山东车镇凹陷东部古近系沙河街组成岩作用

车镇凹陷沙河街组的沉积体系受控于盆地内的构造、物源供给以及沉积时的气候环境。以岩石学特征为基础，描述了成岩过程中压实与压溶作用、胶结作用、溶解作用与次生孔隙的特征，以及次生孔隙带在本区的分布。论述了碳酸盐胶结物与粘土矿物胶结作用的特点。粘土矿物蒙脱石-伊利石转变具有明显的渐变与突变交替的演化程式，其演化经历了蒙脱石带、渐变带、迅速转化带和伊利石带以及蒙脱石向伊利石的转变带。沙河街组的成岩作用划分为早期成岩阶段（A期、B期）和晚期成岩阶段（A期、B期、C期），并提出了成岩阶段的划分标志。     

泌阳凹陷安棚油田深层系成岩作用研究及其在成岩圈闭预测中的应用

深层系一般指沉积盆地中埋藏深度在2 500～2 700 m以下的地层,其储集物性普遍很差,但在一定条件下,深部溶蚀作用可产生优质储层,形成成岩圈闭.然而这种成岩圈闭的预测一直是一个难题.安棚油田位于河南泌阳凹陷东南部,勘探成果表明,在该油田深层系下第三系核桃园组核三段下部(简称(核三下)席状的扇三角洲砂体中存在成岩圈闭.本次通过定量的成岩作用研究和成岩阶段划分,对成岩圈闭的形成机理和分布进行了探讨.研究表明,该区核三下的砂体经历了压实、胶结、溶蚀等多种成岩作用,不同的成岩作用发生于不同的埋藏深度.2 700～3 100 m之间以胶结强烈为特征,属于胶结带.3 100～3 900 m之间以次生溶蚀孔隙发育为特征,尤其是3 200～3 600 m之间, 属于深部溶蚀带.本区核三下砂体自南而北埋藏深度逐渐变浅,其上倾方向处于胶结带的部分由于强烈胶结而变成致密层,可封堵油气,而下倾方向处于溶蚀带的部分由于次生溶蚀孔隙发育而成为良好储层,从而形成成岩圈闭.根据不同埋藏深度、不同成岩阶段孔隙发育和保存的特征,可预测成岩圈闭分布。     

Genesis of chlorine and sulphur in fumarolic emissions at Vulcano Island (Italy): assessment of pH and redox conditions in the hydrothermal system

Chlorine- and sulphur-bearing compounds in fumarole discharges of the La Fossa crater at Vulcano Island (Italy) can be modelled by a mixing process between magmatic gases and vapour from a boiling hydrothermal system. This allows estimating the compounds in both endmembers. Magma degassing cannot explain the time variation of sulphur and HCl concentrations in the deep endmember, which are more probably linked to reactions of solid phases at depth, before mixing with the hydrothermal vapours. Based on the P–T conditions and speciation of the boiling hydrothermal system below La Fossa, the HCl and S_tot contents in the hydrothermal vapours were used to compute the redox conditions and pH of the aqueous solution. The results suggest that the haematite–magnetite buffer controls the hydrothermal fO₂ values, while the pH has increased since the end of the 1970s. The main processes affecting pH values may be linked to Na–Ca exchanges between evolved seawater, feeding the boiling hydrothermal system, and local rocks. While Na is removed from water, calcium enters the solution, undergoes hydrolysis and produces HCl, lowering the pH of the water. The increasing water–rock ratio within the hydrothermal system lowers the Ca availability, so the aqueous solution becomes less acidic. Seawater flowing towards the boiling hydrothermal brine dissolves a large quantity of pyrite along its path. In the boiling hydrothermal system, dissolved sulphur precipitates as pyrite and anhydrite, and becomes partitioned in vapour phase as H₂S and SO₂. These results are in agreement with the paragenesis of hydrothermal alteration minerals recovered in drilled wells at Vulcano and are also in agreement with the isotopic composition of sulphur emitted by the crater fumaroles.     

