Aseismio fault slip and block deformation in North China

In North China, the tectonic fault-block system enables us to use the Discontinuous Deformation Analysis (DDA) method to simulate the long-term cross-fault survey and other geodetic data related to aseismic tectonic deformation. By the simulation we have found that: (1) Slips on faults with different orientation are generally in agreement with the ENE-WSW tectonic stress field, but the slip pattern of faulting can vary from nearly orthogonal, to pure shear along the strike of the faults, this pattern cannot be explained by simple geometric relation between the strike of the fault and the direction of the tectonic shortening. This phenomenon has been observed at many sites of cross-fault geodetic surveys, and might be caused by the interactions between different blocks and faults. (2) According to the DDA model, if the average aseismic slip rate along major active faults is at the order of several tenths of millimeter per year as observed by the cross-fault geodetic surveys, the typical strain rate inside a block is at the order of 10^–8 year^–1 or less, so that the rate of 10^–6 year^–1, as reported by observations in smaller areas, cannot be the representative deformation rate in this region. (3) Between the slips caused by regional compression and block rotation, there is a possibility that the sense of slip caused by rigid body rotation in two adjacent blocks is opposite to the slip caused by the tectonic compression. But the magnitude of slip resulting from the tectonic compression is much larger than that due to the block rotation. Thus, in general, the slip pattern on faults as a whole agrees with the sense of tectonic compression in this region. That is to say, the slip caused by regional compression dominates the entire slip budget. (4) Based on (3), some observed slips in contradiction to ENE tectonic stress field may be caused by more localized sources, and have no tectonic significance.     

扇束CT探测器偏转的重建图像伪影校正

对于CT扇束扫描,射线源焦点与被测工件旋转中心的连线不垂直于探测器所在直线时,采用标准的滤波反投影重建算法重建出的图像会存在伪影,降低图像质量。本文基于经典滤波反投影重建算法理论,分析了此类伪影形成的原因,给出了利用投影原始数据(正弦图)计算校正算法所必需的几何参数的方法。本方法无需专用模体,不必进行二次扫描,方便、快捷并有效。计算机仿真及实验结果证明本方法的有效性。     

The temporal variation of the spherical and Cartesian multipoles of the gravity field: the generalized MacCullagh representation

 The Cartesian moments of the mass density of a gravitating body and the spherical harmonic coefficients of its gravitational field are related in a peculiar way. In particular, the products of inertia can be expressed by the spherical harmonic coefficients of the gravitational potential as was derived by MacCullagh for a rigid body. Here the MacCullagh formulae are extended to a deformable body which is restricted to radial symmetry in order to apply the Love–Shida hypothesis. The mass conservation law allows a representation of the incremental mass density by the respective excitation function. A representation of an arbitrary Cartesian monome is always possible by sums of solid spherical harmonics multiplied by powers of the radius. Introducing these representations into the definition of the Cartesian moments, an extension of the MacCullagh formulae is obtained. In particular, for excitation functions with a vanishing harmonic coefficient of degree zero, the (diagonal) incremental moments of inertia also can be represented by the excitation coefficients. Four types of excitation functions are considered, namely: (1) tidal excitation; (2) loading potential; (3) centrifugal potential; and (4) transverse surface stress. One application of the results could be model computation of the length-of-day variations and polar motion, which depend on the moments of inertia. Received: 27 July 1999 / Accepted: 24 May 2000     

Nature of the small main belt Asteroid 3169 Ostro

We present a set of rotational lightcurve measurements of the small main belt Asteroid 3169 Ostro. Our observations reveal an unambiguous, double-peaked rotational lightcurve with a peak-to-peak variation up to 1.2±0.05 mag and a synodic period of 6.509±0.001 h. From the large flux variation and the overall shape of the lightcurves, we suggest that 3169 Ostro could be a tightly bound binary or a contact binary, similar to the Trojan Asteroid 624 Hektor. A shape model of this system is proposed on the assumption that 3169 Ostro is a Roche binary described by a pair of homogeneous elongated bodies, with a size ratio of 0.87, in hydrostatic equilibrium and in circular synchronous motion around each other. The direction of the spin axis is determined modulo 180° by its J2000 ecliptic coordinates λ₀=50±10°, β₀=±54±5°. The binary interpretation and the pole solution adequately fit the earlier photometric observations made in 1986 and 1988. However, additional supporting lightcurves are highly desirable especially in the next mutual events occurrence of 2008 and 2009 in order to remove the pole ambiguity and to confirm unambiguously the binary nature of 3169 Ostro.     

