The propagation of a single shear crack: A displacement discontinuity model

Numerical studies using the displacement discontinuity method show that a single shear crack under compression propagates in its own direction, because such propagation results in the maximum release of strain energy. The methods of linear elastic fracture mechanics may not be used for such a closed crack, and the stress intensity factors are meaningless in that case. Laboratory observations of propagation by means of kinks at an angle of approximately 70° to the crack may be due to heterogeneities, to the effect of a preexisting crack, to end effects, to microcracking, or to some combination of these factors. Such kinks may thus be local phenomena which cannot release most of the strain energy, and are not incompatible with our numerical results which are based on a global energy balance.     

扬子地台前寒武纪－寒武纪界线地层的微体植物化石群

前寒武纪一寒武纪界线地层在扬子地台发育良好、分布广泛,并有包括微体植物群、海藻、瓶形原生物、具硬体动物及‘澄江动物群’等化石的发现。因而,扬子地台成为研究前寒武纪－寒武纪界线生物地层的代表地区之一。基于对扬子地台前寒武纪－寒武纪界线地层已知微体植物化石记录的回顾和论定,总结概括了下寒武统微体植物化石组合：寒武系最底部硅质磷块岩中的Ｍｉｃｒｈｙｓｔｒｉｄｉｕｍ－Ｐａｒａｃｙｍａｔｉｏｓｐｈａｅｒａ－Ｍｅｇａｔｈｒｉｘ组合和较高层位页岩的Ｓｋｉａｇｉａ－Ａｎｎｕｌｕｍ－Ａｒｃｈａｅｏｄｉｓｃｉｎａ组合。它们分别与Ａｎａｂａｒｉｔｅｓ－Ｃｉｒｃｏｔｈｅｃａ－Ｐｒｏｔｏｈｅｒｔｚｉｎａ小壳动物化石带和Ｐａｒａｂａｄｉｅｌｌａ及Ｅｏｒｅｄｌｉｃｈｉａ三叶虫带相对应。与东欧地台疑源类生物地层相对照,扬子地台Ｍｉｃｒｈｙｓｔｒｉｄｉｕｍ－Ｐａｒａｃｙｍａｔｉｏｓｐｈａｅｒａ－Ｍｅｇａｔｈｒｉｘ组合的纵向分布大体和东欧地台Ａｓｔｅｒｉｄｉｕｍｔｏｒｎａｔｕｍ－Ｃｏｍａｓｐｈａｅｒｉｄｉｕｍｖｅｌｖｅｔｕｍ组合带相一致,而以上两地台的化石组合产出层位可能都略高于纽芬兰东部剖面,依据Ｐｈｙｃｏｄｅｓｐｅｄｕｍ所厘定的寒武系底界?     

Measurements of peroxyacetylnitrate in the marine boundary layer over the Atlantic

The atmospheric concentration of peroxyacetylnitrate (PAN) was measured during a cruise of the R.S. Polarstern from Bremerhaven (Germany) to Rio Grande do Sul (Brazil) in September/ October 1988. The measurements were made in-situ by a combination of electron capture gaschromatography with a cryogenic preconcentration step. The theoretical lower limit of detection (3) was 0.4 ppt. The mixing ratios of PAN varied by more than three orders of magnitude from 2000 ppt in the English Channel to less than 0.4 ppt south of the Azores (38° N). South of 35° N, PAN levels were below the detection limit, except at 30–31° S off the eastern coast of South America. Here, PAN mixing ratios of 10 to 100 ppt were detected in continentally influenced air masses. Detectable levels of PAN were mostly observed in air masses of continental or high northern origin. Changes in the wind directions were usually associated with substantial changes in the PAN mixing ratios.     

