华北地台中元古代碳酸盐岩中的微生物成因构造及其生烃潜力

华北地台中元古界主要由环潮坪石英砂岩、浅海碳酸盐岩和浅海—泻湖相暗色页岩3种沉积相组合构成,以陆表海浅水碳酸盐岩占主导。碳酸盐岩中除含有丰富的微古植物、宏观藻类和微生物建隆外,还发育大量的微生物成因构造(MISS)和微生物诱发的碳酸盐沉淀(MMCP)。微生物席和MISS构造在高于庄组上部(约1.6 Ga)和雾迷山组下部(约1.45 Ga)碳酸盐岩中尤为发育,表明活跃的微生物活动和高有机质产量。在石化微生物席中,发现有丝状、球状细菌化石和草莓状黄铁矿;围岩中发现有针状文石、花瓣状重晶石、放射状菱铁矿、铁白云石和葡萄状碳酸盐胶结物等多种自生碳酸盐矿物,指示甲烷厌氧氧化(AOM)导致的自生碳酸盐沉淀。中元古代的温暖气候和海洋分层、缺氧、硫化条件有利于微生物的高生产量和高有机质埋藏率。气隆构造和核形石状碳酸盐结核反映浅埋藏条件下活跃的成烷作用和甲烷排放,围岩和MMCP中富沥青质。华北地台中元古界富微生物席碳酸盐岩有良好的生烃潜力,有可能形成重要的烃源岩。据微生物席、MISS构造及MMCP的研究,初步估算华北地台中元古代碳酸盐岩的概略生烃潜力约为10×108t石油当量。     

Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。     

Early Jurassic rift structures associated with the Soapaga and Boyacá faults of the Eastern Cordillera, Colombia: Sedimentological inferences and regional implications

The NW-trending Bucaramanga fault links, at its southern termination, with the Soapaga and Boyacá faults, which by their NW trend define an ample horsetail structure. As a result of their Neogene reactivation as reverse faults, they bound fault-related anticlines that expose the sedimentary fill of two Early Jurassic rift basins. These sediments exhibit the wedge-like geometry of rift fills related to west-facing normal faults. Their structural setting was controlled further by segmentation of the bounding faults at approximately 10 km intervals, in which each segment is separated by a transverse basement high. Isopach contours and different facies associations suggest these transverse anticlines may have separated depocenters of their adjacent subbasins, which were shaped by a slightly different subsidence history and thereby decoupled. The basin fill of the relatively narrow basin associated with the Soapaga fault is dominated by fanglomeratic successions organized in two coarsening-upward cycles. In the larger basin linked to the Boyacá fault, the sedimentary fill consists of two coarsening-upward sequences that, when fully developed, vary from floodplain to alluvial fan deposits. These Early Jurassic rift fills temporally constrain the evolution of the Bucaramanga fault, which accommodated right-lateral displacement during the early Mesozoic rift event.     

Modeling of Beams on Reinforced Granular Beds

The paper describes a mechanical model for estimating the flexural response of a strip footing, supporting a column (imposing a concentrated load), resting on a compacted granular bed overlying a reinforcement layer for example, geogrids, geomats etc. below which lies a loose soil deposit. The footing is idealized as a beam and the reinforcing element is assumed to have finite bending stiffness and negligible frictional resistance. The upper and lower soil layers are idealized by a series of linear and discrete springs (Winkler springs) of different stiffness values. To find the response of such a model the governing differential equations have been derived and expressed in a nondimensional form. A closed form analytical solution of the same has been obtained subjected to appropriate boundary conditions. Using the present approach the resulting solution for a degenerated case of a long beam is found to be identical to the same of Hetenyi (1946, Beams on elastic foundations, University of Michigan press, Ann Arbor, MI). Parametric studies reveal that the ratio of flexural rigidity of upper and lower beam and the ratio of stiffness of the upper and lower soil layers affect significantly the response of the foundation.     

The origin of the Pedra Furada sandstone tubular structures (South of Lisbon, Portugal)

The Pedra Furada is a 12 m wide, 18 m high outcrop feature showing hundreds of ferruginised sandy tubes and looking in part like a giant organ. In this paper the origin of the tubes is explained on the basis of geochemical, petrographic and microscopic (optical and electronic) analytical data. The tubes are considered to represent vertical escape channels for overpressured water, exhibiting inward decreasing grain size due to water velocity gradients inside the escape channels. The ferruginisation is due to iron oxides associated with colloidal/clayey fine sediments and to goethite formed from solution. The overpressure of water may be due to seismically fluidised beds below the Pedra Furada outcrop or to artesian water ascent. In both cases, fault rupturing may have played a major role in the focussing of the ascending flow.     

