内蒙古二连浩特市—东乌珠穆沁旗半干旱荒漠草原区区域化探方法试验

内蒙古二连浩特市-东乌珠穆沁旗地区属半干旱荒漠草原区.1∶20万区域化探扫面应针对该类景观区微景观特点,选择土壤或水系沉积物测量方法开展工作.经试验确定采样粒级为-5～ 20目;采样密度2个点/km2;采样介质为残坡积物或冲、洪积物.经4个1∶20万图幅的区域化探扫面工作,取得了明显的异常圈定和地质找矿效果,方法技术有效.     

降雨条件下岩土饱和-非饱和渗流分析

基于Buckley-Leverett两相渗流方程,提出了新的岩土饱和-非饱和渗流数学模型,利用有限差分方法给出了隐式压力显示饱和度数值求解方法,编制了饱和-非饱和渗流计算程序.结合工程实例,模拟了降雨入渗条件下边坡岩体渗流场孔隙压力变化和含水饱和度变化,模拟结果验证了所提出的模型对饱和-非饱和渗流的有效性.     

Kinetic-simulating experiment combined with GC-IRMS analysis: application to identification and assessment of coal-derived methane from Zhongba Gas Field (Sichuan Basin, China)

The main purpose of this study is to model the δ¹³C values of methane derived from coal by combining kinetic-simulating experiment with the gas chromatography-isotope ratio mass spectrum (GC-IRMS) analysis. The stable carbon isotopic variation of methane in pyrolysates with heating temperature indicates that the assumptions for both a constant kinetic isotope effect (α) and a uniform initial isotopic composition (δ¹³C_o) are impractical for explaining the carbon isotopic fractionation during coalification. For purposes of simplification, two approaches are used in this paper to deal with the heterogeneity of terrestrial organic matter. One is that, assuming a uniform initial isotopic composition (i.e., δ¹³C_{i, o}=δ¹³C_o) for all methane-generating precursors in coal, the isotopic variation of methane is fitted by adjusting ΔE_{a, i} (E_{a¹³C, i}−E_{a¹²C, i}) for each hypothetical reaction. The other is that, assuming a constant kinetic isotope effect during the whole gas formation, that is all ΔE_{a, i} values are identical, the modeling of methane isotopic composition is achieved by changing the ¹³CH₄ generation potential of each reaction (f_{i, ¹³C}), namely, by adjusting the initial δ¹³C value (δ¹³C_{i, o}) for each methane-generating precursor. Results of the kinetic calculation shows that the two simulating methods can yield a similar result at a geological heating rate of 2 °C/My, which further demonstrates that those natural gases with methane δ¹³C value being approximately −36‰ are possibly sourced from the upper Triassic coal measure strata in the Northwestern Sichuan Basin.     

Biomineralization of Uranium: A Simulated Experiment and Its Significance

A simulated experimental reduction of U^v1 and the synthesis of uraninite by a sulfate-reducing bacteria,Desulfovibrio desulfuricans DSM 642, are first reported. The simulated physicochemical experimental conditions were:35℃, pH=7.0-7.4, corresponding to the environments of formation of the sandstone-hosted interlayer oxidation-zone type uranium deposits in Xinjiang, NW China. Uraninite was formed on the surface of the host bacteria after a one-week‘s incubation. Therefore, sulfate-reducing bacteria, which existed extensively in Jurassic sandstone-producing environments,might have participated in the biomineralization of this uranium deposit. There is an important difference in the orderdisorder of the crystalline structure between the uraninite produced by Desulfovibrio desulfuricans and naturally occurring uraninite. Long time and slow precipitation and growth of uraninite in the geological environment might have resulted in larger uraninite crystals, with uraninite nanocrystals arranged in order, whereas the experimentally produced uraninite is composed of unordered uraninite nanocrystals which, in contrast, result from the short time span of formation and rapid precipitation and growth of uraninite. The discovery has important implications for understanding genetic significance in mineralogy, and also indicates that in-situ bioremediation of U-contaminated environments and use of biotechnology in the treatment of radioactive liquid waste is being contemplated.     

Transport rate of calcareous sand in unidirectional flow

This paper examines the transport of calcareous sand in unidirectional flow and its prediction through existing sediment transport models. A flume experiment of four sand samples collected on Oahu, Hawaii, provides 29 sets of sediment transport data in the bed-form and suspended transport stages. The measured transport data are compared with direct predictions from four energy-based transport models developed for siliceous particles. Corrections for the grain-size, fall velocity, and critical velocity of calcareous sand based on recent research are applied to the models and the results are compared with the direct calculations and measured data. The comparison illustrates the important role particle shape plays in the transport of calcareous sand. All four sediment transport models give consistent predictions and good agreement with the majority of the measured data. Two of the models respond positively to the corrections in both the bed-form and suspended transport stages indicating that such an approach may provide an interim solution for the transport of calcareous sand.     

基坑防渗体局部失效渗流场变化特征

采用三维有限元方法分析了基坑开挖工程在防渗体出现局部失效情况下，引起渗流在失效部位的集中及渗流场空间状况。提出了以一维通道嵌入三维块体的方法模拟管涌发展过程及渗流场变化特征。讨论了管涌通道渗透性对基坑管涌发展规律的影响。     

Transient seepage analysis in zoned anisotropic soils based on the scaled boundary finite‐element method

The scaled boundary finite‐element method, a semi‐analytical computational scheme primarily developed for dynamic stiffness of unbounded domains, is applied to the analysis of unsteady seepage flow problems. This method is based on the finite‐element technology and gains the advantages of the boundary element method as well. Only boundary of the domain is discretized, no fundamental solution is required and singularity problems can be modeled rigorously. Anisotropic and non‐homogeneous materials satisfying similarity are modeled with no additional efforts. In this study, firstly, formulation of the method for the transient seepage flow problems is derived followed by its solution procedures. The accuracy, simplicity and applicability of the method are demonstrated via four numerical examples of transient seepage flow – three of them are available in the literature. Homogenous, non‐homogenous, isotropic and anisotropic material properties are considered to show the versatility of the technique. Excellent agreement with the finite‐element method is observed. The method out‐performs the finite‐element method in modeling singularity points. Copyright © 2014 John Wiley & Sons, Ltd.     

