论卡以头组的时代

中国科学院南京地质古生物研究所的有关人员 (1980 )曾做过大量地层古生物工作 ,证实卡以头砂页岩层或卡以头组的时代为三叠纪最早期 ,是飞仙关组底部地层的相变。“论卡以头组”一文认为该组下部的时代为二叠纪 ,上部则属三叠纪。对该文提供的地层古生物资料进行分析后 ,本文作者认为该论点缺乏证据 ,不能成立 ;将陆相的威宁哲觉剖面代替标准地点宣威羊场的过渡相剖面作为卡以头组的标准剖面 ,也是不合适的     

H2O-CH4-H2-CO2-CO-O2在高温、高压和高密度条件下的状态方程

为了计算高温，高压和高密度流体的热力学性质，提出了一个具有19个参数的维里型状态方程，其中参数与温度间的函数关系采用由Sutherland位能函数导出的维里系数近似式。除临界点附近以外，在已报道的pVT数据所覆盖的大部分超临界区域内，该方程均可适用。用该方程对H2O，CH4，H2，CO2，CO和O2等流体pVT关系的计算结果令人满意，其中pVT上限分别为：91-610GPa,1.6-11.0cm^3/mol,4000-5000K。计算体积的平均偏 小于0．8％，最大偏差小于5．4％。     

离散裂隙渗流方法与裂隙化渗透介质建模

流体渗流模拟的连续介质方法通常适用于多孔地质体，并不一定适用于裂隙岩体，由于裂隙分布及其特征与孔隙差异较大。若流体渗流主要受裂隙的控制，对于一定尺寸的裂隙岩体，多孔介质假设则较难刻划裂隙岩体的渗流特征。离散裂隙渗流方法不但可直接用于模拟裂隙岩体非均质性和各向异性等渗流特征，而且可用其确定所研究的裂隙岩体典型单元体及其水力传导（渗透）张量大小。主要讨论了以下问题：（1）饱和裂隙介质中一般的离散流体渗流模拟；（2）裂隙岩体中的REV（典型单元体）及其水力传导（渗透）张量的确定；（3）利用离散裂隙网络流体渗流模型研究裂隙方向几何参数对水力传导系数和REV的影响；（4）在二维和三维离散裂隙流体渗流模型中对区域大裂隙和局部小裂隙的处理方法。调查结果显示离散裂隙流体渗流数学模型可用来评价不同尺度上的裂隙岩体的水力特征，以及裂隙方向对裂隙化岩体的水力特征有着不可忽视的影响。同时，局部小裂隙、区域大裂隙应当区别对待，以便据其所起的作用及水力特征，建立裂隙化岩体相应的流体渗流模型。     

华北克拉通北部内、外缘中生代流体成矿作用研究--以大井、蔡家营典型矿床为例

华北克拉通北部内、外缘中生代形成的有色金属矿种繁多 ,以外缘富 Sn、内缘富 Mo,Cu、Pb、 Zn遍布内、外缘为主要特色。通过内、外缘典型矿床的研究和综合对比 ,认为外缘的富 Sn是与富 Sn的基底有关 ,内缘的富 Mo是与结晶基底地层和岩浆热液关系密切。而内、外缘 Cu、 Pb、 Zn的成矿与中生代构造转折 ,造成大规模陆相火山活动和成矿流体的卸载密切相关     

川滇密西西比河谷型铅锌矿床成矿流体来源研究:流体Na-Cl-Br体系的证据

应用流体包裹体滤液分析方法，测定了川滇7个MVT铅锌矿床成矿流体的Na,Cl,Br含量，结果表明成矿流体的x(Na/Br)和x(Cl/Br)的平均值分别为185和73，并与高度蒸发浓缩的残留海水的x(Na/Br)和x(Cl/Br)相近。成矿流体的Na,Cl含量呈正相关，在lgNa-lgCl图解中呈线性分布。根据这些事实以及矿床地质特征，认为原始成矿卤水起源于蒸发浓缩的残留海水，原始含矿卤水与富含有机质的大气降水混合导致矿质沉淀而成矿。     

Origin of Gold—Bearing Fluid and Its Initiative Localization Mechanism in Xiadian Gold Deposit,Shandong Province

