往复流中双向导向叶冲动透平模型性能试验研究

研制了 30 0双向自调导叶透平试验机组 ,安装在 10 0 0活塞式往复流透平试验台上 ,对两种叶轮方案和 6种不同喷咀、扩压器进行了不同活塞行程、不同周期和不同恒定输出电压下性能试验。试验结果表明在喷咀出口角α1=2 1 5°、扩压器入口角α2 =6 5 5°和α1=2 4°、α2 =6 3°组合最佳 ,最高效率达 5 3 3% ,而且在宽广流量系数范围内 ,特别是大流量系数范围内都有较高效率。大大优于常用对称翼透平。将上下游导叶固定 ,变成双向固定导叶透平。用No 1叶轮和 6种导叶出口角组合进行试验。表明最佳导叶出口角为 2 4°～ 30°,最高效率仍达 38 5 % ,比对称翼透平仍高许多     

GPS单频精密单点定位方法与实践

讨论了单频精密单点定位的解算方法与思路,编写了单频精密动态单点定位的程序,实现了事后动态单频精密单点定位.     

基于动态检测平台的GPS接收机动态性能检测研究

介绍了一种新型动态检测平台,设计了GPS动态差分试验和双动态差分试验,分析了GPS动态单点定位、动态差分测量、双动态差分测量在两种不同速度条件下进行了的试验数据.     

垦71区块井间地震资料处理研究与应用

由于避开了地表低降速带和风化层的影响,井间地震能够采集到高频地震信号,经过资料处理可以得到较高分辨率的速度和上行反射波成像剖面。2004～2005年,胜利油田在垦71 区块实施了8对井间地震资料采集。针对原始资料特点,研究了以层析成像、管波衰减、VSP-CDP技术和有限角度叠加成像等关键处理技术,较好地完成了该区块的井间地震资料处理。初步分析解释表明,井间地震可以识别低序级断层、小幅度构造和薄储层。     

Normative quartz as an indicator of the mass transfer intensity during the postmagmatic alteration of the Botuobinskaya pipe kimberlites (Yakutia)

The intensity of postmagmatic processes in the Botuobinskaya pipe kimberlites was estimated from the calculated content of normative secondary quartz (Q). Several simple algorithms are proposed to calculate the Q content from chemical analyses of kimberlites. Ten groups of altered kimberlites have been recognized from the Q contents. The contents of MgO, some trace elements, and LREE in the groups, the contents of Cr and Ca of crimson garnets, the diamond contents of kimberlites, and the average weight of diamonds decrease as the Q content increases. It is shown that the negative SiO₂–MgO correlation is the most effective indicator of the postmagmatic alteration of kimberlites. As the degree of their secondary alteration increases, the kimberlites transform into an assemblage of quartz and clay minerals enriched in some trace elements and almost completely lacking REE and diamonds.     

U-Pb Age Determination for Seven Standard Zircons using Inductively Coupled Plasma–Mass Spectrometry Coupled with Frequency Quintupled Nd-YAG (λ = 213 nm) Laser Ablation System: Comparison with LA-ICP-MS Zircon Analyses with a NIST Glass Reference Material

This paper evaluates the analytical precision, accuracy and long‐term reliability of the U‐Pb age data obtained using inductively coupled plasma–mass spectrometry (ICP‐MS) with a frequency quintupled Nd‐YAG (λ = 213nm) laser ablation system. The U‐Pb age data for seven standard zircons of various ages, from 28 Ma to 2400 Ma (FCT, SL13, 91500, AS3, FC1, QGNG and PMA7) were obtained with an ablation pit size of 30 μm diameter. For ²⁰⁷Pb/²⁰⁶Pb ratio measurement, the mean isotopic ratio obtained on National Institute of Standards and Technology (NIST) SRM610 over 4 months was 0.9105 ± 0.0014 (n = 280, 95% confidence), which agrees well with the published value of 0.9096. The time‐profile of Pb/U ratios during single spot ablation showed no significant difference in shape from NIST SRM610 and 91500 zircon standards. These results encouraged the use of the glass standard as a calibration standard for the Pb/U ratio determination for zircons with shorter wavelength (λ = 213 nm) laser ablation. But ²⁰⁶Pb/²³⁸U and ²⁰⁷Pb/²³⁵U ages obtained by this method for seven zircon standards are systematically younger than the published U‐Pb ages obtained by both isotope dilution–thermal ionization mass spectrometry (ID‐TIMS) and sensitive high‐resolution ion‐microprobe (SHRIMP). Greater discrepancies (3–4% younger ages) were found for the ²⁰⁶Pb/²³⁸U ages for SL13, AS3 and 91500 zircons. The origin of the differences could be heterogeneity in Pb/U ratio on SRM610 between the different disks, but a matrix effect accuracy either in the ICP ion source or in the ablation‐transport processes of the sample aerosols cannot be neglected. When the ²⁰⁶Pb/²³⁸U (= 0.2302) newly defined in the present study is used, the measured ²⁰⁶Pb/²³⁸U and ²⁰⁷Pb/²³⁵U ages for the seven zircon standards are in good agreement with those from ID‐TIMS and SHRIMP within ±2%. This suggests that SRM610 glass standard is suitable for ICP‐MS with laser ablation sampling (LA‐ICP‐MS) zircon analysis, but it is necessary to determine the correction factor for ²⁰⁶Pb/²³⁸U by measuring several zircon standards in individual laboratories.     

Composition-Induced Variations in SIMS Instrumental Mass Fractionation during Boron Isotope Ratio Measurements of Silicate Glasses

An analytical artefact is reported here related to differences in instrumental mass fractionation between NIST SRM glasses and natural geological glasses during SIMS boron isotope determinations. The data presented demonstrated an average 3.4‰ difference between the NIST glasses and natural basaltic to rhyolitic glasses mainly in terms of their sputtering-induced fractionation of boron isotopes. As no matrix effect was found among basaltic to rhyolitic glasses, instrumental mass fractionation of most natural glass samples can be corrected by using appropriate glass reference materials. In order to confirm the existence of the compositionally induced variations in boron SIMS instrumental mass bias, the observed offset in SIMS instrumental mass bias has been independently reproduced in two laboratories and the phenomenon has been found to be stable over a period of more than one year. This study highlights the need for a close match between the chemical composition of the reference material and the samples being investigated.     

Rock magnetic record of Cenozoic lake sediments from the Linxia basin and aridification of the Asian inland

High resolution research of rock magnetic records and quartz sands from the Maogou Section in the Linxia basin reveals that after a relatively stable environment between 13.07 Ma and 8.6 Ma, the basin was gradually influxed by eolian dusts at about 8.6 Ma, with two rapid increases at about 6.4 Ma and 5.3 Ma, respectively. The study suggests that drying of northwest China began at 8.6 Ma and strengthened rapidly at about 6.4 Ma and 5.3 Ma. __________ Translated from Marine geology & Quaternary geology, 2007, 27(4): 103–110 [译自: 海洋地质与第四纪地质]     

倒Y形竖井联系测量

介绍在小直径竖井联系测量中取消联系三角形,改用单根钢丝定点,全站仪引测高程的施测方法。     

等截面单桩抗拔承载性状试验研究

在基坑中对等截面单桩进行了抗拔静载试验，在桩身设置应变式钢筋计，成功测得桩身各截面的应变数据。分析试验所得数据，对试验抗拔桩抗拔系数的取值、侧摩阻力的发挥、混凝土桩身的开裂等进行了探讨，相应给出了抗拔桩的设计建议。