3D shear-wave velocity structure of the Eifel plume, Germany

The Quaternary Eifel volcanic fields, situated on the Rhenish Massif in Germany, are the focus of a major interdisciplinary project. The aim is a detailed study of the crustal and mantle structure of the intraplate volcanic fields and their deep origin. Recent results from a teleseismic P-wave tomography study reveal a deep low-velocity structure which we infer to be a plume in the upper mantle underneath the volcanic area [J.R.R. Ritter et al., Earth Planet. Sci. Lett. 186 (2001) 7-14]. Here we present a travel-time investigation of 5038 teleseismic shear-wave arrivals in the same region. First, the transverse (T) and radial (R) component travel-time residuals are treated separately to identify possible effects of seismic anisotropy. A comparison of 2044 T- and 2994 R-component residuals demonstrates that anisotropy does not cause any first-order travel-time effects. The data sets reveal a deep-seated low-velocity anomaly beneath the volcanic region, causing a delay for teleseismic shear waves of about 3 s. Using 3773 combined R- and T-component residuals, an isotropic non-linear inversion is calculated. The tomographic images reveal a prominent S-wave velocity reduction in the upper mantle underneath the Eifel region. The anomaly extends down to at least 400 km depth. The velocity contrast to the surrounding mantle is depth-dependent (from −5% at 31-100 km depth to at least −1% at 400 km depth). At about 170-240 km depth the anomaly is nearly absent. The resolution of the data is sufficient to recover the described features, however the anomaly in the lower asthenosphere is underestimated due to smearing and damping. The main anomaly is similar to the P-wave model except the latter lacks the ‘hole’ near 200 km depth, and both are consistent with an upper mantle plume structure. For plausible anhydrous plume material in the uppermost 100 km of the mantle, an excess temperature as great as 200-300 K is estimated from the seismic anomaly. However, 1% partial melt reduces the required temperature anomaly to about 100 K. The temperature anomaly associated with the deeper part of the plume (250 to about 450 km depth) is at least 70 K. However, this estimate is quite uncertain, because the amplitude of the shear-wave anomaly may be larger than the modelled one. Another possibility is water in the upwelling material. The gap at 170-240 km depth could arise from an increase of the shear modulus caused by dehydration processes which would not affect P-wave velocities as much. An interaction of temperature and compositional variations, including melt and possibly water, makes it difficult to differentiate quantitatively between the causes of the deep-seated low-velocity anomaly.     

Isotope variations in a Sierra Nevada snowpack and their relation to meltwater

Isotopic variations in melting snow are poorly understood. We made weekly measurements at the Central Sierra Snow Laboratory, California, of snow temperature, density, water equivalent and liquid water volume to examine how physical changes within the snowpack govern meltwater δ¹⁸O. Snowpack samples were extracted at 0.1 m intervals from ground level to the top of the snowpack profile between December 1991 and April 1992. Approximately 800 mm of precipitation fell during the study period with δ¹⁸O values between −21.35 and −4.25‰. Corresponding snowpack δ¹⁸O ranged from −22.25 to −6.25‰. The coefficient of variation of δ¹⁸O in snowpack levels decreased from −0.37 to −0.07 from winter to spring, indicating isotopic snowpack homogenization. Meltwater δ¹⁸O ranged from −15.30 to −8.05‰, with variations of up to 2.95‰ observed within a single snowmelt episode, highlighting the need for frequent sampling. Early snowmelt originated in the lower snowpack with higher δ¹⁸O through ground heat flux and rainfall. After the snowpack became isothermal, infiltrating snowmelt displaced the higher δ¹⁸O liquid in the lower snowpack through a piston flow process. Fractionation analysis using a two-component mixing model on the isothermal snowpack indicated that δ¹⁸O in the initial and final half of major snowmelt was 1.30‰ lower and 1.45‰ higher, respectively, than the value from simple mixing. Mean snowpack δ¹⁸O on individual profiling days showed a steady increase from −15.15 to −12.05‰ due to removal of lower δ¹⁸O snowmelt and addition of higher δ¹⁸O rainfall. Results suggest that direct sampling of snowmelt and snow cores should be undertaken to quantify tracer input compositions adequately. The snowmelt sequence also suggests that regimes of early lower δ¹⁸O and later higher δ¹⁸O melt may be modeled and used in catchment tracing studies.     