Crustal structure across the Grand Banks–Newfoundland Basin Continental Margin – II. Results from a seismic reflection profile

New multichannel seismic reflection data were collected over a 565 km transect covering the non-volcanic rifted margin of the central eastern Grand Banks and the Newfoundland Basin in the northwestern Atlantic. Three major crustal zones are interpreted from west to east over the seaward 350 km of the profile: (1) continental crust; (2) transitional basement and (3) oceanic crust. Continental crust thins over a wide zone (∼160 km) by forming a large rift basin (Carson Basin) and seaward fault block, together with a series of smaller fault blocks eastwards beneath the Salar and Newfoundland basins. Analysis of selected previous reflection profiles (Lithoprobe 85-4, 85-2 and Conrad NB-1) indicates that prominent landward-dipping reflections observed under the continental slope are a regional phenomenon. They define the landward edge of a deep serpentinized mantle layer, which underlies both extended continental crust and transitional basement. The 80-km-wide transitional basement is defined landwards by a basement high that may consist of serpentinized peridotite and seawards by a pair of basement highs of unknown crustal origin. Flat and unreflective transitional basement most likely is exhumed, serpentinized mantle, although our results do not exclude the possibility of anomalously thinned oceanic crust. A Moho reflection below interpreted oceanic crust is first observed landwards of magnetic anomaly M4, 230 km from the shelf break. Extrapolation of ages from chron M0 to the edge of interpreted oceanic crust suggests that the onset of seafloor spreading was ∼138 Ma (Valanginian) in the south (southern Newfoundland Basin) to ∼125 Ma (Barremian–Aptian boundary) in the north (Flemish Cap), comparable to those proposed for the conjugate margins.     

Townsend's Hypothesis, Coherent Structures And Monin–Obukhov Similarity

Townsend's hypothesis states that turbulence near a wall can be divided into an activepart that transports momentum, and an inactive part that does not, and that these twokinds of turbulence do not interact. Active turbulence is generated by wind shear and has properties that scale on local parameters of the flow, while inactive turbulence isthe product of energetic processes remote from the surface and scales on outer-layerparameters. Both kinds of motion can be observed in the atmospheric surface layer, soMonin–Obukhov similarity theory, which is framed in terms of local parameters only,can apply only to active motions. If Townsend's hypothesis were wrong, so that activeand inactive motions do interact in some significant way, then transport processes nearthe ground would be sensitive to outer-layer parameters such as boundary-layer depth,and Monin–Obukhov theory would fail.Experimental results have shown that heat transport near the ground does depend onprocesses in the outer layer. We propose a mechanism for this whereby inactive motionsinitiate active, coherent ejection/sweep structures that carry much of the momentum andheat. We give evidence that the inactive motions take the form of streak patterns of fasterand slower air, and argue that these are induced by the pressure effects of large eddiespassing overhead. The streak pattern includes regions where faster streams of air overtakeand engulf slower-moving streaks. Transverse vortices form across the spines of the streaksat these places and some of them develop into horseshoe vortices. These horseshoe vorticesgrow rapidly and are rotated forward in the sheared flow so they soon contact the ground,squirting the air confined between the legs of the horseshoe vortex outwards as a forcefulejection. This model is consistent with a wide range of results from the field and laboratoryexperiments. Heat transport is significantly affected, so undermining the dimensionalassumptions of Monin–Obukhov similarity theory.     

Proportioning earthquake‐resistant RC frames in central/eastern U.S.

A maximum allowable period criterion is used to determine reasonable stiffness requirements for reinforced concrete frames with the seismicity associated with central and eastern U.S. A general relationship is developed to describe the displacement demand expected for central and eastern U.S. based on a survey of available ground motions, opinions of seismologists, and code‐based provisions. A series of hypothetical reinforced concrete frames is proportioned using a maximum allowable period criterion and evaluated for expected maximum displacement response using non‐linear dynamic analyses and a suite of ground motions. Results indicate that for the reinforced concrete structural systems considered in the study, proportioning for gravity loads will provide sufficient stiffness in central and eastern U.S. Copyright © 2002 John Wiley & Sons, Ltd.     

Towards a direct collapse–load method of design for concrete frames subjected to severe ground motions

Most current methods of design for concrete structures under earthquake loads rely on highly idealized ‘equivalent’ static representations of the seismic loads and linear‐elastic methods of structural analysis. With the continuing development of non‐linear methods of dynamic analysis for the overload behaviour and collapse of complete concrete structures, a more direct and more accurate design procedure becomes possible which considers conditions at system collapse. This paper describes an evaluation procedure that uses non‐linear dynamic collapse–load analysis together with global safety coefficients. A back‐calibration procedure for evaluating the global safety coefficients is also described. The aim of this paper is to open up discussion of alternative methods of design with improved accuracy which are necessary to move towards a direct collapse–load method of design. Copyright © 2002 John Wiley & Sons, Ltd.