A New Interpretation of Centimetre-scale Variations in the Progress of Infiltration-driven Metamorphic Reactions: Case Study of Carbonated Metaperidotite, Val d'Efra, Central Alps, Switzerland

Progress () of the infiltration-driven reaction, 4olivine +5CO₂ + H₂O = talc + 5magnesite, that occurred during Barrovianregional metamorphism, varies at the cm-scale by a factor of3·5 within an 3 m³ volume of rock. Mineral and stableisotope compositions record that X_CO2, ¹⁸O_fluid, and ¹³C_fluidwere uniform within error of measurement in the same rock volume.The conventional interpretation of small-scale variations in in terms of channelized fluid flow cannot explain the uniformityin fluid composition. Small-scale variations in resulted insteadbecause (a) reactant olivine was a solid solution, (b) initiallythere were small-scale variations in the amount and compositionof olivine, and (c) fluid composition was completely homogenizedover the same scale by diffusion–dispersion during infiltrationand subsequent reaction. Assuming isochemical reaction, spatialvariations in image variations in the (Mg + Fe)/Si of the parentrock rather than the geometry of metamorphic fluid flow. Ifinfiltration-driven reactions involve minerals fixed in composition,on the other hand, spatial variations in do directly imagefluid flow paths. The geometry of fluid flow can never be determinedfrom geochemical tracers over a distance smaller than the oneover which fluid composition is completely homogenized by diffusion–dispersion. KEY WORDS: Alpine Barrovian metamorphism; diffusion; metamorphic fluid composition; metamorphic fluid flow; reaction progress     

裂隙岩质边坡地下水渗流数值模拟

本文从反倾向岩质高边坡的渗流特征和渗流普遍规律出发,根据渗流力学知识,建立数学模型,通过渗流数值模拟计算分析了渗透压力、水头变化规律以及对岩质边坡稳定性的影响.     

四川省宁南县主要地质灾害特征及防御对策

宁南县属地质灾害频发区。主要地质灾害点共有31处。威胁6757人的生命财产安全。其中对城镇发生直接威胁4处，学校威胁3处，度假山庄威胁1处，潜在经济损失达22765万元。本文在详细论述地质灾害体特征的基础上并提出了相应的防御对策，提出对当地居民构成重大生命财产威胁的共5处，需采取治理措施，以减少地质灾害的发生。     

Estimation of irrigation return flow on monthly time resolution using SWAT model under limited data availability

ABSTRACT

This study is an assessment of the return flow ratio of an irrigation abstraction using the flow records of a downstream stream-gauging station, with the example of the Kozluk scheme irrigated by diverted water from Garzan Creek flowing through the southeastern region of Turkey. In the planning reports of the major dam projects of the region, an unverified return ratio was assumed in eliminating the influence of this irrigation on the flow measurements of Garzan Creek. The correctness of this assumed return ratio is evaluated by analysing the monthly streamflow measurements of the Besiri station through a Soil and Water Assessment Tool (SWAT) model constructed with the coarse-scale topography, land use and soil data from open source databases. The results show the necessity of irrigation project-based return flow analyses using regional fine-scale datasets, instead of rule-of-thumb assumptions, to determine the effects of irrigation activities on flow regimes more accurately.     

GIS支持下的东川区泥石流危险度区划

在建立东川区泥石流信息系统的基础上,根据泥石流形成原因,初步选择面积、相对切割度、主沟沟床比降、相对高差、主沟长度、圆状率作为评价指标,利用东川区21条典型泥石流沟的数据,通过主成分分析,选择出面积、圆状率、相对高差三个指标,由主成分载荷得到危险度评价公式,在ARC／INFO和ARCVIEW软件的支持下,把东川区划分为60个评价单元,计算出各个单元内的危险度总分值,依据分值划分为四个级别,重度危险区、危险区、轻度危险区和基本无危险区,最后根据泥石流危险度区划原则,得到东川区泥石流危险度区划图。     

Parameters affecting maximum fluid transport in large aperture fractures

We present results of laboratory experiments to study the behavior of liquids moving in unsaturated wide-aperture fractures. A 5-mm-thick glass plate cut with a 1.7-mm aperture was used as a fractured rock analog to study behavior of film and capillary droplet flow modes. Flow rates ranged between 0.6 and 6.0 ml/min. Variability in the ambient barometric pressure, resulting from weather conditions, seemed to play a role in the natural selection of flow mode. For droplet mode, constant input conditions resulted in highly variable transport properties within the fracture. The advancing meniscus exhibited a dynamic contact angle that was a function of the droplet speed and much larger than the static contact angle. Flow rate was reduced due to the larger contact angle. Analytical expressions for droplet velocity and flow capacity are presented as a function of the dynamic rather than the static contact angle.     