Mantle plumes from top to bottom

Hotspots include midplate features like Hawaii and on-axis features like Iceland. Mantle plumes are a well-posed hypothesis for their formation. Starting plume heads provide an explanation of brief episodes of flood basalts, mafic intrusions, and radial dike swarms. Yet the essence of the hypothesis hides deep in the mantle. Tests independent of surface geology and geochemistry to date have been at best tantalizing. It is productive to bare the current ignorance, rather than to dump the plume hypothesis. One finds potentially fruitful lines of inquiry using simple dynamics and observations. Ancient lithospheric xenoliths may reveal heating by plumes and subsequent thermal equilibration in the past. The effect at the base of the chemical layer is modest 50-100 K for transient heating by plume heads. Thinning of nonbuoyant platform lithosphere is readily observed but not directly attributable to plumes. The plume history in Antarctica is ill constrained because of poor geological exposure. This locality provides a worst case on what is known about surface evidence of hotspots. Direct detection of plume tail conduits in the mid-mantle is now at the edge of seismic resolution. Seismology does not provide adequate resolution of the deep mantle. We do not know the extent of a chemically dense dregs layer or whether superplume regions are cooler or hotter than an adiabat in equilibrium with the asthenosphere. Overall, mid-mantle seismology is most likely to give definitive results as plume conduits are the guts of the dynamic hypothesis. Finding them would bring unresolved deep and shallow processes into place.     

Tectonic relation between northeastern China and the Korean peninsula revealed by interpretation of GRACE satellite gravity data

The major continental blocks in northeastern Asia are the North China block and the South China block, which have collided starting from the Korean peninsula. Geologic and geophysical interpretations reveal a well defined suture zone in northeastern China from Qinling through Dabie to Jiaodong. The discovery of high-pressure metamorphic rocks in the Hongseong area of the Korean peninsula, prominent evidence for the collision zone, indicates extension of the collision zone in northeastern China into the Korean peninsula. Interpretation of the GRACE satellite gravity dataset shows two prominent structural boundaries in the Yellow Sea. One extends from the Jiaodong Belt in eastern China to the Imjingang Belt in the Korean peninsula. The other extends from near Nanjing, eastern China, to Hongseong. Tectonic movement in or near the suture zone may be responsible for seismic activity in the western Korean peninsula and the development of the Yellow Sea sedimentary basin.     

Seismic lamination and anisotropy of the Lower Continental Crust

Seismic lamination in the lower crust associated with marked anisotropy has been observed at various locations. Three of these locations were investigated by specially designed experiments in the near vertical and in the wide-angle range, that is the Urach and the Black Forrest area, both belonging to the Moldanubian, a collapsed Variscan terrane in southern Germany, and in the Donbas Basin, a rift inside the East European (Ukrainian) craton. In these three cases, a firm relationship between lower crust seismic lamination and anisotropy is found. There are more cases of lower-crustal lamination and anisotropy, e.g. from the Basin and Range province (western US) and from central Tibet, not revealed by seismic wide-angle measurements, but by teleseismic receiver function studies with a P–S conversion at the Moho. Other cases of lamination and anisotropy are from exhumed lower crustal rocks in Calabria (southern Italy), and Val Sesia and Val Strona (Ivrea area, Northern Italy). We demonstrate that rocks in the lower continental crust, apart from differing in composition, differ from the upper mantle both in terms of seismic lamination (observed in the near-vertical range) and in the type of anisotropy. Compared to upper mantle rocks exhibiting mainly orthorhombic symmetry, the symmetry of the rocks constituting the lower crust is either axial or orthorhombic and basically a result of preferred crystallographic orientation of major minerals (biotite, muscovite, hornblende). We argue that the generation of seismic lamination and anisotropy in the lower crust is a consequence of the same tectonic process, that is, ductile deformation in a warm and low-viscosity lower crust. This process takes place preferably in areas of extension. Heterogeneous rock units are formed that are generally felsic in composition, but that contain intercalations of mafic intrusions. The latter have acted as heat sources and provide the necessary seismic impedance contrasts. The observed seismic anisotropy is attributed to lattice preferred orientation (LPO) of major minerals, in particular of mica and hornblende, but also of olivine. A transversely isotropic symmetry system, such as expected for sub-horizontal layering, is found in only half of the field studies. Azimuthal anisotropy is encountered in the rest of the cases. This indicates differences in the horizontal components of tectonic strain, which finally give rise to differences in the evolution of the rock fabric.     

