Palaeovariations in the East-Asian Monsoon Regime Geochemically Recorded in Varved Sediments of Lake Sihailongwan (Northeast China, Jilin Province). Part 1: Hydrological Conditions and Dust Flux

The varved sediments of the dimictic Lake Sihailongwan (Long Gang mountain area, Jilin Province, Northeast China) represent a palaeoclimatic archive which documents the local precipitation frequency during the summer monsoon, and variations in the aeolian flux of dust with their remote sources in the arid and semi-arid regions of inner Asia. Based on a detailed discussion of sediment genesis in Lake SHL, dust flux rates and palaeohydrological conditions were reconstructed on a decadal scale over the past 220 years. The aeolian influx by dry and wet deposition was quantified and characterised in its chemical composition. Photosynthetic production in the lake is positively correlated with the inflow of nutrient-rich groundwater. The groundwater discharge largely reflects the strength of the summer monsoon. Net accumulation rates for biogenic silica were determined for annually laminated sediments from the centre of the U-shaped lake basin based on sediment data. In a Si-balance model of the modern lake, the depositional flux of biogenic silica could be independently quantified on the base of hydrochemical monitoring data. Comparison of the both estimates allowed to asses the focussing of the particle flux in the lake. Though water retention in Lake SHL is rather high (ca. 30 years), changes in the hydrological conditions are sensitively recorded in the sediments because (i) nutrient-rich groundwater discharges into the productive zone of the lake, (ii) a substantial proportion of the total dissolved Si-inventory of the mixed lake (ca. 30%) is annually consumed by diatom growth, and (3) sediment accumulation is substantially focussed towards the flat bottom of the lake basin. The bulk siliciclastic sediment fraction (ca. 75 wt.%) largely originates from influx of dust of remote provenance. In sediment thin-sections, the dry-deposited dust fraction is microscopically identifiable as seasonal silt layer. Aeolian input by wet-deposition shows a distinctly higher variability than the influx of dust by dry-deposition. As diatom production, wet-deposition of dust is positively correlated with the rainfall during the summer monsoon. The inferred positive correlation between rainfall and dust flux during the summer monsoon implies that dust deposition is determined by the out-wash efficiency of mineral particles for a permanent high atmospheric dust concentration over Northeast China in the last 220 years.     

Vertical distribution and water solubility of phosphorus and heavy metals in sediments of the St. Lucie Estuary, South Florida, USA

Accumulation and distribution of heavy metals and phosphorus in sediments impact water quality. There has been an increasing concern regarding fish health in the St. Lucie Estuary, which is related to increased inputs of nutrients and metals in recent decades. To investigate vertical changes of contaminants (P, Cd, Cr, Co, Cu, Ni, Pb, Zn, and Mn) in sediments of the St. Lucie Estuary in South Florida, 117 layer samples from six of the 210 to 420 cm depth cores were analyzed for their total and water-soluble P and heavy metals, clay, total Fe, Al, K, Ca, Mg, Na, and pH. Principal component analysis (PCA) was used in two sets of analytical data (total and water-soluble contaminant concentrations) to document changes of contaminants in each core of sediments. The PCA of total contaminants and minerals resulted in two factors (principal components). The first and second factors accounted for 61.7 and 17.2 % of the total variation in all variables, and contrast indicators associated with contaminants of P, Cd, Co, Cr, Ni, Pb, Zn, and Mn and accumulation of Fe and Al oxides, respectively. The first factor could be used for overall assessment of P and heavy metal contamination, and was higher in the upper 45–90 cm than the lower depths of each core. The concentrations of P and heavy metals in the surface layers of sediments significantly increased, as compared with those in the sediments deeper than 45–90 cm. The PCA of water-soluble contaminants developed two factors. The second factor (Cu–P) was higher in the upper than the lower depths of the sediment, whereas the highest score of the first factor (Cd–Co–Cr–Ni–Pb–Zn–Mn) occurred below 100 cm. The water-soluble Cu and P concentrations were mainly dependent on their total concentrations in the sediments, whereas the water-soluble Cd, Co, Cr, Ni, Pb, Zn, and Mn concentrations were mainly controlled by pH.     

Application of membrane technology for water treatment： Ultrasound-associated cleaning of fouled microfiltration membranes

The use of membranes is a widely employed, versatile, and effective separation process. One of the limiting aspects in applying microfiltration （MF） for wastewater treatment is that of problems with membrane fouling and consequent flux reduction. Membrane fouling occurs by the irreversible deposition of retained particles, colloids, macromolecules, salts, etc. at the membrane surface and/or inside the membrane. The predominant fouling mechanisms observed with MF membranes are classified as three categories： the build-up of a cake layer on the membrane surface, blocking of membrane pores, and adsorption of fouling material on the membrane surface or in the pore walls. Although many techniques have been developed to overcome fouling, studies on membrane cleaning still seem to be insufficient for practical membrane filtration systems. Current membrane cleaning technologies include hydraulic, chemical, and mechanical methods. Ultrasound （US） has been widely used as a method of cleaning materials because of the cavitation phenomenon. In this study, US cleaning technique was applied to removing the fouling of polyvinglidenefluoride （PVDF） MF membrane, which was used to treat yeast cell and isolated soybean protein （ISP） solution, respectively. The US employed 40 kHz frequency and the output power of 1.43-2.85 W/cm^2. The evolution of the cleaning effect is followed by the measurements of the flux recovery rate （FRstat） and the cleaning time cycle. Results showed that the membrane property, which was fouled by yeast cell solution, could be recovered by water cleaning with US irradiation. And the cleaning time with the same FRstat decreased with the increase of US intensity.     

