城市建设中的地震小区划与浅层地震探测

简要阐述地震小区划在现代城市建设中的重要性以及在实施地震小区划的研究中浅层地震探测的重要作用及其方法原理,并给出应用浅层地震探测在城市地震小区划中的实例。     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

Neural network for wave forecasting among multi-stations

Unlike in the open sea, the use of wind information for forecasting waves may encounter more ambiguous uncertainties in the coastal or harbor area due to the influence of complicated geometric configurations. Thus this paper attempts to forecast the waves based on learning the characteristics of observed waves, rather than the use of the wind information. This is reported in this paper by the application of the artificial neural network (ANN), in which the back-propagation algorithm is employed in the learning process for obtaining the desired results. This model evaluated the interconnection weights among multi-stations based on the previous short-term data, from which a time series of waves at a station can be generated for forecasting or data supplement based on using the neighbor stations data. Field data are used for testing the applicability of the ANN model. The results show that the ANN model performs well for both wave forecasting and data supplement when using a short-term observed wave data.     

地震勘探在不同地质条件下的新应用

20世纪末，地震勘探技术在油气勘探、煤田勘探、工程勘探等多方面的应用都有了突飞猛进的发展。总结了近年来地震勘探在岩性、沉积相、构造体系等不同地质条件下的应用实例，用以说明地震勘探的多用性及其强大的生命力。     

1999年以来台湾及邻近海域7.5级以上强震前的条带现象

中国台湾地区地处欧亚板块与菲律宾海板块之间,地震活动频繁．本文报道了 我国台湾地区及其邻近海域1985～2002年间5．5级以上地震的条带内外频度比分 布,并着重研究了1999—2002年中发生的3次7．5级以上地震前的条带现象．其结 果表明:台湾地区近期发生的3次7．5级以上大地震前,5．5级以上地震呈条带分 布．这些条带符合条带内地震个数Nin≥6的条件,符合条带内、外频度比Nin／(Nin Nout)≥75％的条件,也符合条带长宽比大于5的要求,只是与板内地震条带相比,条 带的长度较短．     

地层学的发展推动油气地质理论研究的进步

自上个世纪50年代以来,地层学经历了彻底的变革,逐渐由“相模式”、“沉积体系”、“地震地层学”发展到目前的“层序地层学”,形成高分辨率层序地层学和事件地层学的理论体系和研究方法。文章围绕层序地层学、高分辨率层序地层学基本方法及理论体系,与含油气系统相关关系进行了讨论。     

Crustal Structures of the Northernmost South China Sea: Seismic Reflection and Gravity Modeling

The South China Sea (SCS) is a marginal sea off shore Southeast Asia. Based on magnetic study, oceanic crust has been suggested in the northernmost SCS. However, the crustal structure of the northernmost SCS was poorly known. To elaborate the crustal structures in the northernmost SCS and off southwest Taiwan, we have analyzed 20 multi-channel seismic profiles of the region. We have also performed gravity modeling to understand the Moho depth variation. The volcanic basement deepens southeastwards while the Moho depth shoals southeastwards. Except for the continental margin, the northernmost SCS can be divided into three tectonic regions: the disturbed and undisturbed oceanic crust (8–12 km thick) in the southwest, a trapped oceanic crust (8 km thick) between the Luzon-Ryukyu Transform Plate Boundary (LRTPB) and Formosa Canyon, and the area to the north of the Formosa Canyon which has the thickest sediments. Instead of faulting, the sediments across the LRTPB have only displayed differential subsidence offset of about 0.5–1 s in the northeast side, indicating that the LRTPB is no longer active. The gravity modeling has shown a relatively thin crust beneath the LRTPB, demonstrating the sheared zone character along the LRTPB. However, probably because of post-spreading volcanism, only the transtension-shearing phenomenon of volcanic basement in the northwest and southeast ends of the LRTPB can be observed. These two basement-fractured sites coincide with low gravity anomalies. Intensive erosion has prevailed over the whole channel of the Formosa Canyon.     

An Application of Direct Ritz Method for Random Seismic Responses of Jacket Platforms

1 .IntroductionNowadays tremendous efforts have been devotedtothe analysis of randomseismic responses .Forexample ,American PetroleumInstitute (API) has declared that the analysis of randomseismic re-sponsesis a useful tool for safety inspection. Owing to the complexity of platformand randomness ofload,it is difficult to carry out the randomresponse analysis of a jacket platform. The conventionalrandomvibration methods ,such as square root of the sumof squares (SRSS) and complete quadratic…     

1994年发生在台湾海峡的一次地震海啸的数值模拟

建立了一个地震海啸数值模式,模式包含越洋海啸传播部分和近岸海啸变形部分,在越洋海啸传播部分中采用线性浅水方程,使用蛙跃格式求解,并且选择合适的空间步长与时间步长,使差分格式中产生的数值频散与包辛尼斯克方程中的物理频散一致,这样在不影响海啸数值计算精度的前提下,节省了计算机的机时与内存.在近岸海啸变形部分的计算中,考虑了非线性对流项与海底摩擦项.同时该模式采用了多重网格嵌套技术,提高了所关心地区的计算精度.利用这个地震海啸模式模拟了1994年发生在台湾海峡的一次地震海啸,结果与观测记录较吻合.这个模型已用于我国沿海核电站可能最大地震海啸的数值计算.