DNAPLs migration

Migration characteristics of dense non-aqueous phase liquids (DNAPLs) in the subsurface can be expressed as a water–DNAPL two-phase system based on mainly the k–S–p relations, which describe the relations among relative permeability (k), degree of water saturation (S), and capillary pressure head (p). The aims of this research are to develop an experimental system with new type of probes, such as the electrical conductivity probe for measuring the degree of water saturation and the hydrophilic and hydrophobic tensiometer for measuring the pore water and DNAPL pressures, and also to estimate the results obtained from the developed experimental system. From these tests, the excellent k–S–p relations were obtained and the efficiency and validity of this developed experimental system have been confirmed in terms of the concept of the scaling coefficient calculated by interfacial tensions.     

Compression mechanisms of coesite

 The structure of coesite has been determined at ten pressures up to a maximum of 8.68 GPa by single-crystal X-ray diffraction. The dominant mechanism of compression is the reduction of four of the five independent Si–O–Si angles within the structure. There is no evidence of the fifth linkage, Si1–O1–Si1, deviating from 180°. Some Si–O bond distances also decrease by up to 1.6% over the pressure range studied. The pattern of Si–O–Si angle reduction amounts to a rotation of the Si2 tetrahedron around the [001] direction. This rotation induces significant internal deformation of the Si1 tetrahedron. Comparison of the experimental data with rigid-unit distance least-squares simulations of coesite suggests that this pattern of compression, the anomalous positive values of both s₂₃ and K′′ in the equation of state of coesite, its high elastic anisotropy and the unusual straight Si1–O1–Si1 linkage within the structure are all consequences of the connectivity of the tetrahedral framework. Received: 11 July 2002 / Accepted: 14 January 2003 Acknowledgements The help of Christian Baerlocher of ETH Zurich in providing both the DLS-76 software and advice in its use is gratefully acknowledged, as are discussions with Paul Ribbe of Virginia Tech and the comments of two anonymous reviewers. The data analysis was supported by the National Science Foundation under grant EAR-0105864 to N.L. Ross and R.J. Angel.     

Atomistic simulation of the structure and elastic properties of pyrite (FeS2) as a function of pressure

Interatomic potential parameters have been derived at simulated temperatures of 0 K and 300 K to model pyrite FeS₂. The predicted pyrite structures are within 1% of those determined experimentally, while the calculated bulk modulus is within 7%. The model is also able to simulate the properties of marcasite, even though no data for this phase were included in the fitting procedure. There is almost no difference in results obtained for pyrite using the two potential sets; however, when used to model FeS₂ marcasite, the potential fitted at 0 K performs better. The potentials have also been used to study the high-pressure behaviour of pyrite up to 44 GPa. The calculated equation of state gives good agreement with experiment and shows that the Fe–S bonds shorten more rapidly that the S–S dimer bonds. The behaviour of marcasite at high pressure is found to be similar to that of pyrite.     

盐渍土与分散性针孔试验影响

通过具体实例,研究了新疆氯盐渍、硫酸盐渍土对针孔试验的影响,认为氯盐渍土因其胶结作用,随着盐量的增加,土样孔径大小、流量变化不大。硫酸盐渍土因其膨胀性,随着盐量的增加,土样孔径、流量减小,对土样的冲蚀破坏作用而不相同。     

MODELING STUDY ON SEDIMENTATION CONFIGURATION IN FRONT OF THE DAM AND IN THE PRESSURE CONDUIT OF BOTTOM OUTLETS BY FLUME EXPERIMENT

I.INTRODUCTIONReseri,oirsonoverloadedriverswillreachthestateofrelativeequilibriumwithcontinuousdevelopmentofsedimentation.Insuchcase,thereisdePOsitinfrontofthedam.Thereforethesiltpressureonthedambodyisconsiderablylarge.Sedimentationelevationinfrontofthedamisoneofthefactorsofcalculatingthesiltpressure.Inaddition,tokeeplong-termworkingstorageinreservoif,itisnecessarytoinstallbottomoutlets.Asthereisapressureconduitinfrontoftheoperatinggateofthebottomoutlet,thesedimelltenteredtheconduitwill…     

我国特殊岩土研究

本文分析，总结了我国特殊岩土理论与应用研究方面的新进展，内容涉及湿陷性黄土，软土膨胀岩土，红土，软岩和特殊土的结构性，指出需要进一步研究的问题，最后对特殊土的研究方法做了阐述。     

Utilization of lime,slag and fly ash for improvement of a colluvial soil in New South Wales,Australia

In Australia, colluvial soils form large terrains which are often subjected to considerable erosion and mass movement. This study presents a laboratory evaluation of the improvement effected by hydrated lime, milled blast furnace slag and fly ash on a fine grained (erosive) colluvial soil in New South Wales, Australia. Geotechnical tests were conducted to determine the compaction and consolidation characteristics and the compressive and shear strength properties of the blended and natural soil specimens. The effect of these additives on the Atterberg limits and pH levels is also investigated. As large amounts of fly ash and steel slag are produced in New South Wales, it is economically attractive to utilize these industrial by-products for ground improvement rather than employing conventional methods such as lime treatment. This study demonstrates that for the colluvial soil tested, milled slag is the most effective in terms of improving the internal friction angle of the treated soil, while lime is the most suitable for achieving the optimum compressive strength. Non-pozzolanic fly ash is found to be inappropriate as a soil improving agent. The cost of ground treatment using the various additives is also estimated and compared.