三峡深水高土石围堰工程的渗流研究

为了对三峡工程二期高土石围堰防渗设施的布置方案及其阻渗效果进行比较,采用有限元法对二期高土石围堰在不利的运行工况下的渗流场进行数值分析.比较了双排混凝土防渗墙方案、单排塑性混凝土低防渗墙加土工膜斜墙和单排厚塑性混凝土防渗墙等3种方案,分别采用恒定与非恒定模型计算,对立面二维和三维绕渗及防渗墙局部开裂等不利工况分别进行了数值模拟.结果表明:三方案均可有效抑制渗流场,双排混凝土防渗墙的防渗效果最好;墙体的局部开裂仅对局部区域的流场有影响.非恒定数值分析表明,堰体、基础不均匀沙石料及基坑抽水速度对渗流场影响极大,为保证堰体稳定,应限制基坑水位降落速度小于2 m/d.     

长江三峡工程奉节库岸边坡地下水渗流场模拟分析

长江三峡工程正常蓄水位为175m，在蓄水过程中随着库水位的抬升，必然会引起库岸边坡地下水渗流场的变化。运用3D－Modflow软件模拟了三峡工程的蓄水过程中奉节库段边坡岩土体内部地下水位的动态变化，为长江三峡工程奉节库区段移民迁建地质灾害预测与防治提供科学依据。     

Evapotranspiration from citrus trees growing in sandy soilunder drip irrigation with saline water

An experiment on evapotranspiration from citrus trees under irrigation with saline waterwas carried out for 4 months. Two lysimeters planted with a citrus tree in the green house wereused. One lysimeter was irrigated with saline water (NaCl and CaCl2 of 2000 mg/L equivalence,EC = 3.8 dS/m, SAR = 5.9) and the other was irrigated with freshwater using drip irrigation. Theapplied irrigation water was 1.2 times that of the evapotranspiration on the previous day.Evapotranspiration was calculated as the change in lysimeter weight recorded every 30 minutes.The lysimeters were filled with soil with 95.8% sand. The results of the experiment were as follows.(i) The evapotranspiration from citrus tree was reduced after irrigation with saline water. Theevapotranspiration returns to normal after leaching. However it takes months to exhaust the saltfrom the tree. ( ii ) To estimate the impact of irrigation with saline water on the evapotranspirationfrom citrus trees, the reduction coefficient due to salt stress (Ks) was used in this experiment.Evapotranspiration under irrigation with saline water (ETs) can be calculated from evapotranspira-tion under irrigation with freshwater (ET) by the equation ETs = Ks× ET. Ks can be expressed as afunction of ECsw. (iii) The critical soil-water electrical conductivity (ECsw) is 9.5 dS/m, beyondwhich adverse effects on evapotranspiration begin to appear. If ECsw can be controlled at below9.5 dS/m, saline water can be safely used for irrigation.     

钙贝塔石(Calciobetafite)在我国的发现

钙贝塔石发现于四川西昌的霓辉石-钠铁闪石脉中，与之共生的矿物是霓辉石，钠铁闪石，钠长石，铈磷灰石，硅钛铈矿，沥青铀矿，重晶石，方解石和彩钼铅矿等。钙贝塔石呈黑色，黑褐色，具八面体晶形，大小为2mm～8mm，条痕为黑色或黄褐色，油脂到沥青光泽，贝壳状断口。摩氏硬度为6．05～6．44(Hv=570．08kg／mm^2～689．06kg／mm^2)；无解理，比重4．51(扭力天平法测定)，反射率从406nm(13．53％)到659nm(11．87％)。经计算钙贝塔石的化学式为：(Ca，Na，U)2(Nb，Ti)2(0，OH)，。钙贝塔石的强X射线：2．975(10．222)，2．570(5．400)，1．816(9．440)，1．549(8．622)，1．050(6．844)，等轴晶系，α=1．029nm。     

多元回归模型在坝基渗透稳定性预测中的应用

在坝的失事事故中，渗透破坏占了30～40％。坝基渗流长期观测资料是病险土石坝渗透稳定性预测的主要依据。多元回归模型是定量处理观测数据的有力工具。本文根据坝基水文地质特征的差异性以及渗流场的非平面性，将多元回归数学模型应用于坝基渗透稳定性预测中，给出了在计算机上实现的计算算例。通过对陆浑水库的研究分析，对坝基渗透稳定现状及变化趋势的有了进一步认识，成功地解决了影响水库正常运行的坝基渗流问题，为水库投入正常高水位运行提供了详实的依据。其研究成果与其它方法结论一致，从而证明多元回归模型具有较强的实用性。     

