南极洲纳尔逊冰帽的某些动力学特征*

纳尔逊冰帽是南设得兰群岛的一个小冰帽,受海洋性气候影响冰帽上降水丰富,冰温较高。冰帽表面运动速度完全由冰帽表面形态和冰帽底床形态所控制,其中E剖面更为复杂。冰帽驱动应力基本小于100kPa.由V/Z～Za曲线得到在V/7为0.6～3×10^-9范围内的流动参数:n约为1;B≈4.3×10¹⁰dynescm^-2sec.这表明在低应力区,冰体流动更接近牛顿流体。     

黄土高原复杂地形受中尺度运动影响的稳定边界层湍流特征

利用兰州大学半干旱气候与环境观测站(Semi-Arid Climate and Environment Observatory of Lanzhou University,简称SACOL)2008年12月观测资料,研究了稳定边界层湍流特征.使用涡动相关资料研究湍流通量时,定义湍流的平均时间τ内的中尺度运动是造成湍流统计量变化范围大的主要原因,稳定情形? τ取几十秒至几分钟.对梯度理查森数大于0.3的强稳定情形的湍流尺度分解(MRD)谱分析表明,感热通量在112.4～449.9 s存在谱隙,尺度大于谱隙的中尺度运动造成了通量观测资料离散性大,甚至有支配性影响.动量通量的谱隙在112.4～224.9 s之间.弱风时,中尺度运动的影响更大,垂直风速标准差以0.1的比率随中尺度风速变化;垂直风速标准差同广义风速表现出很好的相关性,并随着广义风速消失而消失.三维风速标准差与摩擦速度呈很好的线性关系,垂直、水平、横风风速的无量纲标准差分别为1.35、2.54、2.21.对湍流动能的研究发现,在梯度理查森数大于0.3的条件下,仍然存在连续的湍流.以湍动能为依据,分析了湍流的平稳时间长度,其长度随稳定度变化而变化,2008年12月7～11日从133.5 s变化到856.2 s,湍流平稳时间长度反映了中尺度运动的发生频率.     

掘进工作面前方煤层底板高程动态预测的试验研究

快速掘进急需构建掘进前方高精度二维地质模型。以沁水煤田某矿区XY-S工作面为例,基于三维地震解释成果,利用巷道掘进过程中煤层底板高程实测信息,动态刷新三维地震平均速度场,更新掘进前方煤层底板高程,最后对掘进前方预测的精度进行统计分析。结果表明：通过不断利用掘进实测煤层底板高程,刷新平均速度场,更新掘进前方煤层底板地质剖面,掘进前方煤层底板剖面与实际揭露剖面之间误差逐渐越小,实测点前方25 m和50 m范围的煤层底板高程最小绝对误差可达0.2 m和0.45 m。若实测点数据密度大、分布均匀,预测精度将会进一步得到提高,可为快速掘进提供高精度煤层底板导航数据。     

句容甲山膨润土矿的地质特征和成因探讨

研究了句容甲山膨润土矿的矿床地质特征,发现地层上覆下白垩统碱性流纹岩,矿石呈黄绿色、粉红色、灰白色和肉红色等多种颜色,局部保留有原岩的角砾结构,并观察到含有风化残余的粗面岩团块和因断层滑移形成的断层角砾。X射线衍射（XRD）分析发现不同颜色矿石的矿物组成差异很大,通过扫描电子显微镜观察到岩石风化现象和伴生的次生矿物类型。研究表明,该矿属于火山熔岩风化残积型膨润土矿床,在开发过程中应进行分类开发或进行深加工处理,可提高开发效益。     

探地雷达宽角反射图形拟合方法

探地雷达共中心点(CMP)法仅用于局部速度测试,为使用宽角反射法进行剖面探测,可固定一个雷达天线而将另一个天线沿测线移动,从而获取整个地质界面的反射信号.本文提出宽角反射剖面探测方法,基于平直岩层界面导出其反射信号的关系式,并开发出解释软件,可精确计算岩层几何参数和层速度,从而进行地质分层.     

A numerical scheme for calculating stresses and strain rates in glaciers

The stress and strain-rate fields in a glacier or other type of rock with known rheological properties can be calculated by using a numerical solution technique. Calculations are based on force-balance equations and the constitutive relation for polar ice, and do not involve any mathematical approximations. The geometry is prescribed. Basal velocities also are prescribed, either by specifying their values or by relying on a sliding relation. All other quantities are determined numerically.     

基于窗口速度平滑伪距的遥感平台定位算法

对浮空器遥感平台进行精密的控制定位是其完成对地观测、中继通信以及环境遥感等任务的关键。在自主地面测控系统对浮空器平台跟踪定位的基础上,给出加窗径向速度平滑伪距的多站跟踪定位方法。仿真结果表明:在GDOP值超过6的情况下,利用加窗速度平滑伪距方法仍能改善遥感平台定位的精度,而且能够有效地削弱测距链路中粗差的影响,从而自主地根据近地空间环境对浮空器进行控制。     

Site effects at Euroseistest—I. Determination of the valley structure and confrontation of observations with 1D analysis

This paper describes the process of construction of the 2D model of Volvi's geological structure and results of empirical and theoretical approaches to the evaluation of site response at Euroseistest. The construction of the 2D model is based on a re-interpretation of the available geophysical and geotechnical data in an effort to improve the definition of the subsoil structure at Euroseistest in terms of the most important parameters needed to model site response. The results of this re-interpretation are compared with a previous published 2D model of the same alluvial valley. Different analysis of the measurements and different criteria in the synthesis of data have led to a different model, even if both studies had access to the same field measurements. This underscores the fact that a model results of an interpretation and is not uniquely determined by the data, no matter how detailed they are. The well known subsoil structure opened the possibility to correlate the geometry and the dynamic properties of the 2D model with the results of site response determined from a detailed analysis of two events in frequency and time domains and 1D numerical modeling. The study of site response shows the important effect of the lateral variations on the ground motion and suggests that the contribution of locally generated surface waves to the resonant peak may be important. In the case of Volvi's graben, the limitations of the 1D approximation to simulate ground motion under complex soil conditions in both frequency and time domains are also shown. This paper lays the ground for a companion article dealing with 2D site effects in this basin.