MONITORING THE DIFFUSION OF SUSPENDED SEDIMENTS AND STABILITY OF TIDAL RADIAL SAND RIDGES AREA USING MULTI-SATELLITE REMOTE SENSING DATA

Nine Landsat TM tapes and images and MSS images, 10 NOAA tapes and images and 1 SAR image from 1973 to 1997 were used to analyse the diffusion of suspended sediments and the change of tidal radial sand ridges in the northern part of the Changjiang River delta, the South Yellow Sea. The results showed that the diffusion of suspended sediments was controlled by the tide, net current, and submarine topography in this area. The distribution of suspended sediments had close relationship with thesubmarine topography. The old Huanghe River delta and the Changjiang River comprise the main sediment supply for the formation of radial sand ridges, whose evolution can be divided into three stages since the Huangbe River changed its course and flowed northward into the Bohai Sea.     

SOHM-4与MHM-2010氢原子频标的特点比较

基于对已投入国家授时中心守时运转的SOHM-4型与MHM-2010型氢原子频标的长期关注,对这两种氢原子频标的性能作了较详细的比较和分析。讨论了它们共同的优点、各自的特长和不足之处,还给出了稳定度的测试结果。     

RETRACTION: Numerical simulation of a wind-sand flow under different conditions of atmospheric stability

A theoretical model for wind‐sand flow is developed by considering the coupling between wind flow and sand particle motion, the latter subject to the Magnus effect, under different atmospheric stability conditions. Using this model, the characteristics of the wind‐sand flow are discussed in detail. The results show that the atmospheric stability and the Magnus effect both have a strong influence on wind profiles and on the trajectories of sand particles. This approach produces results with characteristics that differ from those previously reported; the latter only applying to atmospheric conditions of neutral stability. The saltating sand reaches a greater height under non‐neutral stability than under neutral stability, while the maximum horizontal distance is greater under unstable conditions and is smaller under stable conditions than under conditions of neutral stability.     

Sensitivity analysis of support safety factor for predicting the effects of contributing parameters on roof falls in underground coal mines

Roof falls accounted for 18.18% of all fatal accidents in Indian coal mines, contributing about 35.29% of all fatal accidents in below-ground operations in 2005. The support safety factor, always preferred in support planning and design of underground coal mines, may be an important predictor for roof falls. In this paper, geotechnical data were collected from 14 roof fall incident places in an underground coal mine, located in the Eastern India, which has bord and pillar method of workings. The mean value of probabilistic support safety factor for the case study mine was found to be 1.24. However, the probability, of the estimated support safety factor of less than or equal to one, was found to be 0.246. Sensitivity analysis was conducted to analyze the effects of the contributing parameters on support safety factor and the likelihood of the roof fall. The multi-variate regression analysis was carried out for the data generated by Monte Carlo method to correlate the contributing factors to support safety factor. It ranked gallery width as the first parameter to control the support safety factor.     

Case history of controlling a landslide at Panluo open-pit mine in China

Controlling of landsides safely and economically is a great challenge to mine operators because landslides are major geological problems especially in open-pit mines. In this paper, a case history at Panluo open-pit mine is presented in detail to share the experiences and lessons with mine operators. Panluo open-pit mine is located in the southwestern Fujian province of China. It is the largest open-pit iron mine in the Fujian province and was planned in 1965 and is in full operation from 1978. In July 1990, an earthquake of magnitude 5.3 in Taiwan Strait and big rainstorms impacted the mine slope, causing tension cracks and rather large-scale failures, and forming a U-shaped landslide. Total potential volume was estimated to be up to 1.0 × 10⁶ m³. This directly threatened the mine production. In order to protect the mine production and the dwellers’ safety around, a dynamic comprehensive method was implemented including geotechnical investigations, in-situ testing and monitoring, stability analysis, and many mitigation and preventive measures. These measures slowed down the development and further occurrence of the landslide. The results showed that the landslides were still active, it was slowed with the control measures and moved rapidly with rainfall and mining down. However, no catastrophic accidents occurred and the pit mining was continued till it was closed at the elevation of 887 m in 2000. As a successful case of landslide control at an open-pit mine for 10 years, this paper reports the controlling measures in details. These experiences of landslide control may be beneficial to other similar mines for landslide control.     