青藏高原土壤水热分布特征及冻融过程在季节转换中的作用

利用GAME-Tibet期间所取得的高分辩率土壤温度和含水量资料，对青藏高原（主要是藏北高原）土壤水热分布特征及冻融过程在季节转换中的作用进行了分析。指出藏北高原4cm学深处土壤在10月份开始冻结，次年4-5月份开始消融，冻结持续时间长达5-7个月。冻结过程有利于土壤维持其水分，因此，在刚刚开始消融时土壤含水量仍然很高。从而为夏季风爆发前土壤通过蒸发向大气提供水分打下了基础。指出土壤冻融过程可能在高原季节转换中起着重要作用。     

Identification of geomorphic process units in Kärkevagge, northern Sweden, by remote sensing and digital terrain analysis

Sediment transport processes in the Kärkevagge are investigated concerning their spatial and temporal characteristics due to long–term monitoring. Within this study remote sensing techniques and GIS modelling in connection with geomorphic mapping are applied for identification and characterization of geomorphic process units. Relationships between geomorphometric parameters and slope processes like solifluction, talus creep and rockfall have been analysed. Multitemporal Landsat–TM5 scenes are used as source for landcover characteristics (Normalized Difference Vegetation Index) after preprocessing involving orthorectification and topographic normalization in order to remove possible terrain–induced effects. Additionally, a digital elevation model with a resolution of 20 m for the Kärkevagge catchment is developed and parameters like slope gradient, slope aspect and profile curvature are extracted as input for the analysis of the sediment transport system. The combination of landcover information, geomorphometrical and topological features allows the definition of areas for single process activities. They show specific sediment displacement characteristics depending on material conditions, topological and geometrical features. Geomorphic process units, which show a homogenous composition, are extracted from these available layers.     

Study of weathering processes developed on old piedmont surfaces in Western Spain: new contributions to the interpretation of the “Raña” profiles

The Hercynian basement of the Iberian Peninsula was uplifted by the Alpine orogeny during the Tertiary. It gave rise to a set of block mountains and tectonic grabens, one of which is the Ciudad Rodrigo Basin. It is located in Western Spain and forms a westward extension of the great Tertiary Duero Basin. The sediments filling this graben are of continental origin, their ages ranging from Palaeogene to Quaternary. Morphologically, the southern part of this basin forms a set of piedmont surfaces (the “Raña” surfaces) appearing above the terrace system of the present rivers. This paper examines the weathering processes developed over these old piedmont surfaces using micromorphological, XR diffraction, scanning electron microscopy (SEM) and microporosity techniques.The Raña sediments are rich in quartzite pebbles and gravel within a clayey matrix. Once deposited, these materials underwent important in situ weathering processes under somewhat hydromorphic conditions, of which hydrolysis, ferrolysis and xerolysis were the most important. All these processes gave rise to: (1) transformation of most of the clasts of shists and slates into a matrix causing the destruction of the original sedimentary structures and a relative concentration of the resistant lithologies (quartzites and quartz); (2) important changes in the clay fraction, leading to a predominance of kaolinite in the upper levels of the profiles, (3) release of elements from primary minerals, Fe being one of the most important, and (4) redistribution of matter, mainly clay and Fe oxyhydroxides, within the profiles.The coexistence of seasonal periods with pF higher than 4.2 repeated over a long time, together with poor internal and external drainage conditions, are the cause of the special features displayed by Raña deposits.     

Relationships between climatic factors and flower and boll production in Egyptian cotton (Gossypium barbadense)

Fruiting of cotton plant is determined and influenced by cultivar, climatic conditions, management practices and pests. An understanding of the flowering and boll retention patterns of cotton cultivars can contribute to more efficient and economical crop management. The objective of this investigation was to study the effect of various climatic factors on flower and boll production of Egyptian cotton. This could be used in formulating advanced predictions of the effect of certain climatic conditions on the production of Egyptian cotton. Two uniform field trials, using cotton Gossypium barbadense cv. Giza 75 were carried out in 1992 and 1993 at the Agricultural Research Station, Agricultural Research Center, Ministry of Agriculture, Giza, Egypt, to investigate the relationships between climatic factors, flower and boll production. Climatic factors included maximum and minimum air temperatures along with their difference, evaporation, surface soil temperature (grass temperature or green cover temperature) at 0600 and 1800 h°C⁻¹, sunshine duration, maximum and minimum humidity and wind speed. The effects of climatic factors on flower and boll production were quantified in the absence of water and nutritional deficits and damage effects of insects. Results obtained indicate that evaporation, sunshine duration, humidity, surface soil temperature at 1800 h, and maximum air temperature, were the important climatic factors that significantly affect flower and boll production of Egyptian cotton. Consequently, applying appropriate specific cultural practices that minimize the deleterious effect of these factors will lead to an improvement in cotton yield.