The Mw = 6.0, 7 September 1999 Athens Earthquake

On 7 September 1999 at 11:56 GMT a destructive earthquake (M_w = 6.0) occurred close to Athens (Greece). The rupture process is examined using data from the Cornet local permanent network, as well as teleseismic recordings. Data recorded by a temporary seismological network were analyzed to study the aftershock sequence. The mainshock was relocated at 38.105°N, 23.565°E, about 20 km northwest of Athens. Four foreshocks were also relocated close to the mainshock. The modeling of teleseismic P and SH waves provides a well-constrained focal mechanism of the mainshock (strike = 105°, dip = 55° and rake = -80°) at a depth of 8 km and a seismic moment M₀ = 1.010²⁵ dyn·cm. The obtained fault plane solution represents normal faulting indicating an almost north-south extension. More than 3500 aftershocks were located, 1813 of which present RMS < 0.1 s and ERH, ERZ < 1.0 km. Two main clusters were distinguished, while the depth distribution is concentrated between 2 and 11 km. Over 1000 fault plane solutions of aftershocks were constrained, the majority of which also correspond to N–S extension. No surface breaks were observed but the fault plane solution of the mainshock is in agreement with the tectonics of the area and with the focal mechanisms obtained by aftershocks. The hypocenter of the mainshock is located on the deep western edge of the fault plane. The relocated epicenter coincides with the fringe that represents the highest deformation observed on the differential interferometric image. The calculated source duration is 5 sec, while the estimated dimensions of the fault are 15 km length and 10 km width. The source process is characterized by unilateral eastward rupture propagation, towards the city of Athens. An evident stop phase observed in the recordings of the Cornet local stations is interpreted as a barrier caused by the Aegaleo Mountain.     

Fitness-for-Purpose of Reference Material Reference Values in Relation to Traceability of Measurement, as Illustrated by USGS BCR-1, NIST SRM 610 and IAEA NBS28

As in all fields of sample analysis, reference materials play a large role in supporting measurements in the geosciences. While a rather large number of materials are in distribution (> 380), not all are equally effective or fit-for-purpose in supporting laboratory data quality and thereby assuring the desired comparability of measurements between laboratories. Equally important, reference values that are not fit-for-purpose cannot be used effectively to establish traceability links between laboratory measurements and national and international standards. The needed fitness-for-purpose is not achieved for reference values either when more than one reference value has been proposed and a consensus does not exist among users as to which should be used by all, or when reference value uncertainties are too large in comparison to those of routine laboratory measurements. The focus of this review will be, first to outline the current reality, and second to suggest ways in which certifications of RMs can be improved to provide reference values that are universally accepted and more fit-for-purpose in general laboratory use. The discussion will be illustrated largely by current uses of USGS BCR-1, NIST SRM 610 and IAEA NBS28, as these three materials are those for which the largest body of newly published data exists, according to recent bibliographies of the geoanalytical literature published annually in Geostandards Newsletter: The Journal of Geostandards and Geoanalysis.     

Preparation of a New Geological Survey of Japan Geochemical Reference Material: Coral JCp-1

A new geochemical reference material, coral Porites sp. JCp-1 has been prepared by the Geological Survey of Japan (GSJ). Provisional values for twenty one major, minor and trace elements are presented. The homogeneity tests showed that all elements studied are considered to be homogeneously distributed.     

圆弧状沉积盆地与软土单覆盖层出平面地表运动对比

采用解析方法，通过圆弧状沉积盆地与同样参数的软土均匀单覆盖层的对比，研究沉积盆地对平面SH波二维散射效应和其出平面地表运动。数值对比结果表明：（1）波垂直入射时盆地中央地表位移幅值反应，其随频率变化形式与软土单覆盖层的地表运动有较强的对应性，且此时单覆盖层地表位移幅值为其下降；（2）盆地的二维散射效应特点显著波的汇聚作用使盆地中的地表运动显著放大，总体上较软土单覆盖层的地表位移幅值要大，其频域内的最大反应则明显大于单覆盖层情况，但最大反应在盆地表面出现的位置依赖于入射波角度、盆地深宽比和盆地的软硬程度；（3）沉积盆地中地表位移运动有强烈扭转效应，且随盆地变软和入射波频率增高而增强。     

Chemical equilibria of thermal waters for the application of geothermometers from the Guanzhong basin, China

In this study, representative samples from thermal wells and springs were chemically analyzed and geothermometers were used to calculate the deep temperatures of geothermal reservoirs on the basis of water–mineral equilibrium. In some cases, however, the chemical components are not in equilibrium with the minerals in the reservoir. Therefore, log(Q/K) diagrams are used to study the chemical equilibrium for the minerals that are likely to participate. The Na–K–Mg triangular diagram is also applied to evaluate the equilibrium of water with reservoir rocks. Standard curves at the reference temperatures are prepared to reveal which type of silica geothermometer is appropriate for the specified condition. This study shows that water samples from geothermal wells W9 and W12 are in equilibrium with the selective minerals, and chalcedony may control the fluid–silica equilibrium. It is estimated that there is an exploitable low-temperature reservoir with possible temperatures of 80–90°C in the Guanzhong basin.     

大开间小型混凝土砌块10层模型房屋抗震性能试验研究(Ⅰ)

我国抗震设计规范（GB50011－2001）规定在6、7、8度区，混凝土小砌块结构分别可以建七、六、五层。由于混凝土小砌块结构的最大优势在于10－20层（与混凝土框架或框架剪力墙结构比）。本文按1／4比例制作了10层混凝土小砌块结构模型，按7度设防要求实施构造措施，通过振动台试验研究模型结构的抗震性能。结果表明，模型结构完全能够满足在7度区“小震不坏，大震不倒”的要求。圈梁、构造柱以及水平拉结筋构成的约束体系抗震作用是明显的。试验利用砌块的非注芯孔灌注铁砂来模拟墙体出平面动力效应。在本模型的构造措施下，平出面反应不对结构破坏起控制作用。     

国际地磁参考场在我国地磁基础研究中的应用

国际地磁参考场资料在我国得到广泛应用。利用国际地磁参考场资料，我国学者研究了高斯分析、地球磁场模型及其源场可能位置、重磁关系、核幔耦合、地磁场能量、地球非偶极子磁场西向漂移等。在绘制中国地磁等值图中也利用了某些国际地磁参考场资料。     

充电激发极化法在金属矿上的应用

充电激发极化法是矿山物探的一种主要方法，其兼有充电法与激发极化法的特点，可利用已有的工程，最大限度地了解地下三度空间地球物理场的分布情况，解决地质问题。概述了其理论基础和方法技术，并列举了该方法在多个金属矿上的应用实例。