低应变测桩常见缺陷分析

低应变法检测桩身完整性,作为一种快速、经济、可靠的方法目前得以广泛应用。当桩身存在明显缺陷(缩径、扩径、离析、断桩等),传感器在接收到桩底反射信号前会记录下桩身缺陷的反射干扰,熟练掌握动测曲线的分析方法,则能够快速、准确的判断出桩身完整性。本文结合传统的行波理论知识,通过理论分析和图文说明,对低应变反射波法动测曲线常见缺陷给出理论分析,并结合工程实例加以验证。     

Coupled hydro-mechanical model for partially saturated soils predicting small strain stiffness

In the paper, we present newly developed hydro-mechanical hypoplastic model for partially saturated soils predicting small strain stiffness. Hysteretic void ratio dependent water retention model has been incorporated into the existing hypoplastic model. This required thorough revision of the model structure to allow for the hydro-mechanical coupling dependencies. The model is formulated in terms of degree of saturation, rather than of suction. Subsequently, the small strain stiffness effects were incorporated using the intergranular strain concept modified for unsaturated conditions. New features included degree of saturation-dependent size of the elastic range and an updated evolution equation for the intergranular strain. The model has been evaluated using two comprehensive data sets on completely decomposed tuff from Hong-Kong and Zenos Kaolin from Iran. It has been shown that the modified intergranular strain formulation coupled with the hysteretic water retention model correctly reproduces the effects of both the stress and suction histories on small strain stiffness evolution. The model can correctly predict also different other aspects of partially saturated soil behaviour, starting from the very small strain range up to the asymptotic large-strain response.     

东昆仑东段东昆中构造带韧性剪切作用及其地质意义

东昆仑东段东昆中构造带经历了多期(次)构造事件,现今保留了复杂多样的构造样式。哈图沟、清水泉—塔妥和沟里等地区构造变形十分强烈,且发育有呈NWW-SEE展布的韧性剪切带。通过野外调研及显微构造研究,对东昆中构造带几何学、运动学及动力学等进行了分析,并通过费氏台和EBSD技术对其进行石英C轴组构分析后认为该剪切带为一压-扭性构造界面,且早期为左旋逆冲,晚期为右旋走滑,变形温度为400~550℃。对剪切带内的石英亚颗粒及动态重结晶粒度测量计算出研究区内韧性剪切带古应力值约为153.791 MPa。哈图沟牦牛山组变形砾岩(4个测点)有限应变测量结果显示,越靠近东昆中断裂带砾石Flinn指数、应变程度、罗德系数(绝对值)越大,且Flinn指数均大于1,属拉伸变形。结合区域地质资料,认为东昆仑东段东昆中韧性剪切带形成于晚海西—印支期。     

绳索取心钻杆丝扣结构力学仿真分析

以饱89 mm绳索取心钻杆为分析研究对象,对其连接丝扣部分建立准三维模型,运用CAE有限元软件AN-SYS对其进行接触非线性力学分析,得出钻杆连接丝扣处等效应力及变形云图,结果显示最大等效应力出现的位置及变形状态与钻探现场钻杆常见断裂位置及形态完全一致,表明所采用的研究手段和方法切实可行。     

BG型钻杆排放设备的设计与应用

传统接卸钻杆多采用人工对扣、拖拽摆放方式,效率较低,工人劳动强度大。针对目前流行的可抬头式全液压钻机,设计了一种BG型自动钻杆排放设备,该设备通过机械手与夹持器2个机构与抬头式动力头配合完成钻杆的自动化接卸、摆放。详细介绍了机械手结构设计与回转驱动选型、夹持器结构设计与夹持油缸选型以及液压系统的设计思路,从理论上确定设备的可靠性。最后通过现场试验验证了BG型自动钻杆排放设备的实用性。     

地埋管地源热泵技术在贵州岩溶地区的应用研究

地埋管热泵技术是采集地表以下200 m深度内的浅层地热能进行供热制冷的新型能源利用技术,而该技术在贵州碳酸盐岩分布区的应用和推广之所以受到制约,其主要原因是岩溶地层中建造垂直换热孔的难度大、成本较高。通过贵州省有色科技大楼附楼采用垂直地埋管式与基础桩螺旋盘管式有效组合的换热系统,在岩溶一般至中等发育的碳酸盐岩地层中开发利用浅层地热能的成功经验的介绍,为地埋管热泵技术在贵州岩溶地区的应用和推广提供参考。     

三轴应力状态下盐岩强度分析探讨

通过分析盐岩在三轴应力状态下的变形,说明了较高围压下盐岩的大变形特性,提出了三轴应力状态下,利用轴向荷载除以试件初始横截面面积得到应力-应变关系存在的问题,据此对工程应变和对数应变进行了分析和对比,阐明了这两种应变的适用条件,并开展了不同围压下的试验测试和对试验结果对比分析。研究揭示了应利用对数应变分析盐岩的大变形特性和对变形后的应力进行修正,得到了盐岩的工程应变和对数应变均可表示为围压的线性函数,围压为20 MPa时的轴向压缩变形量是5 MPa时的3.09倍。围压越高,对数应变修正得到的最大轴向应力与不修正的差值越大,用对数应变修正后的轴向应力低于不修正的结果,围压达到20 MPa时,前者仅为后者的63.85%。     

东川-易门式铜矿床成矿作用研究的几个问题

从宏观基础地质入手,按矿床学的一些基本概念,针对东川-易门铜矿床地质地球化学特征,探讨了一些存在争议的重要问题。研究认为:狮山段是绿汁江组下部独立存在的地层层位;东川-易门式铜矿床属沉积-改造成因,其中的层状铜矿属沉积成岩成因,不是"热液成矿";所谓东川-易门式矿床(稀矿山除外)为"喷流沉积成矿"或"岩浆叠加",尚依据不足;刺穿体是构造作用产物,对成矿有利,是良好的找矿标志,其中的角砾岩主要是沉积角砾岩与构造角砾岩,或沉积-构造角砾岩,不足以冠名"隐爆角砾岩(筒)"。     

A high strain‐rate constitutive model for sand and its application in finite‐element analysis of tunnels subjected to blast

The paper presents a constitutive model for simulating the high strain‐rate behavior of sands. Based on the concepts of critical‐state soil mechanics, the bounding surface plasticity theory and the overstress theory of viscoplasticity, the constitutive model simulates the high strain‐rate behavior of sands under uniaxial, triaxial and multi‐axial loading conditions. The model parameters are determined for Ottawa and Fontainebleau sands, and the performance of the model under extreme transient loading conditions is demonstrated through simulations of split Hopkinson pressure bar tests up to a strain rate of 2000/s. The constitutive model is implemented in a finite‐element analysis software Abaqus to analyze underground tunnels in sandy soil subjected to internal blast loads. Parametric studies are conducted to examine the effect of relative density and type of sand and of the depth of tunnel on the variation of stresses and deformations in the soil adjacent to the tunnels. Copyright © 2012 John Wiley & Sons, Ltd.