Absolute Magnitudes of Be Stars Based on Hipparcos Parallaxes

The absolute visual magnitudes of 457 Be stars are determined from Hipparcos parallaxes, subsequently the mean absolute visual magnitudes of Be stars for luminosity classes III, IV and V are obtained. The new Mv calibration is compared with existing calibrations. It is found that Be stars are generally brighter than B stars of the corresponding spectral types, and that there is no direct correlation between absolute magnitudes and the stellar rotational velocity, these results are in agreement with some earlier results. A new and interesting result is that there is no direct correlation between near infrared excess and absolute visual magnitudes for Be stars. Moreover, possible biases, such as the Malmquist bias and the Lutz–Kelker bias, are also discussed.     

The light curve of asteroid 2867 Steins measured by VIRTIS-M during the Rosetta fly-by

On 5 September 2008, the Rosetta spacecraft encountered the asteroid 2867 Steins on its way to the comet 67P/Churyumov-Gerasimenko. This was the first of two planned asteroid fly-bys performed by the probe, the second fly-by being with the much larger asteroid 21 Lutetia in July 2010. The VIRTIS imaging spectrometer (IFOV 0.250 mrad, overall spectral range 0.25-5.1 μm) onboard Rosetta acquired data of Steins already before the closest approach phase, when the target was spatially unresolved, in order to obtain a light curve of the asteroid in the infrared spectral range extending up to 5 μm, that was never explored before. The VIRTIS light curve campaign started at 11:30 UTC onboard time, when the spacecraft was about 221,377 km away from the target, and ended at 17:58 UTC, at a distance of 20,741 km away from Steins. During this timeframe, the solar phase angle of the asteroid was roughly constant, ranging from 38.2° to 36.3°.Assuming the most recent value derived for the rotational period of Steins (Lamy et al., 2008), the VIRTIS observations covered slightly more than one rotation of the asteroid. In this interval, VIRTIS collected 8 hyperspectral cubes where Steins was captured 119 times, both in the visual and in the infrared range. Given the low signal and the unresolved appearance of the source, for which the instrument was not designed, only a small subset of wavelengths turned out to be suitable to sample the light curve. Nevertheless, in both the VIS and NIR ranges we find a similar trend, with two different maxima and minima during one rotational period, and amplitudes consistent with the results in the visual range obtained in previous works, including the data set acquired by the OSIRIS camera onboard Rosetta. We also report the presence of a new broad feature centered at approximately 0.81-0.82 μm, which is seen in the visual data throughout the rotation of the asteroid.     

27‐day variations of solar indices and cosmic ray neutron monitor intensities

Solar activity indices (coronal, chromospheric as well as photospheric) and cosmic ray neutron monitor rates (different cut‐off rigidity) have been used to study 27‐day variations in the years from 1957 to 2004. Daily data were employed for this purpose, analysed by the FFT and wavelet techniques. To work with a continuous data set for the cosmic rays (CR), the ‘Composite Cosmic Ray’ (CCR) set was first created from the observations carried out at different neutron monitor stations. The CCR frequency analysis shows significant 27‐day variations in the intensity of CR, with its amplitude's values very sensitive to the sign of the quantity qA. The most significant 27‐day variations of CR were found not to correlate with those of other solar indices. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Cass 5.1软件下的数字化内业纠错

阐述了数字化内业制图中,对外业测站错设而引起的大量碎部点测偏的内业纠正,重点探讨了错误产生后的平面和高程数据的纠错处理,有针对性地做出了说明。     

Seismic view of the solar interior

The interior of the Sun is not directly observable to us. Nevertheless, it is possible to infer the physical conditions prevailing in the solar interior with the help of theoretical models coupled with observational input provided by measured frequencies of solar oscillations. The frequencies of these solar oscillations depend on the internal structure and dynamics of the Sun and from the knowledge of these frequencies it is possible to infer the internal structure as well as the large scale flows inside the Sun, in the same way as the observations of seismic waves on the surface of Earth help us in the study of its interior. With the accumulation of seismic data over the last six years it has also become possible to study temporal variations in the solar interior. Some of these seismic inferences would be described.