Transport rate of calcareous sand in unidirectional flow

This paper examines the transport of calcareous sand in unidirectional flow and its prediction through existing sediment transport models. A flume experiment of four sand samples collected on Oahu, Hawaii, provides 29 sets of sediment transport data in the bed-form and suspended transport stages. The measured transport data are compared with direct predictions from four energy-based transport models developed for siliceous particles. Corrections for the grain-size, fall velocity, and critical velocity of calcareous sand based on recent research are applied to the models and the results are compared with the direct calculations and measured data. The comparison illustrates the important role particle shape plays in the transport of calcareous sand. All four sediment transport models give consistent predictions and good agreement with the majority of the measured data. Two of the models respond positively to the corrections in both the bed-form and suspended transport stages indicating that such an approach may provide an interim solution for the transport of calcareous sand.     

Influence of vegetation on aeolian sand transport rate from a backshore to a foredune at Hasaki, Japan

The influence of vegetation on aeolian sediment transport rate in the region from a backshore to a foredune was investigated at the Hasaki Coast in Japan, where an onshore wind was predominant and the creeping beach grasses Carex kobomugi and Calystegia soldanella were major species. The comparison of cross-shore distributions of the cross-shore component of aeolian sand transport rate with and without vegetation, which were estimated on the basis of the beach profile changes and a mass conservation equation, showed that the creeping grasses influenced the aeolian sand transport rate. The landward aeolian sand transport rate rapidly decreased landward from the seaward limit of vegetation when the grasses grew. The aeolian sand transport rate reduced by 95% with a vegetation cover of 28%. On the other hand, when the grasses were absent, the landward aeolian sand transport rate did not decrease near the seaward vegetation limit, but near the foot of the foredune.     

The initiation and development of metamorphic foliation in the Otago Schist, Part 2: evidence from quartz grain-shape data

Shape, size and orientation measurements of quartz grains sampled along two transects that cross zones of increasing metamorphic grade in the Otago Schist, New Zealand, reveal the role of quartz in the progressive development of metamorphic foliation. Sedimentary compaction and diagenesis contributed little to the formation of a shape‐preferred orientation (SPO) within the analysed samples. Metamorphic foliation was initiated at sub‐greenschist facies conditions as part of a composite S1‐bedding structure parallel to the axial planes of tight to isoclinal F1 folds. An important component of this foliation is a pronounced quartz SPO that formed dominantly by the effect of dissolution–precipitation creep on detrital grains in association with F1 strain. With increasing grade, the following trends are evident from the SPO data: (i) a progressive increase in the aspect ratio of grains in sections parallel to lineation, and the development of blade‐shaped grains; (ii) the early development of a strong shape preferred orientation so that blade lengths define the linear aspect of the foliation (lineation) and the intermediate axes of the blades define a partial girdle about the lineation; (iii) a slight thinning and reduction in volume of grains in the one transect; and (iv) an actual increase in thickness and volume in the survivor grains of the second transect. The highest‐grade samples, within the chlorite zone of the greenschist facies, record segregation into quartz‐ and mica‐rich layers. This segregation resulted largely from F2 crenulation and marks a key change in the distribution, deformation and SPO of the quartz grains. The contribution of quartz SPO to defining the foliation lessens as the previously discrete and aligned detrital quartz grains are replaced by aggregates and layers of dynamically recrystallized quartz grains of reduced aspect ratio and reduced alignment. Pressure solution now affects the margins of quartz‐rich layers rather than individual grains. In higher‐grade samples, therefore, the rock structure is characterized increasingly by segregation layering parallel to a foliation defined predominantly by mica SPO.     