Sewage treatment level and flow rates affect polychaete assemblages

The European Water Framework Directive (WFD) and the Urban Wastewater Treatment Directive (UWWTD) aim to improve water quality and reduce the environmental impact of wastewater, by requiring member states to introduce better treatment levels. This study was carried out in order to detect the most suitable treatment type or flow level for reducing benthic environmental impact. Therefore, soft-bottom polychaete assemblages affected by discharges of six treatment plants, with different treatment technologies and flow rates, were analysed over three consecutive years. Polychaete assemblages changed as a result of sewage discharge. These changes were related to treatment level and flow rates. Both disposal quality and quantity are important since changes in soft-bottom assemblages in stations affected by pre-treated sewage with medium and high flow rates are observed. However, the location with a low-flow pre-treated effluent has similar polychaete assemblages with regard to locations with biological treatment or controls.     

Numerical simulation of ground flow caused by seismic liquefaction

Flow failure of sandy subsoil induced by seismic liquefaction is known to cause significant damage to structures. It is induced not only by the dynamic forces exerted by seismic acceleration but also by the static gravity force in consequence of the topography of the ground. The ground flow may sometimes continue after the end of the seismic loading and finally the ground is significantly deformed to cause a failure.This paper numerically predicts the magnitude of flow that could occur when soil liquefaction continues for a sufficiently long period. It is considered that liquefied soil behaves like a viscous liquid, and hence, ground flow is governed by the principle of minimum potential energy. In the calculation, liquefied sand is assumed to be a viscous liquid that deforms in undrained conditions with its volume remaining constant. To consider the non-linearity due to large displacement, the updated Lagrangian method is used to solve the equation of motion. The Newmark β method is employed to calculate the time history of the ground motion. Finally, a simulation using this calculation method shows that the proposed method gives reasonable results for the conditions indicated.     

Effects of a sill on selective withdrawal through a point sink in a linearly stratified fluid

Reservoir topography has significant effects on mechanism of selective withdrawal. We study selective withdrawal of a linearly stratified fluid through a point sink in a long rectangular reservoir with a sill at the bed experimentally and analytically. Experiments were conducted for various flow rates and sill heights to evaluate their effects on withdrawal layer in the inertial-buoyancy regime. Transition to the steady state is discussed in terms of dynamics of shear waves over the sill. The results show that in presence of a sill the withdrawal layer is thicker and higher in elevation. For flows controlled at the sill crest, the withdrawal layer thickness in the point-sink flow is almost equal to that in the similar line-sink flow. We propose an analytical relation for the withdrawal layer thickness in presence of a sill and confirm it by experiments.     

Characteristics of particle size for creeping and saltating sand grains in aeolian transport

Creep and saltation are the primary modes of surface transport involved in the fluid‐like movement of aeolian sands. Although numerous studies have focused on saltation, few studies have focused on creep, primarily because of the experimental difficulty and the limited amount of theoretical information available on this process. Grain size and its distribution characteristics are key controls on the modes of sand movement and their transport masses. Based on a series of wind tunnel experiments, this paper presents new data regarding the saltation flux, obtained using a flat sampler, and on the creeping mass, obtained using a specifically designed bed trap, associated with four friction velocities (0·41, 0·47, 0·55 and 0·61 m sec^?1). These data yielded information regarding creeping and saltating sand grains and their particle size characteristics at various heights, which led to the following conclusions: (i) the creeping masses increased as a power function (q = ?1·02 + 14·19u_*³) of friction wind velocities, with a correlation (R²) of 0·95; (ii) the flux of aeolian sand flow decreases exponentially with increasing height (q = a exp(–z/b)) and increases as a power function (q = ?26·30 + 428·40 u_*³) of the friction wind velocity; (iii) the particle size of creeping sand grains is ca 1·15 times of the mean diameter of salting sand grains at a height of 0 to 2 cm, which is 1·14 times of the mean diameter of sand grains in a bed; and (iv) the mean diameter of saltating sand grains decreases rapidly with increasing height whereas, while at a given height, the mean diameter of saltating sand grains is positively correlated with the friction wind velocity. Although these results require additional experimental validation, they provide new information for modelling of aeolian sand transport processes.