Influence of a coarse interlayer on seawater intrusion and contaminant migration in coastal aquifers

Vertical 2D slice laboratory experiments were carried out in homogenous and layered sand tanks to elucidate the effects of a highly permeable (coarse‐grained sand) interlayer on seawater intrusion and transport of contaminants to a coastal sea. Tidal fluctuations produced oscillations in the seawater–freshwater transition zone, fluctuations of the contaminant infiltration rate and a zigzag contaminant plume outline. The seawater wedge became discontinuous at the (vertical) edges of the interlayer because of increased lateral movement of the seawater–freshwater interface within the interlayer. The contaminant plume formed a tail within the interlayer depending on the tidal stage, and similar to the wedge, its movement was accentuated. A simple analytical model that neglected vertical flow reliably predicted steady‐state seawater intrusion into the coastal aquifer. Numerical modeling was used to gain insight into the groundwater hydrodynamics and contaminant migration. The numerical results confirmed the experimental findings, i.e. that a highly permeable interlayer can provide a rapid transit path for contaminants to reach the seaward boundary and that the interlayer amplifies the effects of tidal fluctuations, resulting in wider transition zones for the seawater wedge and contaminant plume. Numerical simulations further showed that, with increasing interlayer hydraulic conductivity, the maximum seawater intrusion distance inside the interlayer increases approximately linearly. For the fixed‐head contaminant injection condition used, the model showed that contaminant infiltration increases approximately logarithmically with increasing interlayer hydraulic conductivity (other factors held fixed). Copyright © 2013 John Wiley & Sons, Ltd.     

Hydrological cycle and water balance estimates for the megadune–lake region of the Badain Jaran Desert,China

The hydrology and water balance of megadunes and lakes have been investigated in the Badain Jaran Desert of China. Field observations and analyses of sand layer water content, field capacity, secondary salt content, and grain size reveal 3 types of important natural phenomenon: (a) vegetation bands on the leeward slope of the megadunes reflect the hydrological regime within the sandy vadose zone; (b) seepage, wet sand deposits, and secondary salt deposits indicate the pattern of water movement within the sandy vadose zone; (c) zones of groundwater seeps and descending springs around the lakes reflect the influence of the local topography on the hydrological regime of the megadunes. The seepage exposed on the sloping surface of the megadunes and gravity water contained within the sand layer confirm the occurrence of preferential flow within the vadose zone of the megadunes. Alternating layers of coarse and fine sand create the conditions for the formation of preferential flows. The preferential flows promote movement of water within the sand layer water that leads to deep penetration of water within the megadunes and ultimately to the recharging of groundwater and lake water. Our results indicate that a positive water balance promotes recharge of the megadunes, which depends on the high permeability of the megadune material, the shallow depth of the surface sand layer affected by evaporation, the occurrence of rainfall events exceeding 15 mm, and the sparse vegetation cover. Water balance estimates indicate that the annual water storage of the megadunes is about 7.5 mm, accounting for only 8% of annual precipitation; however, the shallow groundwater per unit area under the megadunes receives only 3.6% of annual precipitation, but it is still able to maintain a dynamic balance of the lake water. From a water budget perspective, the annual water storage in the megadunes is sufficient to serve as a recharge source for lake water, thereby enabling the long‐term persistence of the lakes. Overall, our findings demonstrate that precipitation is a significant component of the hydrological cycle in arid deserts.     

Autogenic avulsion,channelization and backfilling dynamics of debris‐flow fans

Alluvial fans develop their semi‐conical shape by quasi‐cyclic avulsions of their geomorphologically active sector from a fixed fan apex. On debris‐flow fans, these quasi‐cyclic avulsions are poorly understood, partly because physical scale experiments on the formation of fans have been limited largely to turbidite and fluvial fans and deltas. In this study, debris‐flow fans were experimentally created under constant extrinsic forcing, and autogenic sequences of backfilling, avulsion and channelization were observed. Backfilling, avulsion and channelization were gradual processes that required multiple successive debris‐flow events. Debris flows avulsed along preferential flow paths given by the balance between steepest descent and flow inertia. In the channelization phase, debris flows became progressively longer and narrower because momentum increasingly focused on the flow front as flow narrowed, resulting in longer run‐out and deeper channels. Backfilling commenced when debris flows reached their maximum possible length and channel depth, as defined by channel slope and debris‐flow volume and composition, after which they progressively shortened and widened until the entire channel was filled and avulsion was initiated. The terminus of deposition moved upstream because the frontal lobe deposits of previous debris flows created a low‐gradient zone forcing deposition. Consequently, the next debris flow was shorter which led to more in‐channel sedimentation, causing more overbank flow in the next debris flow and resulting in reduced momentum to the flow front and shorter runout. This topographic feedback is similar to the interaction between flow and mouth bars forcing backfilling and transitions from channelized to sheet flow in turbidite and fluvial fans and deltas. Debris‐flow avulsion cycles are governed by the same large‐scale topographic compensation that drives avulsion cycles on fluvial and turbidite fans, although the detailed processes are unique to debris‐flow fans. This novel result provides a basis for modelling of debris‐flow fans with applications in hazards and stratigraphy.