Attenuation of aqueous metal transport at two natural acid rock drainage occurrences in the Yukon Territory, Canada

Naturally acidic drainage associated with pyritic black shale has been observed in many locations in the Yukon Territory. While not necessarily linked to known mineral deposits, most of these natural acid rock drainage occurrences show elevated dissolved concentrations of trace elements, especially zinc, nickel, copper, cadmium and arsenic. Based on field observations, microbial investigation, chemical analyses and geochemical modeling, the fate and transport of potentially deleterious elements at two natural acid drainage occurrences with slightly different settings are examined. The Macintosh Creek is a small, acidic stream （pH 2.98-3.40）, 2 km long, located in the Macmillan Pass area of east-central Yukon amidst known sedimentary exhalative massive sulfide mineralization but remains undisturbed by exploration activities. Its trace metal content is apparently derived from groundwater discharges, which gave as much as 5.0, 2.5, 0.7, 0.13 and 0.03 mg/L ofZn, Ni, Cu and As, respectively. Interaction and sorption reactions with algal mats, biofilms and iron oxyhydroxides appear to be the dominant mechanisms attenuating aqueous contaminant transport along the stream. Cryogenic precipitation further consolidates the ferricrete formation and reduces the mobility of the sorbed metals. The tributaries of the Engineering Creek along the Dempster Highway in northern Yukon drain through a series of dolomite, phyllite, argillite, limestone, black shale, sandstone and conglomerate with no known concentration of mineralization. In this area, the water chemistry fully reflects the local geology with acidic streams invariably associated with black shale occurrences. Groundwater seeps in the headwaters area of the km-180 Creek completely enclosed in black shale gave pH 3.0 and as much as 148, 39, 2.9 and 9.1 mg/L of Zn, Ni, Cu and As, respectively. Sorption with iron oxyhydroxide and organic matter appear to dominate the attenuation of contaminant transport along the stream. However, once entered into carbonate-dominated terrains, secondary carbonate minerals exercise additional geochemical control on the local water chemistry as a result of neutralization.     

Naturally acidic and metalliferous waters at unmined volcanogenic massive sulfide deposits in the Bonnifield mining district, Alaska Range, east-central Alaska

The Bonnifield district hosts 26 tmmined volcanogenic massive sulfide （VMS） occurrences. Environmental geochemical samples of water and stream sediment were collected at several occurrences, concentrating on the two best-exposed and largest deposits, Red Mountain （RM） and Sheep Creek （SC）. Limited samples were also collected at the poorly exposed WTF deposit. The deposits are Late Devonian to Early Mississippian, and are hosted by felsic metavolcanic and carbonaceous schist members of the Totatlanika Schist or Keevy Peak Fm. Spring and stream waters at RM and SC have pH values commonly 〈3.5 （as low as 2.4 at RM and 2.5 at SC）, high conductivity （up to 11000 μS/cm）, and very high （Is to 100s mg/L） dissolved contents of Al, Cd, Co, Cu, Fe, Ni, and Pb. Waters at RM are characterized by extremely high REE contents （summed REE median 3200 μg/L, n=33）. At both RM and SC, pyrite oxidation and dissolution produce low pH waters that interact with and dissolve bedrock minerals, resulting in acidic, metal-laden, naturally degraded streams that are mostly devoid of aquatic life. Ferricrete is common. In contrast, WTF barely produces a surficial environmental footprint, mostly due to topography and relief. RM and SC are well exposed in the areas of relatively high relief, and both exhibit extensive areas of quartz-sericite-pyrite-alteration. While WTF shares many of the same deposit-and alteration characteristics, it is concealed by tundra in a large, nearly flat area. Surface water at WTF is absent and outcrops are sparse. Even though WTF is roughly the same size as Red Mountain （both around 3 million tonnes） and has similar base- and precious-metal grades, the surficial geochemical manifestation of WTF is minimal. However, exposure through mining of the altered, mineralized rock at WTF potentially could initiate the same processes of pyrite oxidation, acid generation, and mineral dissolution that are observed naturally at RM and SC.     

Drainage spacing regularity on a fault-block: A case study from the eastern Ruahine Range

Abstract:  Recent research has indicated river basin outlets draining linear sections of large, uplifting mountain belts often show a regularity of spacing, transverse to the main structural trend. A morphometric analysis of part of the Ruahine Range, on the North Island was undertaken to test whether drainage regularity may exist in smaller, younger mountain ranges. The ratio, R , of the half-width of the mountain belt, W , and the outlet spacing, S , was used to characterize drainage networks on the eastern side of the range. The spacing ratio for the range of 1.31 is lower than R results from studies of larger mountain belts ( R  = 1.91–2.23). We suggest the cause of this lower ratio is related to eastward migration of the Ruahine drainage divide.