漳州热田的对流热流和传导热流的研究

漳州地热系统属对流型地热系统.漳州热田是我国东南沿海地区目前所见热田中温度最高（121.5℃）的一个.地表热流值的研究表明,热田中心具有最大的实测热流值（359mw/m²）.本文根据热田内152个钻孔的测温资料和56块岩石样品的热导率数据,采用三种不同方法计算出漳州热田及其邻近地区的大地热流值,并讨论了热流值分布的特点.     

云南大地热流及地热地质问题

本文报道了云南20多个大地热流测试数据。据热流分布特点并参考前人有关资料,结合地球物理测深资料、岩石热物性与放射性生热率测试数据,对各区地壳深度范围的温度、热流配分组成作了粗略分析,划分出各有特征的若干地质-热流区。云南普遍地热偏高(滇东南小范围除外)的主要原因是新构造运动强烈;怒江以西近代岩浆活动亦强烈,具有典型的板块交汇带的基本地热特点     

Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.     

PCBs and OCPs in sediments from Hongfeng Reservoir in Guizhou Province, China

In this research, chlorinated hydrocarbons （polychlorinated biphenyls and organochlorine pesticides） were measured by GC-ECD in sediments from the Hongfeng Reservoir area. The concentrations of total PCBs range from 3.2 to 31.6 ng/g, among which PCB28, PCB52 are the major congeners with the concentrations from 0.5 to 4.6 ng/g, and from 0.4 to 28.1 ng/g, respectively. The concentrations of these pollutants decrease from surface to bottom, while the concentrations at 1-4 cm are lower than at 5-8 cm, suggesting the decline of PCBs input. TOC concentrations of sediment are found in a significant positive correlation with those of PCBs, suggesting that PCBs are mainly adsorbed on organic matter and particles. HCHs and DDTs are the predominant organochlorine pesticides with the concentrations ranging from 1.6 to 8.9 ng/g （average 3.2 ng/g） and 0.9 to 25.7 ng/g （average 7.8 ng/g）, respectively. β-HCH and γ-HCH （lindane） are the predominant HCH isomers from sediments, and p, p＇-DDE and p, p＇-DDT are the predominant DDT isomers. DDT/DDE＋DDD and α-HCH/γ-HCH ratios range from 0.6 to 0.9 and 0.1 to 3.0, respectively, which indicates more use of lindane than technical mixtures of HCHs before, and also suggests changes in HCHs and DDTs in the environment. The high values of β-HCH and p, p＇-DDE also show that atmospheric input is one of the important sources of the Hongfeng Reservoir, because β-HCH and p, p＇-DDE are stable and have low Sw and Pv so that they can be easily transferred over a long range in atmosphere.     

Early diagenesis of nurtrients （C, N, P and Si） stored in sediments of two reservoirs in southwestern China

Damming is a common anthropogenic intervention along the course of rivers, which is defined as ＂artificial-lake effect＂, both in China and across the world. Today as many as 48000 dams and/or reservoirs are in operation in the Changjiang River （Yangtze River） drainage area, and more are being constructed. While damming is well known to affect riverbome nutrient loads, and thus the riverine ecosystems owing to removal of carbon fixation, and removal of particles in reservoir sediments, there is limited information on the detailed early diagenesis of sediments in reservoirs including the regeneration processes of nutrients deposited in sediments and exchange flux across the sediment-water interface, which is important for mass balance of riverbome nutrients. In the present study, two large-size reservoirs, Wujiangdu Reservoir （WJDR） and Dongfeng Reservoir （DFR）, located on the main steam of the Wujiang River and with uniformity hydrography and discrepancy biogeochemical activity （e. g. primary production）, were selected for a comparative study on the detailed processes of nutrient regeneration. Water, pore water and sediment were sampled from these two reservoirs and dissolved organic carbon （DOC）, NH4^＋, NO3^-, PO4^3-, dissolved silica （DSi） in the overlying water and pore water, and total organic matter in sediments were determined. The results of correlation analysis suggested that in these two reservoirs, processes of nutrient regeneration near the sediment-water interface were significantly different. As a result of rapid decomposition of algae-derived ＂labile＂ organic matter in upper sediments, nutrient regeneration processes and upward fluxes in WJDR are dramatically stronger than those of DFR. NH4^＋ upward flux from sediment in WJDR was about 17 times higher than that in DFR. PO4^3- flux in WJDR is about 13 times above that in DFR. DOC flux in WJDR is larger that in DFR by 5 times, and DSi by 1 time.     

Statistical evaluation of methods for the calculation of static formation temperatures in geothermal and oil wells using an extension of the error propagation theory

The feasibility of using the more sophisticated weighted least-squares (WLS) model, as opposed to the traditional ordinary least-squares (OLS), in linear regressions of BHT data to estimate the static formation temperatures (SFT) was investigated. The most commonly used analytical methods (line-source; spherical and radial heat flow; and cylindrical heat source) were applied. Error propagation equations were derived to calculate errors in the time function of each method. These errors were combined with the BHT measurement errors to compute weighting factors for applying the WLS. Intercept uncertainties were estimated for all regressions using sets of synthetic and actual borehole logs taken from geothermal and oil applications. SFT computed with the spherical and radial heat flow method were generally greater than those from the other two methods.     

Temperature–composition–time (T–X–t) data from authigenic K-feldspar: An integrated methodology for dating fluid flow events

Integration of fluid inclusion analysis with high spatial resolution Ar–Ar dating of K-feldspar cements has been used to resolve and reconstruct palaeo-fluid flow. Fluid inclusion analysis allows discrimination of distinct cement phases, thereby identifying discrete episodes of fluid flow. Ar–Ar dating of the same cements via high spatial resolution laserprobe establishes absolute age constraints on the framework previously constructed. Integration of these two datasets yields temperature–composition–time data.     

Reservoir description using dynamic parameterisation selection with a combined stochastic and gradient search

There is a correspondence between flow in a reservoir and large scale permeability trends. This correspondence can be derived by constraining reservoir models using observed production data. One of the challenges in deriving the permeability distribution of a field using production data involves determination of the scale of resolution of the permeability. The Adaptive Multiscale Estimation (AME) seeks to overcome the problems related to choosing the resolution of the permeability field by a dynamic parameterisation selection. The standard AME uses a gradient algorithm in solving several optimisation problems with increasing permeability resolution. This paper presents a hybrid algorithm which combines a gradient search and a stochastic algorithm to improve the robustness of the dynamic parameterisation selection. At low dimension, we use the stochastic algorithm to generate several optimised models. We use information from all these produced models to find new optimal refinements, and start out new optimisations with several unequally suggested parameterisations. At higher dimensions we change to a gradient-type optimiser, where the initial solution is chosen from the ensemble of models suggested by the stochastic algorithm. The selection is based on a predefined criterion. We demonstrate the robustness of the hybrid algorithm on sample synthetic cases, which most of them were considered insolvable using the standard AME algorithm.