仿鱼尾潜器推进系统的水动力分析

以开发适用于小型潜器的仿生操纵与推进系统为研究背景 ,对金枪鱼的月牙形尾鳍进行水动力分析。文中将金枪鱼的尾鳍处理为在做横移和摇摆的耦合运动的同时 ,以某一匀速向前运动的月牙形刚性尾翼。计算中应用了双曲面元和压力库塔条件 ,利用面元法计算分析该三维尾翼的非定常水动力性能。探讨了前进速度、横荡和摇首的幅度、频率及其相位差对推进性能的影响     

A new efficient 3D non-hydrostatic free-surface flow model for simulating water wave motions

A new three-dimensional, non-hydrostatic free surface flow model is presented. For simulating water wave motions over uneven bottoms, the model employs an explicit project method on a Cartesian the staggered gird system to solve the complete three-dimensional Navier–Stokes equations. A bi-conjugated gradient method with a pre-conditioning procedure is used to solve the resulting matrix system. The model is capable of resolving non-hydrostatic pressure by incorporating the integral method of the top-layer pressure treatment, and predicting wave propagation and interaction over irregular bottom by including a partial bottom-cell treatment. Four examples of surface wave propagation are used to demonstrate the capability of the model. Using a small of vertical layers (e.g. 2–3 layers), it is shown that the model could effectively and accurately resolve wave shoaling, non-linearity, dispersion, fission, refraction, and diffraction phenomena.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

山溪性可冲性强潮河口曹娥江高水位初步研究

应用多年的实测资料 ,分析了曹娥江河口高水位成因 ,结果表明 ,曹娥江河口洪水位具有山溪性和可冲性的特点 ,人类活动对高水位有较大影响。应用统计分析法和成因分析法推求 1 %设计高水位 ,讨论了成因分析法中上、下边界条件的选取 ,其选取原则对其他潮汐河口确定设计高水位具有借鉴意义     

Strength Analysis of Turret Mooring Productive/Storage Tanker

The longitudinal strength of turret mooring productive/storage tanker is studied.A numeri-cal example has been implemented according to the method presented in this paper to give practical il-lustration.From the results of the numerical example,it is concluded that the turret hole located near theforward of the amidships has small effect on the longitudinal strength of the ship hull.As for design ex-treme value of wave bending moment of storage tanker,statistic method is a more reasonablemethodology,especially with the consideration of the servere environmental conditions.The primary esti-mation of design section modulus of turret storage tanker can be determined by this design bending mo-ment.     

The Working Mechanism and An Analytic Method of the Deep Embedded Large Cylinder Structure

The large cylinder is a new-type structure that has been applied to harbor and offshore engineering. An analytic method of the relationship between loads and the structure displacement is developed based on the failure mode of deep embedded large cylinder structures. It can be used to calculate directly the soil resistance and the ultirnate bearing capacity of the structure under usage. A new criterion of the large cylinder structure, which discriminates the deep embedded cylinder from the shallow embedded cylinder, is defined. Model tests prove that the proposed method is feasible for the analysis of deep embedded large cylinder structures.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

Acoustic plane-wave scattering from a rough surface over a random fluid medium

Acoustic plane-wave scattering from a rough surface overlying a fluid half-space with a sound-speed distribution subject to a small random variation is considered. Under the assumption that the surface roughness and medium randomness are statistically independent, the scattered field may be derived by first solving for the mean field in the medium, and then incorporating with boundary-perturbation method to obtain the total mean field and the power spectral density of the scattered field. The employed algorithm is compatible to the analysis available in the existing literature so that the formulations are conveniently integrated. The results for the power spectral density have shown that the effects of medium inhomogeneities on the rough surface scattering are limited in a spectral regime where the scattered components have shallow grazing angles. The distribution of the power spectral density over the space is primarily governed by the power spectrum and correlation lengths of the rough surface.     

双层局部开孔板沉箱对波浪反射的理论研究

提出了一种用于研究由双层开孔板和一个不透水后板的开孔结构对斜向波反射率的理论分析方法。整个流域被分成三个子域，在每个子域内应用特征函数展开法以得到该域内包含未知展开系数的势函数的表达式，在速度势的展开中，考虑了非传播模态波浪的影响。通过匹配开孔板处的边界条件可以求解待定的展开系数，继而求解双层开孔板防波堤结构对斜向波的反射率。数值计算结果与试验结果进行了比较，符合较好。并进一步讨论了几个重要因素对反射系数的影响。