Metamorphism and metamorphic K–Ar ages of the Mesozoic accretionary complex in Northland, New Zealand

Abstract A southwest dipping Mesozoic accretionary complex, which consists of tectonically imbricated turbiditic mudstone and sandstone, hemipelagic siliceous mudstone, and bedded cherts and basaltic rocks of pelagic origin, is exposed in northern North Island, New Zealand. Interpillow limestone is sometimes contained in the basaltic rocks. The grade of subduction‐related metamorphism increases from northeast to southwest, indicating an inverted metamorphic gradient dip. Three metamorphic facies are recognized largely on the basis of mineral parageneses in sedimentary and basaltic rocks: zeolite, prehnite‐pumpellyite and pumpellyite‐actinolite. From the apparent interplanar spacing d₀₀₂ data for carbonaceous material, which range from 3.642 to 3.564 Å, the highest grade of metamorphism is considered to have attained only the lowermost grade of the pumpellyite‐actinolite facies for which the highest temperature may be approximately 300°C. Metamorphic white mica K–Ar ages are reported for magnetic separates and <2 µm hydraulic elutriation separates from 27 pelitic and semipelitic samples. The age data obtained from elutriation separates are approximately 8 m.y. younger, on average, than those from magnetic separates. The age difference is attributed to the possible admixture of nonequilibrated detrital white mica in the magnetic separates, and the age of the elutriation separates is considered to be the age of metamorphism. If the concept, based on fossil evidence, of the subdivision of the Northland accretionary complex into north and south units is accepted, then the peak age of metamorphism in the north unit is likely to be 180–130 Ma; that is, earliest Middle Jurassic to early Early Cretaceous, whereas that in the south unit is 150–130 Ma; that is, late Late Jurassic to early Early Cretaceous. The age cluster for the north unit correlates with that of the Chrystalls Beach–Taieri Mouth section (uncertain terrane), while the age cluster for the south unit is older than that of the Younger Torlesse Subterrane in the Wellington area, and may be comparable with that of the Nelson and Marlborough areas (Caples and Waipapa terranes).     

Estimating the seismic displacement of friction pendulum isolators based on non‐linear response history analysis

A procedure for developing equations that estimate the isolator displacement due to strong ground motion is applied to buildings isolated with the friction pendulum system. The resulting design equations, based on rigorous non‐linear analysis, offer an alternative to the iterative equivalent‐linear methods used by current U.S. building codes. The governing equations of the system are reduced to a form such that the median normalized displacement of the system due to an ensemble of ground motions is found to depend on only the isolation period—a function of the curvature of the isolator—and the friction force at incipient slip normalized by peak ground velocity. The normalization is effective in minimizing the dispersion of the normalized displacement for an ensemble of ground motions, implying that the median normalized displacement is a reliable estimate of response. The design equations reflect the significant (20 to 38%) increase in displacement when the excitation includes two lateral components of ground motion instead of just one component. Equivalent‐linear methods are shown to underestimate by up to 30% the exact median displacement determined by non‐linear response history analysis for one component of ground motion, and building codes include at most a 4.4% increase for a second component. Copyright © 2003 John Wiley & Sons, Ltd.     

新疆葡萄产品的优势及其生态气候条件评价

新疆生产的品质优良和用途广泛的无公害葡萄产品，是干旱荒漠区得天独厚的生态气候条件造就的结果。与国内东部葡萄产区相比，最大的优势是干热气候条件和稳定的灌溉水源；不利条件是冬季寒冷，春季灾害天气多、缺水，对葡萄生长有影响。     

柴达木盆地近40a气候变化及其对农业影响的研究

利用柴达木盆地6个代表站逐日平均气温、逐月降水资料以及逐日最低气温资料。对盆地40a来的气候变化特征进行分析。同时分析了气候变化对农业生产的影响。为充分利用变化了的农业气候资源。减少不利因素带来的影响提出了对策和建议。     

中国稻田甲烷产生和排放研究 Ⅰ.产生和排放机理及其影响因子

综合论述了近 2 0年来中国稻田甲烷排放的研究状况 ,包括中国稻田甲烷排放通量的观测 ,稻田甲烷生成的生物学机理及产生、转化、传输的机理研究 ,稻田甲烷排放的影响因子 ,主要介绍了稻田甲烷产生和氧化过程、影响甲烷排放的因子     