The composition of quartz inclusions and trace elements in ore indicate that gold-bearing fluid in the Xiadian gold deposit,Shandong Province,stemmed from both mantle and magma,belonging to a composite origin.Based on theoretical analysis and high temperature and high pressure experimental studies,gold-bearing fluid initiative localization mechanism and the forming environment of ore-host rocks are discussed in the present paper.The composite fluid extracted gold from rocks because of its expanding and injecting forces and injecting forces and flew through ore-conducive structures,leading to the breakup of rocks.The generation of ore-host faults and the precipitation of gold-bearing fluid occurred almost simultaneously.This study provides fur-ther information about the relationships between gold ore veins and basic-ultrabasic vein rocks and intermediate vein rocks,the spatial distribution of gold ore veins and the rules governing the migration of ore fluids.     

Constraints on the application of carbon isotope thermometry in high- to ultrahigh-temperature metamorphic terranes

Nine marble horizons from the granulite facies terrane of southern India were examined in detail for stable carbon and oxygen isotopes in calcite and carbon isotopes in graphite. The marbles in Trivandrum Block show coupled lowering of δ¹³C and δ¹⁸O values in calcite and heterogeneous single crystal δ¹³C values (? 1 to ? 10‰) for graphite indicating varying carbon isotope fractionation between calcite and graphite, despite the granulite facies regional metamorphic conditions. The stable isotope patterns suggest alteration of δ¹³C and δ¹⁸O values in marbles by infiltration of low δ¹³C–δ¹⁸O‐bearing fluids, the extent of alteration being a direct function of the fluid‐rock ratio. The carbon isotope zonation preserved in graphite suggests that the graphite crystals precipitated/recrystallized in the presence of an externally derived CO₂‐rich fluid, and that the infiltration had occurred under high temperature and low f_O2 conditions during metamorphism. The onset of graphite precipitation resulted in a depletion of the carbon isotope values of the remaining fluid+calcite carbon reservoir, following a Rayleigh‐type distillation process within fluid‐rich pockets/pathways in marbles resulting in the observed zonation. The results suggest that calcite–graphite thermometry cannot be applied in marbles that are affected by external carbonic fluid infiltration. However, marble horizons in the Madurai Block, where the effect of fluid infiltration is not detected, record clear imprints of ultrahigh temperature metamorphism (800–1000 °C), with fractionations reaching <2‰. Zonation studies on graphite show a nominal rimward lowering δ¹³C on the order of 1 to 2‰. The zonation carries the imprint of fluid deficient/absent UHT metamorphism. Commonly, calculated core temperatures are > 1000 °C and would be consistent with UHT metamorphism.     

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

Paleoecology of a Middle Wisconsin Deposit from Southern California

Analysis of a buried deposit in the Diamond Valley of southern California has revealed well-preserved pollen, wood, and diatom remains. Accelerator mass spectrometry dates of 41,200±2100 and 41,490±1380 ¹⁴C yr B.P. place this deposit in marine isotope stage 3. Diatoms suggest a shallow lacustrine environment. Pollen data suggest that several plant communities were present near the site, with grassland, scrub, chaparral, forest, and riparian communities represented. Comparison with modern pollen suggests similarities with montane forests in the nearby San Bernardino and San Jacinto ranges, indicating vegetation lowering by at least 900 m elevation and temperatures 4°–5°C cooler than today. An increase in high-elevation conifer pollen documents climatic cooling near the profile top. Early-profile diatoms are typical of warm water with high alkalinity and conductivity, whereas later diatoms suggest a higher flow regime and input of cooler water into the system. We suggest that the sequence is part of the cooling phase of an interstadial Dansgaard–Oeschger cycle. Records of the middle Wisconsin period are rare in southern California, but the Diamond Valley site is similar to records from Tulare Lake in the San Joaquin Valley and the ODP Site 893A record from Santa Barbara Basin. It is probable that the Diamond Valley assemblage is a local expression of a vegetation type widespread in the ranges and basins of southwestern California during the middle Wisconsin.     

交流变频调速CD-2B型岩心钻机的研制

介绍了交流变频调速CD－2B型岩心钻机研制情况，技术参数，主要特点及型式检验，生产试验等情况。