福建沿海边缘陆域的原地应力测量研究

通过在福建沿海边缘陆域地区活动断裂带附近进行水压致裂原地应力测量, 得到了地表浅部构造应力的大小、方向和分布特征. 根据实测的地应力资料,用库仑摩擦滑动准则分析研究了断裂带的性质和活动性. 结果表明：① 沿海岸线边缘自北向南,其最大水平主压应力方向为北西向,与测区北西向断裂带走向近于平行,与地质构造、跨断层形变测量等方法反映的主压应力方向大体一致,与震源机制解反映的主压应力方向夹角20deg;左右; ② 水平主应力值随深度增加而增大,与垂直应力值的关系为SHSVSh和SHasymp;SV Sh, 应力状态有利于走滑断层和正断层活动;③ 利用库仑摩擦滑动准则,摩擦强度取0.6～1.0分析, 断层附近的现今地应力状态达到或超过产生正断层摩擦滑动的临界值,表明测区现今构造活动以正断层为主; ④ 反映出本区现今构造应力场的力源主要来自太平洋板块向西和菲律宾板块向北西对欧亚板块的水平挤压作用.     

大陆岩石圈塑性流动网络的延性弱面效应

岩石圈下层的网状塑性流动 ,作为包含塑性流动网络的黏塑性流动 ,控制着大陆板块内部的构造变形和动力学过程。塑性流动网络由两组网带共轭相交而成 ,而塑性流动网带是黏塑性流动过程中因剪切局部化、黏性摩擦生热和网带介质的弱化而形成的延性弱面 (弱带 )。研究表明 ,类似于断裂和节理等脆性弱面 ,延性弱面对介质强度的影响也具有条件性 ,即当应力方向改变时 ,只有在滑移角θ不超出一定限值的条件 (θ1≤θ≤θ2 )下才可能沿原有弱面滑移 ,显示其弱化效应 ;延性弱面可以用弱化度R表示其屈服限的相对降低程度 ,弱化度与滑移角下限值之间的关系为R =sin2θ1;根据亚洲中东部地区“塑性流动 -地震”网络的最大共轭角推算 ,网带的弱化度R近似于 0 81。基于延性弱面效应的认识 ,文中就网带由剪切滑移向压性褶皱的转化、网带的继承与弃置以及应力方向的允许偏角等问题进行了探讨     

Bedload transport resistance in rough open‐channel flows

During bedload movement by saltation, streamwise momentum is transferred from the ?ow to the saltating grains. When the grains collide with other grains on the bed or in the ?ow, streamwise momentum is reduced, and there is a decrease in streamwise ?ow velocity and an increase in ?ow resistance, herein termed bedload transport resistance f_bt. Based on experiments in two ?umes with ?xed and mobile plane beds and previously published data, an equation is developed that may be used to predict f_bt for both capacity and non‐capacity ?ows. The variables in this equation are identi?ed by dimensional analysis and the coef?cients are determined by non‐linear regression. This equation applies to rough turbulent open‐channel ?ows, where the relative submergence is between 1 and 20 and the entire sediment load moves by saltation. An investigation of the relative magnitudes of f_bt and grain resistance f_c suggests that where dimensionless shear stress θ is less than 1 and saltation is the dominant mode of bedload transport, f_bt/f_c increases with θ but never exceeds 1. Copyright © 2004 John Wiley & Sons, Ltd.     

Seismic isolation analysis of FPS bearings in spatial lattice shell structures

<正>A theoretical model of a friction pendulum system(FPS) is introduced to examine its application for the seismic isolation of spatial lattice shell structures.An equation of motion of the lattice shell with FPS bearings is developed.Then, seismic isolation studies are performed for both double-layer and single-layer lattice shell structures under different seismic input and design parameters of the FPS.The influence of frictional coefficients and radius of the FPS on seismic performance are discussed.Based on the study,some suggestions for seismic isolation design of lattice shells with FPS bearings are given and conclusions are made which could be helpful in the application of FPS.     

REPRESENTATIONS OF COULOMB FRICTION FOR DYNAMIC ANALYSIS

In many engineering problems involving friction, the friction is treated as Coulomb friction, where the magnitude of the friction force is constant but its direction is always opposite to that of the sliding velocity. In dynamic problems, the direction of the sliding velocity can change quite often. The many changes of the velocity direction cause many discontinuities in the friction force, complicating the process of evaluating the response of systems involving friction. In this paper, it is shown that the discontinuous Coulomb friction force can be represented by at least four different continuous functions. Each of these functions involves one constant that controls the level of accuracy of that function's representation of the friction force. The accuracy of the various representations is verified by comparing the response of a single degree freedom system, obtained through numerical solutions utilizing these representations, with an exact analytical solution. © 1997 by John Wiley & Sons, Ltd.     

基于不同摩擦系数水平的滑移隔震体系的相对输入能量与绝对输入能量的差异性分析

定义了能量变化率指标,以简谐激励作用下的滑移隔震结构为例,探讨了摩擦系数对滑移隔震结构能量变化率指标的影响,通过对这些能量指标的研究,分析了系统的相对输入能量和绝对输入能量的差异性随摩擦系数的变化规律,为后续研究提供理论依据。     

Physics of basic motions in asymmetric continuum

We consider the advantages of a formalism based on concept of the asymmetric continuum and we present some equivalence theorems relating it to the asymmetric elasticity and to micropolar and micromorphic theories as founded by Nowacki, Cosserats and Eringen. We consider the basic processes in an asymmetric continuum which could be reduced to the point basic motions/deformations. The co-action of spin and shear motions is assumed to play the main role in fracturing process, while the constitutive relation between the antisymmetric stresses and rotations replaces the friction constitutive law.     

Damping characteristics of friction damped braced frame and its effectiveness in the mega-sub controlled structure system

Based on energy dissipation and structural control principle, a new structural configuration, called the mega- sub controlled structure (MSCS) with friction damped braces (FDBs), is first presented. Meanwhile, to calculate the damping coefficient in the slipping state a new analytical method is proposed. The damping characteristics of one-storey friction damped braced frame (FDBF) are investigated, and the influence of the structural parameters on the energy dissipation and the practical engineering design are discussed. The nonlinear dynamic equations and the analytical model of the MSCS with FDBs are established. Three building structures with different structural configurations, which were designed with reference to the conventional mega-sub structures such as used in Tokyo City Hall, are comparatively investigated. The results illustrate that the structure presented in the paper has excellent dynamic properties and satisfactory control effectiveness.     

摩擦耗能器的类型与性能及其在实际工程中的应用

摩擦耗能器是一种构造简单、耗能机理明确、耗能能力大且性能稳定的耗能减震装置,在实际工程中已得到较为广泛的应用.主要介绍不同类型摩擦耗能器的构造与性能及其在实际工程中的应用,并提出了摩擦耗能器在开发与应用中需进一步研究解决的问题.