大别山太湖地区榴辉岩峰期变质条件与构造意义

大别山太湖地区曾被作为“冷”、“热”榴辉岩带的交界处所在，我们对大别山太湖地区的进行了1：10000地质填图，并详细研究了该地区榴辉岩的岩相学和矿物成分变化，以及KD值、峰期变质P-T条件。研究表明榴辉岩自南向北可分为三类：①朱家冲型榴辉岩；②大坝型榴辉岩；③金河桥型榴辉岩。其中朱家冲型榴辉岩和金河桥型榴辉岩显示出明显的温度、压力差异，它们形成的P-T条件分别为：P=2．14GPa、T=563℃和P=3．76GPa、T=791℃。大坝型榴辉岩的峰期变质P-T条件差别较大，在柯石英-石英相变线附近徘徊，变质环境相当于高压一超高压过渡环境。朱家冲型榴辉岩与大坝型榴辉岩分别对应于前人所划分的“冷”、“热”榴辉岩，并且两者在峰期，变质温、压条件上是连续变化的，没有明显的温、压间断。因此，我们认为本区所谓的“冷”、“热”榴辉岩带界线是不存在的。     

河流调整中的熵、熵产生和能耗率的变化

河流是一个真正的开放系统,而不是孤立系统或封闭系统。运用经典热力学和非平衡态热力学基本原理,分析研究了河流调整中的熵、熵产生和能耗率的变化。指出:熵和熵产生是两个不同的概念;最小熵产生原理等价于最小能耗率原理;冲积河流在调整过程中遵循最小熵产生原理或最小能耗率原理,而不是最大熵原理。     

某滑坡软弱夹层抗剪强度取值方法的研究

文章主要针对软弱夹层抗剪强度取值所存在的争议，通过对贵州新街子滑坡的软弱夹层分别选择比例极限、屈服极限及峰值作为剪应力值，采用最小二乘法获得比例抗剪强度、屈服抗剪强度和峰值抗剪强度。以参数选取中应用较为成熟的反分析方法推求力学性质参数c、φ值作为判据对以上3种参数进行比较。计算结果表明：本滑坡软弱夹层中由于含泥量较大，而且粘塑性较强，屈服抗剪强度和反分析得到的抗剪强度偏差最小，比例抗剪强度偏差最大，峰值抗剪强度居中。并以此3种抗剪强度进行天然状态下滑坡稳定性验算，结果表明选用比例极限抗剪强度与当前滑坡的地质现象不符，选用峰值极限抗剪强度安全储备较低，而选取屈服极限抗剪强度最为合理。用此参数进行设计，滑坡已经得到了良好的治理。在取值研究中认为采用试验与反分析相结合的方法确定滑坡稳定性计算参数是比较合理的。以上结论为滑坡中软弱夹层抗剪强度取值的选择提供了重要的依据。     

Privatizing conditions of production: trade agreements as neoliberal environmental governance

Recent multilateral trade agreements are among the major manifestations of neoliberalism. They are also emerging as some of the most important sites of environmental governance in the 21st century. I argue here that these trade agreements, particularly the sweeping new protections they provide for investors, are redefining property rights and environmental governance in fundamental ways. I suggest that in addition to furthering the centuries-long process of the enclosure of nature under capitalism, the neoliberal agenda of NAFTA and similar trade agreements also involves something new: the privatization, or primitive accumulation, of conditions of production as an accumulation strategy. I explore these dynamics through examination of two cases, one in the United States and one in Mexico. I also explore the roles of social movements in these dynamics.     

Aeolian abrasion and modes of fine particle production from natural red dune sands: an experimental study

A series of experiments was conducted to determine the potential for aeolian abrasion of natural dune sands to produce fine particles (< 125 µm) by (1) the release of resident fines; (2) spalling, chipping and breakage of particles; and (3) the removal of grain surface coatings. Parent samples were obtained from the surfaces of four active continental dunes and abraded using a glass ‘test tube’ chamber for up to 120 h. The fine particles produced by this abrasion process were trapped at varying time intervals and subject to detailed particle‐size analyses using a Coulter Multisizer. The abrasion of untreated parent samples produced fine particles in one of two main size classes, < 10 µm and > 50 µm, but when the parent sample was sieved to exclude particles < 250 µm, relatively more material in the range 10–50 µm was produced. For unsieved parent samples, the size range associated with the dominant mode varied according to the length of the abrasion time. The coarsest mode (> 63 µm) was dominant during the first 16 h of abrasion, then became less significant and is thought to be associated with the release of resident fines into suspension. The finest mode (< 10 µm) was absent or very weak during the first 16 h of abrasion, then became more significant and, in some instances, dominated the distribution as abrasion continued. Removal of grain surface coatings is the main source of fine material < 10 µm, and this may be a significant source of fine material in areas where sands are dominated by subrounded and rounded particles. By comparison with previous studies of aeolian particle abrasion, these natural dune sands produced very low quantities of fine material (by weight), but their spatial extent makes them potentially a significant source of dust‐sized particles at the global scale.