致密砂岩的形成机制及其地质意义——以塔里木盆地英南2井为例

砂质岩的孔隙和喉道被网格状粘土矿物和次生加大矿物充填成微细孔喉状结构时,形成具有较高毛细管压力的致密砂岩。它与地层水发生水锁效应,可大大降低渗透率,成为致密砂岩盖层。当含水饱和度在50%以下时,束缚水饱和度比较低,致密砂岩储层可以产气;当含水饱和度在50%～90%区间时,具有较高的束缚水饱和度,相对渗透率非常低,它既不能产气也不能产水,反映为渗透率瓶颈区(具有盖层性质);当含水饱和度大于90%以上时,致密砂岩储层仅微量产水。塔里木盆地英南2井侏罗系气藏盖层由致密砂岩构成,不含水时的气体渗透率在(0.027～0.081)×10-3μm2,不能构成封堵;当含水饱和度达到60%以上时,相对渗透率几乎为零,构成有效盖层。     

Primary Ore Mineral Assemblage and Fluid Inclusion Study of the Batu Hijau Porphyry Cu-Au Deposit, Sumbawa, Indonesia

Abstract. The Batu Hijau porphyry Cu‐Au deposit, Sumbawa Island, Indonesia, is associated with a tonalitic intrusive complex. The temperature‐pressure condition of mineralization at the Batu Hijau deposit is discussed on the basis of fluid inclusion microthermometry. Then, the initial Cu‐Fe sulfide mineral assemblage is discussed. Bornite and chalcopyrite are major copper ore minerals associated with quartz veinlets. The quartz veinlets have been classified into ‘A’ veinlets associated with bornite, digenite, chalcocite and chalcopyrite, ‘B’ veinlets having chalcopyrite bornite along vuggy center‐line, rare ‘C’ chalcopyrite‐quartz veinlets, and late ‘D’ veinlets consisting of massive pyrite and quartz (Clode et al., 1999). Copper and gold mineralization is associated with abundant ‘A’ quartz veinlets. Abundant fluid inclusions are found in veinlet quartz consisting mainly of gas‐rich inclusions and polyphase inclusions throughout the veinlet types. The hydrothermal activity occurred in temperature‐pressure conditions of aqueous fluid immiscibility into hypersaline brine and dilute vapor. The halite dissolution (Tm[halite]) and liquid‐vapor homogenization (Th) temperatures of the polyphase inclusions in veinlet quartz range from 270 to 472d?C and from 280 to 454d?C, respectively. The estimated salinity ranges from 36 to 47 wt% (NaCl equiv.). The apparent pressures lower than 300 bars are estimated to have been along the liquid‐vapor‐halite curve for the fluid inclusions having the Th lower than the Tm that trapped the brine saturated with halite, or at slightly higher pressure relative to liquid‐vapor‐halite curve for the fluid inclusions having the Th higher than the Tm that trapped the brine unsaturated with halite. The actual temperature and pressure during the hydrothermal activity at the Batu Hijau deposit are estimated to have been around 300d?C and 50 bars. At such temperature‐pressure conditions, the principal and initial Cu‐Fe sulfide mineral assemblages are thought to be chalcopyrite + bornite solid solution (bnss) for the chalcopyrite‐bearing assemblage, and chalcocite‐digenite solid solution and bnss for the chalcopyrite‐free assemblage.     

Geologic and geotechnical effects of an impact caused by an airplane crash

A Turkish Airlines (THY) Boeing 737-400 plane crashed into alluvial soils creating an approximately 13 m deep and 30 m wide crater near the village of Adatepe, Ceyhan in southern Turkey. Effects of the impact on the soils in and around the crater were investigated from both the geological and soil mechanics point of view.

The results show that the impact caused severe deformations in the soils in and around the crater. The soils deformed similar to metamorphic rocks seen at many terrestrial hypervelocity impact craters around the world and became overconsolidated up to a distance of about 10 m from the crater wall as a result of the impact.

Also, the crash was recorded as a 2.7 magnitude earthquake by a nearby microtremor seismograph which provided both the location (epicenter) and time of the crash which was not known immediately after the crash.     

钻孔灌注桩后压浆作用机理与应用

通过对桩侧和桩底后压浆,可大幅度提高钻孔灌注桩单桩承载力.应用桩-土理论分析了后压浆中浆液对土体及桩体的作用,并从分析影响桩基承载力的因素出发,研究了后压浆的作用机理.在渗透率小的地层中后压浆以压密注浆为主,在渗透率大的地层中后压浆以渗透注浆为主.为避免过分压裂土层,在压浆过程中应控制灌浆压力.压浆量是影响后压浆质量和提高单桩承载力的关键因素之一.     

