关于修改港工钢筋混凝土规范小偏心受压构件正截面强度计算的建议

本文提出在小偏心受压构件正截面强度计算中，取消弯曲抗压强度ｆｃｍ（Ｒｗ），采用轴心抗压强度ｆｃ，这与构件的实际破坏形态相符。对小偏心受压构件正截面强度计算提出了设计建议。特别是对工程上大量应用的矩形截面对称配筋小偏压构件提示了简捷的设计方法，与以往的近似计算方法相比具有物理概念明确，精度高，方法简捷的特点。     

Seasonal DOC accumulation in the Black Sea: a regional explanation for a general mechanism

During three cruises in the Black Sea, organised in July 1995 and April–May 1997, biological and chemical parameters that can influence the carbon budget were measured in the water column on the NW shelf, particularly in the mixing zone with Danube River waters. We observed in early spring (end of April–May) conditions an important input of freshwater organisms that enhanced the microbial activity in the low salinity range. High bacterial activity regenerates nitrogen in the form of nitrates, but is also responsible for an important consumption of ammonium and phosphate, leading to a high N/P ratio and a strong deficit in phosphorus. The consequence is a limitation of phytoplankton development but also a production of carbohydrates that accumulate all along the salinity gradient. These mechanisms are responsible for a seasonal accumulation of dissolved organic carbon (DOC) that increases from 210 μM in winter to about 280 μM in summer. All this excess DOC disappears during winter, probably degraded by bacterial activity. The degradation of carbon-rich organic matter increases the phosphorus demand by bacteria bringing limitation to phytoplankton primary production.     

Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

Numerical study of enhanced energy dissipation near a seamount

Using a two-dimensional primitive equation model, we examine nonlinear responses of a semidiurnal tidal flow impinging on a seamount with a background Garrett-Munk-like (GM-like) internal wavefield. It is found that horizontally elongated pancake-like structures of high vertical wavenumber near-inertial current shear are created both in the near-field (the region over the slope of the seamount) and far-field (the region over the flat bottom of the ocean). An important distinction is that the high vertical wavenumber near-inertial current shear is amplified only at mid-latitudes in the far-field (owing to a parametric subharmonic instability (PSI)), whereas it is amplified both at mid-and high-latitudes (above the latitude where PSI can occur) in the near-field. In order to clarify the generating mechanism for the strong shear in the near-field, additional numerical experiments are carried out with the GM-like background internal waves removed. The experiments show that the strong shear is also created, indicating that it is not caused by the interaction between the background GM-like internal waves and the semidiurnal internal tides. One possible explanation is proposed for the amplification of high vertical wavenumber near-inertial current shear in the near-field where tide residual flow resulting from tide-topography interaction plays an important role in transferring energy from high-mode internal tides to near-inertial internal waves.     

鲁苏榴辉岩的地球化学

以微量元素、稀土元素、Ｓｒ和Ｎｄ同位素变异特征为依据，确定鲁苏榴辉岩为多成因、多来源和多阶段，指出主要是在印支期扬子陆块与华北陆块碰撞造山作用过程中，挤入的上地幔碎片以及不同原岩类型的壳内高压变质岩碎块。燕山晚期的区域构造热事件使得某些榴辉岩的同位素体系再平衡。     

辽东湾S2冰侧限剪切强度的试验研究

利用试验方法系统地研究了辽东湾S2型海冰侧限剪切强度随剪切应变速率、加载方向、法向应力、温度和冰内孔隙率的变化规律。介绍了S2型海冰各向异性特点及剪切应变速率对剪切破坏方式的效应和韧脆破坏转变的条件。分析了不同加载方向海冰峰值剪切强度的差异 ,获得 - 6 2℃温度下S2冰内摩擦角和内聚力分别为 42°和 70 0kPa。利用统计分析给出峰值剪切强度与冰温和孔隙率的试验关系     

Gradation affects basic mechanical characteristics of Chinese calcareous sand as airport subgrade of reefs