Hydrothermal Quartz Vein Formation, Revealed by Coupled SEM-CL Imaging and Fluid Inclusion Microthermometry: Shuteen Complex, South Gobi, Mongolia

Abstract. Scanning electron microscopy-cathodoluminescence (SEM-CL) imaging of vein quartz in the Cu-mineralised, Shuteen Complex (South Gobi, Mongolia) has revealed a complex history of crystal growth, dissolution and microfracture healing, associated with several hydrothermal events that could not be detected using other observational techniques (e.g. transmitted/reflected light microscopy, back-scattered electron imaging, or secondary electron imaging).
The quartz initially grew as CL-bright/grey crystals in a 345±30C liquid reservoir, as inferred by the analysis of primary liquid fluid inclusions (average Th of 343C; 6.6∼7.7 wt% NaCl_eq). Quartz precipitation occurred at the edge of the crystals as reservoir fluids cooled to 260±25C, as indicated by micron-scale CL-dark/CL-bright quartz growth bands containing abundant fluid inclusions (with an average T_h values of 261C). Pressure fluctuations were the likely cause of dissolution, as SEM-CL imaging reveals the quartz have corroded or rounded crystal edges, and precipitation of later quartz into open space. SEM-CL imaging shows the quartz contains healed microfractures that trapped low salinity fluids (3.9 wt% NaC1_eq) with Th values of 173±15C.
SEM-CL imaging provides a means of deciphering the thermal and chemical evolution of the fossil Shuteen hydrothermal system, and the nature of hydrothermal quartz vein-forming processes, by facilitating the correlation of distinct fluid inclusion populations and their relative chronology, with specific hydrothermal events.     

Simplified Method for the Assessment of the Stiffness Anisotropy of Rocks at Small Strains

Summary A new, practically applicable method for characterizing the stiffness anisotropy of rocks is presented. The anisotropy of geo-materials is often ignored in engineering applications, with potentially serious ramifications, because of the number of parameters required for characterization. The elastic anisotropy has often been considered to be a function of mathematical symmetry, and the restrictions due to layering, microcracking and granularity of the materials have not been considered in the assessment of the anisotropy. The practicality of the method proposed here is achieved by rationally reducing the number of independent anisotropy parameters, typically 9 for orthotropic anisotropy, to a system of 4 independent parameters through a systematic theoretical and experimental analysis of these structural restrictions. These 4 parameters are shown to be sufficient for describing the anisotropy of some rocks and sands at small strains, and parameter determination by back-analysis is demonstrated to be stable using appropriate measurement systems involving 9 elastic wave velocities even when the directions of anisotropic axes are unknown and the velocity data contains appreciable error.     

Mineralogy and geochemistry of a Late Permian coal in the Dafang Coalfield, Guizhou, China: influence from siliceous and iron-rich calcic hydrothermal fluids

This paper describes the influence of siliceous and iron-rich calcic low-temperature hydrothermal fluids (LTHF) on the mineralogy and geochemistry of the Late Permian No. 11 Coal (anthracitic, R_r=2.85%) in the Dafang Coalfield in northwestern Guizhou Province, China. The No. 11 Coal has high contents of vein ankerite (10.2 vol.%) and vein quartz (11.4 vol.%), with formation temperatures of 85 and 180 °C, respectively, indicating that vein ankerite and vein quartz were derived from low-temperature calcic and siliceous hydrothermal fluids in two epigenetic episodes. The vein quartz appears to have formed earlier than vein ankerite did, and at least three distinct stages of ankerite formation with different Ca/Sr and Fe/Mn ratios were observed.The two types of mineral veins are sources of different suites of major and trace metals. Scanning electron microscope and sequential extraction studies show that, in addition to Fe, Mg, and Ca, vein ankerite is the dominant source of Mn, Cu, Ni, Pb, and Zn in the coal, and the contents of these five elements are as high as 0.09% and 74.0, 33.6, 185, and 289 μg/g, respectively. In contrast, vein quartz is the main carrier mineral for platinum-group elements (PGEs) Pd, Pt, and Ir in the coal, and the contents of Pd, Pt, and Ir are 1.57, 0.15, and 0.007 μg/g, respectively. Sequential extraction showed a high PGE content in the silicate fraction, up to 10.4 μg/g Pd, 1.23 μg/g Pt, and 0.05 μg/g Ir, respectively. It is concluded that the formation of ankerite and quartz and the anomalous enrichment of trace elements in the No. 11 Coal in the Dafang Coalfield, Guizhou, result from the influx of calcic and siliceous low-temperature hydrothermal fluids.     

