Effect of Multipoint Heterogeneity on Nonlinear Transformations for Geological Modeling： Porosity-Permeability Relations Revisited

An analysis of statistical expected values for transformations is performed in this study to quantify the effect of heterogeneity on spatial geological modeling and evaluations. Algebraic transformations are frequently applied to data from logging to allow for the modeling of geological properties. Transformations may be powers, products, and exponential operations which are commonly used in well-known relations (e.g., porosity-permeability transforms). The results of this study show that correct computations must account for residual transformation terms which arise due to lack of independence among heterogeneous geological properties. In the case of an exponential porosity-permeability transform, the values may be positive. This proves that a simple exponential model back-transformed from linear regression underestimates permeability. In the case of transformations involving two or more properties, residual terms may represent the contribution of heterogeneous components which occur when properties vary together, regardless of a pair-wise linear independence. A consequence of power- and product-transform models is that regression equationswithin those transformations need corrections via residual cumulants. A generalization of this result isthat transformations of multivariate spatial attributes require multiple-point random variable relations. This analysis provides practical solutions leading to a methodology for nonlinear modeling using correct back transformations in geology.     

水平井含水率上升影响因素

利用塔里木油田塔中4油田(TZ4)底水油藏相关的地质、流体数据建立数值模型。在所建模型的基础上,应用数值模拟计算的累积产油、产水和产液量回归俞启泰水驱特征曲线,以反映水平井见水特征的参数b。以参数b为研究对象,采用正交试验的方法研究不同因素对b值的影响,筛选影响水平井见水特征的主要因素,认为原油粘度、油层厚度、非均质性及水平井水平段在油藏中的位置是影响水平井含水上升趋势的主要指标。最后建立主要因素与b值的关系式,结合俞启泰曲线b值图版,提出预测水平井见水规律的公式——图版法(F-b法)。应用F-b法对塔里木水平井含水率进行预测,并与其他相关方法及实际生产数据对比,认为F-b法可作为预测塔里木油田水平井含水率、估算可采储量的一种有效方法。     

火山沉积岩及其矿床研究中伽马测井曲线解释的误区

根据酸性凝灰岩和酸性火山事件粘土岩的自然伽马测井曲线,对当前流传的"沉积岩层的放射性强度(或放射性核素的含量)随泥质含量的增加而增高"的概念和用自然伽马值及经验公式求泥质含量提出质凝。酸性凝灰岩的自然伽马曲线有高异常响应,若解释为泥岩显然是误解,故将沉积岩伽马曲线高异常一律解释为泥岩是片面的。各类火山事件粘土岩的伽马值相差悬殊,但其泥质含量几乎相等,用它们的伽马值计算泥质含量误差甚大。最后对铝土矿层的伽马曲线稍加解释,指出核测井应用的远景。     

岩石中的渗透率、流体流动及热液成矿作用

热液成因的固体金属矿床形成过程中都曾拥有一段流动的历史。成矿物质以溶液的形式从矿源地穿过孔隙或断裂达到了现在的栖身之所,在此过程中流体通过的路径决定了它们的走向,而溶液本身也改变了路径的特征。因此,对于此类矿床的研究不能仅仅囿于眼之所见,而应将古流体流动的观念融入其中,并考察它们的跋涉之路。文中总结了近年来国内外在岩石孔隙、断裂介质及与其相关渗透率对热液成矿作用的控制等领域的研究成果和最新进展,对岩石渗透率、渗透率的影响因素、岩石中流体流动的特征等问题进行了阐述,讨论了渗透率对于热液成矿作用深度、成矿规模、矿质沉淀机制等方面的重要影响,藉此在固体金属矿床研究中强化流"体运动"的观念,并促进构造地质学和成矿作用地球化学间一个新研究方向的发展。     

Using Sequential Self-Calibration Method to Identify Conductivity Distribution: Conditioning on Tracer Test data

An iterative inverse method, the sequential self-calibration method, is developed for mapping spatial distribution of a hydraulic conductivity field by conditioning on nonreactive tracer breakthrough curves. A streamline-based, semi-analytical simulator is adopted to simulate solute transport in a heterogeneous aquifer. The simulation is used as the forward modeling step. In this study, the hydraulic conductivity is assumed to be a deterministic or random variable. Within the framework of the streamline-based simulator, the efficient semi-analytical method is used to calculate sensitivity coefficients of the solute concentration with respect to the hydraulic conductivity variation. The calculated sensitivities account for spatial correlations between the solute concentration and parameters. The performance of the inverse method is assessed by two synthetic tracer tests conducted in an aquifer with a distinct spatial pattern of heterogeneity. The study results indicate that the developed iterative inverse method is able to identify and reproduce the large-scale heterogeneity pattern of the aquifer given appropriate observation wells in these synthetic cases.     

松辽盆地宋芳屯油田扶杨油层孔隙结构及其影响因素

通过镜下观察,宋芳屯油田扶杨油层孔隙类型较多,以粒间孔为主。细管压力曲线上看,曲线较陡,分选差,孔隙结构特征参数总体上较差,与孔隙度、渗透率有一定的关系,大的孔隙对渗透率的贡献最大。扶杨油层的孔隙结构较复杂主要由于成岩作用影响,压实作用使孔隙空间显著缩小,胶结作用和自生粘土矿物生长使孔隙进一步缩小和复杂化,后期的溶蚀作用使孔隙空间增加。     

饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Reservoir description using dynamic parameterisation selection with a combined stochastic and gradient search

There is a correspondence between flow in a reservoir and large scale permeability trends. This correspondence can be derived by constraining reservoir models using observed production data. One of the challenges in deriving the permeability distribution of a field using production data involves determination of the scale of resolution of the permeability. The Adaptive Multiscale Estimation (AME) seeks to overcome the problems related to choosing the resolution of the permeability field by a dynamic parameterisation selection. The standard AME uses a gradient algorithm in solving several optimisation problems with increasing permeability resolution. This paper presents a hybrid algorithm which combines a gradient search and a stochastic algorithm to improve the robustness of the dynamic parameterisation selection. At low dimension, we use the stochastic algorithm to generate several optimised models. We use information from all these produced models to find new optimal refinements, and start out new optimisations with several unequally suggested parameterisations. At higher dimensions we change to a gradient-type optimiser, where the initial solution is chosen from the ensemble of models suggested by the stochastic algorithm. The selection is based on a predefined criterion. We demonstrate the robustness of the hybrid algorithm on sample synthetic cases, which most of them were considered insolvable using the standard AME algorithm.