地震属性分析中水平切片的应用

利用地震数据体中含有的丰富地质信息,可以有效地进行储层预测。层拉平水平切片地层学解释方法是先将地震剖面目的层段做层拉平处理,然后对切片顺地层层面追踪,勾绘出各种地层现象,并以地层学的观点加以解释。该方法在吉林探区扶新南部地区的应用中,对于识别河道的展布趋势取得了较好的效果,而且发现了多期叠置的扇型沉积体。另外,还可指导反演数据体的解释,做到对岩性体从定性到定量的描述。     

东准噶尔纸房地区晚石炭世巴塔玛依内山组陆相火山-沉积体系特征

东准噶尔巴塔玛依内山组是典型陆相火山．沉积体系(盆地)，主体由基性及中酸性火山熔岩组成，火山碎屑岩及火山碎屑沉积岩较少，通过对纸房地区晚石炭世巴塔玛依内山组陆相火山岩的岩石化学、地球化学特征进行系统研究，认为它属于造山期后固结初期，新陆壳裂谷向高原火山岩演化的同岩浆源、同沉积盆地、同火山作用的钙碱系列双峰式火山岩．     

环境样品中痕量元素的化学形态分析Ⅱ．砷汞镉锡铅硒铬的形态分析

环境中元素的生物有效性和毒性依赖于其存在的化学形态。文章依据文献的有关报道介绍砷、汞、镉、锡、铅、硒和铬在环境中的分布、毒性及它们在环境样品如水、土壤、沉积物和生物体中的形态分析方法,包括分析物的保存、提取、分离和检测。引用文献120篇。     

超声与振荡提取沉积物中松散结合态磷的比较

用超声技术提取沉积物样品中松散结合态磷,并与振荡提取结果进行比较。结果表明,超声提取结果与振荡提取结果大致相当。超声提取耗时短,操作简单易行,测试结果精密度为3.8%(RSD,n=7),可以替代振荡方法提取沉积物中的松散结合态磷。     

长江三角洲地区水和热通量的时空变化特征及影响因子

文中利用改进的K B模式和牛顿扩散方法及 196 1年以来的长江三角洲 (2 8～ 33°N ,118～ 12 3°E)地区的 4 8个测站的常规气象资料 ,估计了该地区近 4 0a来的蒸散量和感热通量。结合该地区的气温、太阳辐射等气候资料和 196 0年以来该区域土地资源利用变化等有关信息对该地区的潜热通量和感热通量的时 空间变化特征及其可能成因进行了综合分析。结果认为该地区自 2 0世纪 70年代开始平均蒸散量有逐渐减小的趋势 ,与 1980年相比 ,1998年区域年平均蒸散量减小了 2 4mm。区域平均感热通量与蒸散量相比在此期间变化并不明显。通过对该地区的云量、太阳辐射及土地利用变化资料分析认为 ,造成该地区平均蒸散量减少趋势的的原因之一是用于蒸发的能量即太阳辐射的减少 ,而造成太阳辐射减少的可能原因为云量及大气透明度的变化所至 ;原因之二是该地区地表覆盖条件的改变。近 2 0a来 ,该地区的水田、旱地及水域面积占总面积的比率分别减少 1.35 3% ,4 .4 4 2 %和2 .5 97% ,而城镇建设、工矿及其它建设用地面积则增加 3.345 %。耕地及水面的减小和城镇及建设用地面积的增加从整体上使区域平均蒸发量减少。     

乾安地区盐碱地显热通量的测量

文中给出了用大孔径闪烁仪在 2 0 0 0年生长季观测到的盐碱地区显热通量的主要结果 ,并初步计算了当地的水热平衡状况。结果表明 :乾安盐碱地区显热通量占净辐射量的百分比在干旱、非生长季达到 6 5 % ,在多雨、植被生长季仅为 11% ;显热通量因降水而明显降低 ,幅度与降水强度有关 ,反映了当地的气候和土壤特征。文中还把LAS的测量结果与传统的梯度法作了比较 ,结果基本一致。     

T106产品中700hPa垂直速度和水汽能量与塔城大降水关系的探讨

对塔城盆地1998－1999年15个大降水个例进行了诊断分析，发现了T106产品700hPa垂直速度和水汽通量与塔城盆地大降水量级呈正相关，并给出了定量预报指标。