Fluid generation and evolution during exhumation of deeply subducted UHP continental crust: Petrogenesis of composite granite–quartz veins in the Sulu belt,China

Composite granite–quartz veins occur in retrogressed ultrahigh pressure (UHP) eclogite enclosed in gneiss at General's Hill in the central Sulu belt, eastern China. The granite in the veins has a high‐pressure (HP) mineral assemblage of dominantly quartz+phengite+allanite/epidote+garnet that yields pressures of 2.5–2.1 GPa (Si‐in‐phengite barometry) and temperatures of 850–780°C (Ti‐in‐zircon thermometry) at 2.5 GPa (~20°C lower at 2.1 GPa). Zircon overgrowths on inherited cores and new grains of zircon from both components of the composite veins crystallized at c. 221 Ma. This age overlaps the timing of HP retrograde recrystallization dated at 225–215 Ma from multiple localities in the Sulu belt, consistent with the HP conditions retrieved from the granite. The ε_Hf(t) values of new zircon from both components of the composite veins and the Sr–Nd isotope compositions of the granite consistently lie between values for gneiss and eclogite, whereas δ¹⁸O values of new zircon are similar in the veins and the crustal rocks. These data are consistent with zircon growth from a blended fluid generated internally within the gneiss and the eclogite, without any ingress of fluid from an external source. However, at the peak metamorphic pressure, which could have reached 7 GPa, the rocks were likely fluid absent. During initial exhumation under UHP conditions, exsolution of H₂O from nominally anhydrous minerals generated a grain boundary supercritical fluid in both gneiss and eclogite. As exhumation progressed, the volume of fluid increased allowing it to migrate by diffusing porous flow from grain boundaries into channels and drain from the dominant gneiss through the subordinate eclogite. This produced a blended fluid intermediate in its isotope composition between the two end‐members, as recorded by the composite veins. During exhumation from UHP (coesite) eclogite to HP (quartz) eclogite facies conditions, the supercritical fluid evolved by dissolution of the silicate mineral matrix, becoming increasingly solute‐rich, more ‘granitic’ and more viscous until it became trapped. As crystallization began by diffusive loss of H₂O to the host eclogite concomitant with ongoing exhumation of the crust, the trapped supercritical fluid intersected the solvus for the granite–H₂O system, allowing phase separation and formation of the composite granite–quartz veins. Subsequently, during the transition from HP eclogite to amphibolite facies conditions, minor phengite breakdown melting is recorded in both the granite and the gneiss by K‐feldspar+plagioclase+biotite aggregates located around phengite and by K‐feldspar veinlets along grain boundaries. Phase equilibria modelling of the granite indicates that this late‐stage melting records P–T conditions towards the end of the exhumation, with the subsolidus assemblage yielding 0.7–1.1 GPa at <670°C. Thus, the composite granite–quartz veins represent a rare example of a natural system recording how the fluid phase evolved during exhumation of continental crust. The successive availability of different fluid phases attending retrograde metamorphism from UHP eclogite to amphibolite facies conditions will affect the transport of trace elements through the continental crust and the role of these fluids as metasomatic agents interacting with the mantle wedge in the subduction channel.     

Genealogy of hypoplasticity and barodesy

This article is an attempt at providing an insight into the development of hypoplasticity (including barodesy, which is a recent development of hypoplasticity) as a theory elaborated since 1977, when the first version was published by the first author, until present. The multiplicity of the many versions published since then is hard to overlook. This article presents a review and insight into the evolution of a theory and the struggle to formulate a satisfactory constitutive law. Among the many proposed versions, we focus on those ones that can be seen as changes of paradigm. Copyright © 2016 John Wiley & Sons, Ltd.