Abstract

Construction of the reefs in the South China Sea is a significant foundation to the secure stability and economic development of China. The construction of an airport runway is necessary for this realization. The calcareous sand is the main primary material in the runway construction. A certain type of calcareous sand near a certain reef of the South China Sea was studied in this paper. To investigate this specific calcareous sand, quartz sand was used as a reference for comparison. Microscopic 3-D imaging, compression and triaxial tests were conducted to test the micro, squeezing and shear properties. The effect mechanism of gradation on the calcareous sand’s compressibility and shear characteristics are discussed from a mesoscopic viewpoint using 3-D morphology. Calcareous sand particles are multiangular and flatter in comparison with quartz sand. The larger the particle sizes are, the more different the two sands’ morphologies are. The compressibility of calcareous sand is greater, and the effect of the coarse fraction (5–1?mm) content in the gradation plays the most significant role in this feature. When the coarse particles’ content is less than 25% and the mass ratio of the middle and fine particles (M) is constant, there is the worst coarse fraction content causing the calcareous sand to be most likely compressed. The worst coarse fraction content decreases with the increase in M, and an empirical formula is proposed. When the gradation, relative density and confining pressure are the same, the peak shear stress and strain of calcareous sand are all at a high level. The effect of confining pressure is manifested in calcareous sand. The shear strength and dilation of calcareous sand are also most affected by the medium coarse fraction (5–0.25?mm) content.     

A Sensitivity Analysis of the Waterline Method of Constructing a Digital Elevation Model for Intertidal Areas in ERS SAR scene of Eastern England

A sensitivity analysis of the waterline method of constructing a Digital Elevation Model (DEM) of an intertidal zone using remote sensing and hydrodynamic modelling is described. Variation in vertical height accuracy as a function of beach slope is investigated using a set of nine ERS Synthetic Aperture Radar (SAR) images of the Humber/Wash area on the English east coast acquired between 1992 and 1994. Waterlines from these images are heighted using a hydrodynamic tide-surge model and interpolated using block kriging. On 1:500 slope beaches, an average block height estimation standard deviation of 18–22 cm is achieved. This rises to 27 cm on 1:100 slope beaches, and 32 cm on 1:30 slope beaches. The average heighting error at different slopes is decomposed into components due to waterline heighting error, inadequate sensor resolution and interpolation inaccuracy. It is shown that, at 1:500 slope, waterline heighting error and interpolation inaccuracy are the main error sources, whilst at 1:30 slope, errors due to inadequate sensor resolution become dominant. The ability of the technique to generate intertidal DEMs for almost the entire coastal zone in a complete ERS SAR scene covering 100×100 km is demonstrated.     

A Preliminary Study of Shear Wave in Seafloor Surface Sediments

This article preliminarily reports and analyses the transmission characteristics and behaviors of shear wave in the offshore seafloor surface sediments in China, discusses the relationships between the physical and mechanical features of the shear wave and the compression wave, and compares the testing results with that of Hamilton and Chen et al. The result shows that the shear wave can be tested if the seafloor surface sediment has tangent modulus. The shear wave velocity ranges from 50-600 m/s and the measuring frequency from 50-200 kHz. The sound velocity rate of shear wave and compression wave can be used to appraise the stress-strain feature of seafloor surface sediments. This study provides a basis for further describing and appraising the seafloor sedimentary acoustic-mechanical feature and building a geological-acoustic model on China's offshore sea area.     

Factors influencing the oxidation,reduction, methylation and demethylation of mercury species in coastal waters

The objective of this study was to examine the redox reactions and other transformations of mercury (Hg) species in surface waters, and the factors determining the rates of these reactions. For the redox studies completed at the Chesapeake Biological Laboratory (CBL), two isotopes (¹⁹⁹Hg^II and ²⁰²Hg⁰) were added into different types of filtered water (fresh to seawater) to examine the oxidation and reduction reactions. Further studies of both the redox reactions and methylation/demethylation reactions of Hg were conducted with unfiltered water on board research vessels during cruises in May and July 2005 on the Chesapeake Bay and shelf. While CH₃¹⁹⁹Hg^II was added to allow the examination of demethylation, ²⁰¹Hg^II was used to examine both reduction and methylation, and ²⁰²Hg⁰ was used to examine oxidation. Overall, the results showed that both Hg oxidation and reduction were simultaneously occurring and were photochemically mediated in the waters investigated. In contrast to the previously assumed “unreactive” nature of Hg⁰, the studies found that the magnitude of the rate constant for Hg⁰ oxidation was greater than that for reduction, indicating its importance in estuarine and coastal waters. In addition, both experiments at CBL and on board ship showed that Hg^II reduction was similar in magnitude, suggesting that biotic processes were relatively unimportant. While no measurable methylation occurred during the incubation period during the on board studies, concentration of CH₃¹⁹⁹Hg^II decreased over the time during the experiments. It appeared that the demethylation processes were not dominantly photochemically driven, but could be microbially mediated. Further studies are needed in order to help better understand Hg redox and transformations in natural water systems.