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.     

Shear strength characterization of municipal solid waste at the Suzhou landfill, China

The current practice of slope stability analysis for a municipal solid waste (MSW) landfill usually overlooks the dependence of waste properties on the fill age or embedment depth. Changes in shear strength of MSW as a function of fill age were investigated by performing field and laboratory studies on the Suzhou landfill in China. The field study included sampling from five boreholes advanced to the bottom of the landfill, cone penetration tests and monitoring of pore fluid pressures. Twenty-six borehole samples representative of different fill ages (0 to 13 years) were used to perform drained triaxial compression tests. The field and laboratory study showed that the waste body in the landfill can be sub-divided into several strata corresponding to different ranges of fill age. Each of the waste strata has individual composition and shear strength characteristics. The triaxial test results showed that the MSW samples exhibited a strain-hardening and contractive behavior. As the fill age of the waste increased from 1.7 years to 11 years, the cohesion mobilized at a strain level of 10% was found to decrease from 23.3 kPa to 0 kPa, and the mobilized friction angle at the same strain level increasing from 9.9° to 26°. For a confinement stress level greater than 50 kPa, the shear strength of the recently-placed MSW seemed to be lower than that of the older MSW. This behavior was consistent with the cone penetration test results. The field measurement of pore pressures revealed a perched leachate mound above an intermediate cover of soils and a substantial leachate mound near the bottom of the landfill. The measurements of shear strength properties and pore pressures were utilized to assess the slope stability of the Suzhou landfill.     

An Attempt to Predict the Failure Time of Abandoned Mine Pillars

Summary  Left in place pillars of abandoned mines are subject to weathering (e.g action of water, bacteria) that degrades their mechanical strength and eventually leads to collapse. A simple weathering model is proposed, that is governed by two parameters: the rate of progression of weathered front and the rate of degradation of the compressive strength with time. Both plane strain and axisymmetric analyses are performed and closed form solutions of the variation with time of the bearing capacity of the pillar are given. Experimental data of the tests conducted on gypsum and anhydrite specimens attacked by water are presented. It is shown that in order to fit the experimental data a third parameter must be introduced. New closed form solutions are given and the data are used for estimating the time to failure of abandoned gypsum mines in Northern Italy. Authors’ address: Dr. Riccardo Castellanza, Research Assistant, Department of Structural Engineering, Milan University of Technology (Politecnico), Piazza Leonardo da Vinci 32, 20133 Milan, Italy     

Implementing low-cost landslide risk reduction: a pilot study in unplanned housing areas of the Caribbean

Landslides pose a serious physical and environmental threat to vulnerable communities living in areas of unplanned housing on steep slopes in the Caribbean. Some of these communities have, in the past, had to be relocated, at costs of millions of dollars, because of major slides triggered by tropical storm rainfall. Even so, evidence shows that: (1) risk reduction is a marginal activity; (2) there has been minimal uptake of hazard maps and vulnerability assessments and (3) there is little on-the-ground delivery of construction for risk reduction. This article directly addresses these issues by developing a low-cost approach to the identification of the potential pore pressure changes that trigger such slides we seek to address these three commentaries directly. A complex 45–60° slope site in St Lucia, West Indies was selected as a pilot for a modelling approach that uses numerical models (FLAC and CHASM) to verify the need for surface water management to effectively reduce landslide risk. Following the model confirmation, a series of drains were designed and constructed at the site. Post-construction evidence indicates the methodology to be sound, in that the site was stable in subsequent 1-in-1 to 1-in-4 year rainfall events. A critical feature of the approach is that it is community-based from data acquisition through to community members participating in construction.