河南东濮凹陷古近系沙河街组盐岩沉积特征及成因

东濮凹陷是渤海湾盆地的一个次级构造单元，其古近系的两个沉积旋回发育了四套盐岩，分别位于沙河街组第三段的第四亚段(S34)、第三亚段(S33)、第二亚段(S32)和沙河街组的第一段(S1)。主要分布在凹陷北部。每套盐岩又由若干个盐韵律组成，每一单韵律由盐岩和泥岩组成。两套等时对比标志层（深湖沉积）之间盐岩与砂泥岩存在着相变关系。盐岩是在深盆背景下干旱成因的，盐类物质来自地下深处上涌的卤水，分层卤水是盐形成的基本形式，上涌通道是基底大断裂，动力基础是岩浆活动。盐的阻隔作用使其对下部地层的温度、压力均有影响，这种影响有利于加快盐下地层中的有机质成熟与演化。盐又是良好的盖层，且在高温、高压下盐呈塑性状态。勘探实践看出东濮凹陷的岩性油气藏与盐岩的沉积有密切的关系，因此搞清盐岩的分布规律对东濮凹陷下步勘探有着极为重要的意义。     

斜坡地下水渗透力计算与稳定性分析

分析了基岩山区斜坡区域地下水的渗流模式,指出斜坡堆积体中地下水的一般特征,根据这个特征建立了条分法中斜坡渗透力的简易计算方法,用于改进传统的剩余推力法和Sarma法。该方法不需要额外补充参数,易于工程勘察人员掌握。提出通过极限状态考察斜坡安全储备的思路,对三峡库区某滑坡在水库蓄水前后的稳定性和安全储备进行了评价,结果表明传统方法计算的稳定性系数过高,当库水位快速下降时滑坡稳定性减弱,地下水渗透力是其中不可忽视的影响因素。     

地下非均匀非饱和带中地下洞室的渗流问题数值模拟--介质参数的灵敏度分析

影响任何一个地下废物处置场所长期行为的一个重要因素是进入地下废物贮置洞室内的渗流量的大小，预测地下洞室中的渗流量是困难的，特别是当地下废物贮置洞室位于非均质非饱和带中，三维数值模型用于研究地下非均质中非饱和流动及流入地下洞室中的渗流量，讨论了非均质模型与均质模型的比较以及数值剖分尺度对计算结果的影响，进入洞室中的渗漏率随着引入系统中入渗量的增加而增大，选用4个参数来衡量渗流场的非均质程度：(1)介质的平均渗透率K0；(2)Van Genuchten参数α；(3)渗透率空间分布相关尺度；(4)渗透率空间分布变化的标准差σ，根据一个随机实现的渗透率分布，通过改变平均渗透率来研究其对流入洞室中渗透量的影响，对一个固定的入渗率而言，流入洞室中的渗漏率将随着Van Genuchten参数α的减小而减小，模拟结果表明流入洞室的渗漏率与介质的平均渗透率相关，即随平均渗透率的增大，流入洞室的渗漏率亦增大，流入洞室的渗漏率还高度依赖于非均质渗透率场的空间分布相关长度与标准差，一个大的相关长度或高的标准差均能导致流入洞室的渗漏率增大。     

哈尔滨市磨盘山水利枢纽区三维渗流数值模拟模型研究

哈尔滨市磨盘山水库防渗型式拟采用垂直砼防渗墙及帷幕灌浆方案。为了分析左岸不同长度防渗对水库渗漏量及坝基渗透稳定性的影响。对磨盘山水利枢纽区渗流场进行了三维数值模拟研究。结果表明，随着左岸防渗长度的增大。渗漏量及下游渗流出口渗透比降基本呈线性趋势减小。当左岸防渗长度为200m时。渗漏量及各渗透比降均小于允许值，为推荐的渗控方案。     

Mechanisms of riverbank failure along the Arno River,central Italy

Riverbanks along the Arno River have been investigated with the aims of de?ning the main mechanisms of failure and retreat, their spatial distribution, and their causes. Geomorphological aspects were investigated by a reconnaissance of riverbank processes, for a number (26) of representative sites. Laboratory and in situ tests were then performed on a selected number of riverbanks (15). Based on the material characteristics, six main typologies of riverbanks have been de?ned, with homogeneous ?ne‐grained and composite banks representing the most frequent types. Slab‐type failures are the most frequent mechanism observed on ?ne‐grained banks, while cantilever failures prevail on composite banks. The role of river stage and related pore water pressure distributions in triggering the main observed mechanisms of failure has been investigated using two different types of stability analysis. The ?rst was conducted for 15 riverbanks, using the limit equilibrium method and considering simpli?ed hypotheses for pore water pressure distribution (annulment of negative pore pressures in the portion of the bank between low water stage and peak stage). Stability conditions and predicted mechanisms of failure are shown to be in reasonably good agreement with ?eld observations. Three riverbanks, representative of the main alluvial reaches of the river, were then selected for a more detailed bank stability analysis, consisting of: (a) de?nition of characteristic hydrographs of the reach with different return periods; (b) modelling of saturated and unsaturated ?ow using ?nite element seepage analysis; and (c) stability analysis with the limit equilibrium method, by adopting pore water pressure values derived from the seepage analysis. The results are compared to those obtained from the previous simpli?ed analysis, and are used to investigate the different responses, in terms of stability, to different hydrological and riverbank conditions. Copyright © 2003 John Wiley & Sons, Ltd.