多块体形状堆石体碾压颗粒破碎数值模拟

通过6种典型堆石块体的形状近似,分别采用两种接触本构模型建立了多块体形状堆石体离散元数值模型,研究堆石体在碾压荷载作用下的颗粒破碎过程,建立颗粒破碎的量化计算方法,分析碾压前、后堆石级配曲线的变化,讨论接触本构模型和颗粒形状对块体破碎的影响。模拟结果显示,碾压荷载下堆石颗粒以张拉破碎为主,随着碾压遍数的增加,局部开始出现剪切破碎;提出的颗粒破碎量化计算方法,在大粒径范围对粒径变化幅度预测偏大,但级配曲线整体趋势与实测结果比较吻合;相比较于接触连接模型,平行连接模型与现场碾压试验结果更接近。6种块体形状的数值结果显示,随着形状系数的增加,在其他条件不变的情况下颗粒破碎率逐渐降低,其中类长方形块体在碾压荷载作用下颗粒破碎最明显。相比较于纯圆颗粒或者单一非圆颗粒,采用的6种颗粒形状建立的堆石体振动碾压离散元模型,更接近现场实际情况。     

土石混合料大型直剪试验的颗粒离散元细观力学模拟研究

土石混合料作为一种特殊的岩土介质越来越受到国内外众多研究者的重视。基于3维颗粒离散元PFC3D,建立了土石混合料直剪试验模型,进行了不同含石量、不同岩性的土石混合料直剪试验模拟研究。颗粒离散元模拟结果表明,土石混合料的石料岩性和含石量在很大程度上控制了土石混合料的抗剪强度特性。硬岩混合料的摩擦角普遍比软岩混合料大6°～ 7°,含石量为60%～80%时达到最大。土石混合料的剪切面不再是一个平面,其起伏度随含石量增加而增大。剪切过程中软岩混合料在低正应力下表现为剪胀,高正应力下表现为剪缩,并产生软化现象,硬岩混合料表现为剪胀和塑性;软岩土石混合料剪切过程中能量以应变能和动能为主,而硬岩土石混合料的能量以摩擦能和动能为主。     

基于PSO-PP的围岩稳定性评价

围岩的稳定性评价是一个复杂的不确定系统问题。结合投影寻踪方法、粒子群算法和逻辑斯谛曲线函数,建立了围岩稳定性评价的粒子群优化投影寻踪(projection pursuit based on particle swarm optimization,PSO-PP)模型。该模型一方面采用粒子群算法优化投影指标函数及逻辑斯谛曲线函数参数,确保了模型的准确性;另一方面利用逻辑斯谛曲线函数建立投影值与经验等级之间的非线性关系。模型的测试结果显示了良好的精度,实例分析结果与实际状态完全一致,表明该模型在围岩稳定性评价中的可行性和有效性。     

洞庭盆地中更新世洞庭湖组砾石特征及其意义

对位于洞庭盆地安乡凹陷东南部的两护村ZKC1孔中更新世洞庭湖组砾石层进行了粒度和砾态的统计分析.结果表明,砾石的粒度变化反映出2个较大尺度的由大→小的旋回,早旋回由洞庭湖组下段砂砾层组成,晚旋回由洞庭湖组中段上部的砂砾层组成,反映出中更新世早-中期安乡凹陷的两次由慢→快的幕式沉降过程.在上述2个大的粒度旋回之上,叠加有多个更小尺度的砾石粗、细变化,主要与气候干湿的频繁波动有关.洞庭湖组中段顶部砾石的磨圆度明显偏低,反映其沉积时期盆地沉降和周缘隆起区抬升活动的增强.     

An enhanced constitutive model for crushable granular materials

Studies in the past have tried to reproduce the mechanical behaviour of granular materials by proposing constitutive relations based on a common assumption that model parameters and parameters describing the properties, including gradation of individual grains are inevitably linked. However successful these models have proved to be, they cannot account for the changes in granular assembly behaviour if the grains start to break during mechanical loading. This paper proposes to analyse the relation between grading change and the mechanical behaviour of granular assembly. A way to model the influence of grain breakage is to use a critical state‐based model. The influence of the amount of grain breakage during loading, depending on the individual grain strength and size distribution, can be introduced into constitutive relations by means of a new parameter that controls the evolution of critical state with changes in grain size distribution. Experimental data from a calcareous sand, a quartz sand, and a rockfill material were compared with numerical results and good‐quality simulations were obtained. The main consequences of grain breakage are increased compressibility and a gradual dilatancy disappearance in the granular material. The critical state concept is also enriched by considering its overall relation to the evolution of the granular material. Copyright © 2009 John Wiley & Sons, Ltd.     

