Effect of slow-solvent-vapour treatment on performance of polymer photovoltaic devices

In this work, enhanced poly(3-hexylthiophene):[6,6]-phenyl-C61-butyric acid methyl ester (P3HT:PCBM) bulk-heterojunction photovoltaic devices are achieved via slow-solvent-vapour treatment. The correlations between the morphology of the active layer and the photovoltaic performance of polymer-based solar cell are investigated. The active layers are characterized by atomic force microscopy and optical absorption. The results show that slow-solvent-vapour treatment can induce P3HT self-organization into an ordered structure, leading to the enhanced absorption and efficient charge transport.     

淤泥质地基海塘与水闸不均匀沉降控制措施优化研究

多年的调查与研究表明,建于淤泥质地基上的水闸与海塘等水工建筑物常常因海塘与水闸连接部位产生过大的差异沉降,影响水闸的正常使用,甚至造成连接部位完全破环。在海塘与水闸之间构建连接段则可以有效减小两者过大的差异沉降,进而减小差异沉降对建筑物的不利影响,但单纯设置连接段对于控制过大差异沉降效果极其有限。论文以浙东沿海某海堤围垦工程为背景,基于有限差分数值模拟软件（FLAC3D）,模拟了海塘堆载及流固耦合过程,并考虑通过调节连接段水泥搅拌桩的桩径、桩长及桩间距的连续变化对地基处理措施进行优化,计算出了不同优化措施下水闸与海塘的差异沉降。计算结果表明：基于连接段地基桩桩长的连续变化,再通过调节桩间距的大小可以很大程度控制海塘与水闸之间的差异沉降。     

海洋工程中桩基水平向承载力可靠指标的影响因素分析

桩基础水平向承载力的计算是海洋工程中桩基设计的重要组成部分。论文在搜集了大量平台建设资料的基础上,以现有的桩基水平向承载力的设计计算方法为依据,进行了水平向承载力的可靠度研究。对影响可靠指标的各个因素进行了灵敏度分析。     

Equilibrium erosion of soft rock shores with a shallow or absent beach under increased sea level rise

A process-based numerical model was used to explore the response of soft rock shores with low volume beaches to variable rates of sea level rise. Equilibrium recession rates were simulated for ranges of wave height and period, tidal amplitude, rock strength, beach volume and rate of sea level rise. Equilibrium shore profiles were found to be steeper with higher rates of sea level rise. Beaches were represented as protective surfaces yet were found to cause no significant reduction in equilibrium recession rate when their volumes were below a critical threshold. Reduced equilibrium recession rates were found with beaches that extended sufficiently far below low tide level. The model results imply that, given several constraints, a very simple relationship exists between increased rates of sea level rise and the response of eroding composite soft rock/low volume beach shores.     

大型储油罐基础非均匀沉降的有限元分析研究

以中石化仪征15万m3大型浮顶储油罐工程为例,研究了砂石褥垫层对大型储油罐基础的差异沉降的影响。根据行业标准《建筑地基处理技术规范》(JGJ79—2012)沉降公式计算以及有限元模拟计算,并结合现场实测数据,验证了有限元模拟分析的可行性,在此基础上进行了环墙内砂石垫层厚度及长度对差异沉降影响的扩展研究,为以后的类似工程项目设计施工提供了借鉴。     

PVDF管式超滤膜在低渗油田水处理中的研究及应用——以江苏台兴油田为例

根据低渗油田和特低渗油田的特点,研制出PVDF管式超滤膜,开展室内基础研究,并在江苏台兴油田进行中试和大规模的现场试验。经过处理后,水质标准达到油田回注水A1标准（SY／T5329-1994）,满足了低渗油田和特低渗油田的注水要求。     

Experimental investigation of the vertical pullout cyclic response of bucket foundations in sand

A series of 1 g model tests was conducted to investigate the accumulated vertical pullout displacement and unloading stiffness of bucket foundations embedded in dry and saturated sands. The foundations were subjected to vertical pullout cyclic loading with different load amplitudes. Cyclic load was applied up to 10⁴ cycles. Test results showed that the accumulated vertical pullout displacement increased with the increase in the number of load cycles and cyclic load amplitudes. The unloading stiffness of the bucket foundations decreased with the increase in load amplitude and number of cycles. Empirical equations were proposed based on the test results to evaluate the accumulated vertical pullout displacement and unloading stiffness of the bucket foundations in saturated sand. These equations can be used for the preliminary design of single or tripod bucket foundations.     

基于多体分析的浅水FPSO和水下软钢臂系泊系统运动特性研究

基于多体动力分析方法进行FPSO和水下软钢臂系泊系统的运动特性研究。相较于非线性弹簧模拟软钢臂系泊系统或者其他近似模拟方法,多体分析方法可以充分考虑系泊系统具体结构形式及其动力项对FPSO运动性能的影响,更好的预报系统运动响应和系泊力。本文将FPSO和水下钢臂结构模拟成2个具有6自由度的独立结构,两者用系泊链组进行连接。基于三维势流理论应用汇源分布法,首先在频域内进行FPSO的水动力参数分析,进而在时域内对系统进行耦合动力分析。本文重点讨论系泊系统黏性力和二阶波浪力对系统响应的影响,计算结果发现系泊系统黏性力对系泊力有一定影响,而在浅水条件下二阶波浪力的计算对准确预报系统运动及系泊力非常重要。     

不同软基处理方法适用性比较

总结分析了国内外现有的软土地基处理的各种方法。通过对采用不同方法进行软基处理的工程实例处理效果的定量对比，发现不同软基处理方法的适用性差异很大，多数工程中仅用一种方法很难达到设计要求，而两种或多种方法联合则可望取得更好的效果。     

A new efficient 3D non-hydrostatic free-surface flow model for simulating water wave motions

A new three-dimensional, non-hydrostatic free surface flow model is presented. For simulating water wave motions over uneven bottoms, the model employs an explicit project method on a Cartesian the staggered gird system to solve the complete three-dimensional Navier–Stokes equations. A bi-conjugated gradient method with a pre-conditioning procedure is used to solve the resulting matrix system. The model is capable of resolving non-hydrostatic pressure by incorporating the integral method of the top-layer pressure treatment, and predicting wave propagation and interaction over irregular bottom by including a partial bottom-cell treatment. Four examples of surface wave propagation are used to demonstrate the capability of the model. Using a small of vertical layers (e.g. 2–3 layers), it is shown that the model could effectively and accurately resolve wave shoaling, non-linearity, dispersion, fission, refraction, and diffraction phenomena.