PRESSURE GRADIENT FROM THE CONTRIBUTION OF BOTH GEOTHERMAL AND GRAVITY IN THE LITHOSPHERE

1 Introduction The pressure, a scalar quantity, is defined as P = F/S (F is force, S is the area for F) which can be widely used for both solid and fluid. The formula P = g ρh (g-gravitation acceleration,ρ-density, h-depth) is only used for even density static solid and fluid. The delivery of pressure in the fluid follows the law of Pascal, and the average pressure of uneven density fluid can be calculated with the formula of P = g ρh. The temperature influence on pressure is notHU Ba…     

箱形基础上浮病害整治技术

结合箱形基础不均匀上浮工程病害实例，综合分析了病害原因，提出了应用高压灌浆和抗浮锚杆工艺进行处治的方案。     

乌江渡水电站岩溶地区高压灌浆施工特殊情况的处理

乌江渡水电站扩机地下厂房防渗帷幕工程身处岩溶发育地区，工程地质条件复杂，地质构造以层间错动断层为主，并有部分陡倾角断层发育,岩层受构造挤压强烈，断层、节理、破碎带发育；水平岩溶、垂直岩溶发育。以此工程为例介绍了高压灌浆施工工艺，阐述了岩溶地区高压灌浆过程中出现的特殊问题并提出了处理措施。     

广西百色水电站边坡治理工程

文章通过广西右江百色水利枢纽地下发电厂房进水口与尾水洞高边坡的治理，介绍在此工程中具有特殊性的一些施工方法。该工程地质体为弱风化硅质泥岩夹泥化夹层、强风化含洞穴硅质泥岩石、强风化硅质岩及全强风化辉绿岩，地质条件非常复杂，对坡体的稳定极其不利。根据三维有限元的分析计算和国内有关权威专家的调查研究需施工1500kN、1000kN的锚索方能保证坡体的永久稳定。大吨位的锚索需锚固在强风化岩土体上，锚索设计采用能提高锚固力的防腐型压力分散锚索。通过现场锚索基本试验，其锚固力完全能满足工程需要。为保证进水口总体施工的进度，在施工进水口约30m高的垂直壁上的锚索时，笔者采用了通常施工中较少采用的垂直壁悬吊式施工法，满足了水电站的整体施工进度和要求。     

云南个（旧）-冷（墩）公路K22＋336回头湾段边坡治理工程研究

目前，在我国地质灾害防治及道路建设工程中，岩土锚固施工大多采用单一的拉力型锚索工法。一般锚索索体的长效防腐问题没有得到应有的重视。文章对云南省个旧-冷墩公路边坡工程中所采用的压力分散型锚索工法从设计、试验及成功应用等多方面进行了详细介绍。①在一些复杂地形条件下，锚索防护方案有其独特的经济实用性。②在地基承载力较低的软弱地层中，常用的拉力型锚索无法提供防护工程所需的大吨位锚固力。而有多个受力体的压力分散型锚索则因其对锚固段全长范围内地基承载力的充分利用来提供较大吨位的锚固力；③永久锚索防护工程作为一项具有隐蔽性强特点的结构工程，为保证在其报务年限内锚索能够可靠地工作，在设计阶段，锚索体的长效防腐应为不能忽略的主要考虑因素。在该工程中首次应用了新型高强材料——环氧全喷涂无粘结钢绞线作为锚索体的杆材，较好地解决了永久锚固工程中的锚索防腐问题。     

Polymorphic phase transition in Superhydrous Phase B

We synthesized superhydrous phase B (shy-B) at 22 GPa and two different temperatures: 1200°C (LT) and 1400°C (HT) using a multi-anvil apparatus. The samples were investigated by transmission electron microscopy (TEM), single crystal X-ray diffraction, Raman and IR spectroscopy. The IR spectra were collected on polycrystalline thin-films and single crystals using synchrotron radiation, as well as a conventional IR source at ambient conditions and in situ at various pressures (up to 15 GPa) and temperatures (down to −180°C). Our studies show that shy-B exists in two polymorphic forms. As expected from crystal chemistry, the LT polymorph crystallizes in a lower symmetry space group (Pnn2), whereas the HT polymorph assumes a higher symmetry space group (Pnnm). TEM shows that both modifications consist of nearly perfect crystals with almost no lattice defects or inclusions of additional phases. IR spectra taken on polycrystalline thin films exhibit just one symmetric OH band and 29 lattice modes for the HT polymorph in contrast to two intense but asymmetric OH stretching bands and at least 48 lattice modes for the LT sample. The IR spectra differ not only in the number of bands, but also in the response of the bands to changes in pressure. The pressure derivatives for the IR bands are higher for the HT polymorph indicating that the high symmetry form is more compressible than the low symmetry form. Polarized, low-temperature single-crystal IR spectra indicate that in the LT-polymorph extensive ordering occurs not only at the Mg sites but also at the hydrogen sites.