国际流行彩色宝石品质分级评估体系的比较及其启示

彩色宝石品质分级标准对彩色宝石市场的形成与发展具有重要意义。彩色宝石品种的多样性和品质影响要素的复杂性,加上不同国家、地区或民族对彩色宝石颜色的偏好不同,在国际市场上要建立一个统一的彩色宝石品质分级评估体系困难重重。通过比较各彩色宝石聚集地（如美国、泰国、中国香港与大陆等）现有的彩色宝石品质分级评估体系,探讨了不同体系对其颜色、净度、切工分级的思想与方法。结果显示,目前国际上不同彩色宝石分级体系在颜色分级术语上强调的要素有一定的差异,对净度分级在思路上有明显的不同,对切工分级则在思路及技术操作上均存在明显差异。因此,要建立统一的国际彩色宝石品质分级体系尚需时日。最后提出,中国可以尝试以宝石的净度和透明度分级为先导,结合颜色、净度与切工分级设计新的彩色宝石二级递进制（时尚首饰级和宝石级）品质评估分级体系。     

粗颗粒悬移质测验误差分析

本文根据流速与含沙量分布,研究了悬移质积点法对粗颗粒含沙量测验误差.首先指出无论从输沙率还是从悬浮高度看,粗颗粒悬移质集中于河底,致使水文测验中的一些测验方法(如一点法、二点法、三点法等)带有较大的误差.进而分析了各种测法对粗颗粒的相对误差,并且随着颗粒变粗,误差愈来愈大,以致不能接受.这种情况在水库下游河道冲刷过程中,会在一定程度上出现,必须重视研究和调整测验方法.最后通过与长江委水文局在沙市及监利两水文站试验结果对比,证明本文理论上的分析是可信的.     

Modelling the flow of self‐compacting concrete

A Lagrangian particle‐based method, smooth particle hydrodynamics (SPH), is used in this paper to model the flow of self‐compacting concretes (SCC) with or without short steel fibres. An incompressible SPH method is presented to simulate the flow of such non‐Newtonian fluids whose behaviour is described by a Bingham‐type model, in which the kink in the shear stress vs shear strain rate diagram is first appropriately smoothed out. The viscosity of the SCC is predicted from the measured viscosity of the paste using micromechanical models in which the second phase aggregates are treated as rigid spheres and the short steel fibres as slender rigid bodies. The basic equations solved in the SPH are the incompressible mass conservation and Navier–Stokes equations. The solution procedure uses prediction–correction fractional steps with the temporal velocity field integrated forward in time without enforcing incompressibility in the prediction step. The resulting temporal velocity field is then implicitly projected on to a divergence‐free space to satisfy incompressibility through a pressure Poisson equation derived from an approximate pressure projection. The results of the numerical simulation are benchmarked against actual slump tests carried out in the laboratory. The numerical results are in excellent agreement with test results, thus demonstrating the capability of SPH and a proper rheological model to predict SCC flow and mould‐filling behaviour. Copyright © 2010 John Wiley & Sons, Ltd.     

A smoothed particle hydrodynamics modelling of soil–water mixing and resulting changes in average strength

Soil–water interaction is a pivotal process in many underwater geohazards such as underwater landslides where soil sediments gradually evolve into turbidity currents after interactions with ambient water. Due to the large deformations, multiphase interactions and phase changes this involves, investigations from numerical modelling of the transition process have been limited so far. This study explores a simple numerical replication of such soil–water mixing with respect to changes in average strength using smoothed particle hydrodynamics (SPH). A uniform viscoplastic model is used for both the solid-like and fluid-like SPH particles. The proposed numerical solution scheme is verified by single-phase dam break tests and multiphase simple shear tests. SPH combinations of solid-like and fluid-like particles can replicate the clay–water mixture as long as the liquidity index of the solid-like particles is larger than unity. The proposed numerical scheme is shown to capture key features of an underwater landslide such as hydroplaning, water entrainment and wave generation and thus shows promise as a tool to simulate the whole process of subaquatic geohazards involving solid–fluid transition during mass transport.     

北京市春夏季大气气溶胶的单颗粒分析表征

采集了北京市2000年春夏季大气气溶胶样品5个，采用扫描电镜X射线能谱技术分析大气气溶胶单颗粒约2500个。研究结果表明，沙尘期间，矿物尘是最主要的颗粒物种类，非沙尘期间，北京市大气气溶胶中主要检出矿物尘和含硫颗粒物。夏季随着颗粒物污染的加重，含硫颗粒物的数目百分数增加。是北京市大气颗粒物污染的重要特征。重点讨论了Ca-S颗粒、K-S颗粒和Ca-K-S颗粒三类典型含硫颗粒物的化学组成和粒径分布特征。数目可观的Ca-K-S颗粒以及其他硫酸盐颗粒的生成与相对湿度和云量等气象条件相关，这些颗粒物可能是云中过程的产物。减少SO2排放，减少含硫颗粒物，对于控制北京市的大气颗粒物浓度水平具有重要意义。