粉煤灰浸出特性试验研究

利用浸出试验方法,对火电厂粉煤灰进行浸出特性的测定,对其有害特性进行鉴别并分析其浸出规律,从而为地下水受粉煤灰排水影响后的水质预测、堆灰场选址、环境影响评价提供依据.     

地下导线随盾构推进逐段接测中的可靠性检验

盾构法施工的要点是需要在井下布设高精度的控制支导线，当我们根据盾构推进进度对导线接测时，由于观测条件、观测方法、观测仪器基本相同，但观测、的成果往往会存在一定的差异，有时我们无法直接判断成果的正确与否，此时，采用测量平差中的统计检验的方法来分析这些观测数据，可以取得比较满意的结果。     

淮河流域土壤湿度异常的时空分布特征及其与气候异常关系的初步研究

利用中国东部1990~2000年旬平均土壤湿度、降水和气温观测资料，通过对0~50 cm层次土壤湿度进行旋转主分量分析 (REOF)，重点分析了淮河流域土壤湿度的时空分布特征, 并初步研究了土壤湿度与前期、同期和后期不同时段降水与气温的关系。发现春季以30 cm为界，30 cm以上各层土壤湿度异常的第一旋转空间模态十分相似, 其大值中心主要位于淮河流域，而30 cm以下 (30~50 cm) 各层的第二旋转空间模态与之亦十分类似, 因此称该模态为“淮河型”，而夏季和秋季虽然该模态也很显著, 但特征不如春季突出。该模态在各层次土壤中具有明显的持续性特征，均存在40旬左右的显著周期；并与前期和同期降水（气温）呈显著正 (负) 相关关系，与约半年后的降水 (气温) 呈负 (正) 相关关系。     

近百年中国东部夏季降水的时空变率

利用中国东部25°N以北28个站1880-1999年夏季季降水序列,用旋转复经验正交函数（RCEOF）方法,研究了中国东部地区百年干湿的时空演变规律。结果表明,夏季降水空间变率大值区依次为:长江中下游地区、淮河流域、江南、华北、西南及东北。除西南外的5个关键区大体上反映了从6月到8月夏季雨带自南向北椎进所滞留的地区。旋转空间位相分布揭示了长江中下游地区、江南、东北的旱涝异常主要表现为驻波振动特征;而淮河流域、华北、西南地区显示出降水异常信号具有部分的行波特征。尤其第4空间模显示出旱涝异常信号从东北南部可沿着黄淮下游传到长江下游地区。对于近百年中国东部地区夏季于湿变化,长江中下游地区、淮河流域、华北及东北四个地区都存在20-25年时间尺度的周期振荡;长江中下游地区及华北地区都存在准60年时间尺度的振荡周期;东北地区主要表现出36年时间尺度的振荡周期;淮河流域存在明显的70-80年时间尺度的振荡周期;华北地区存在的11年时间尺度的振荡周期恰好与太阳黑子活动的11年周期相一致。在年代际时间尺度（包括次年代际时间尺度）上,长江中下游、淮河流域及华北地区的夏季降水的变化与太阳活动有显著的正相关。     

用940 nm通道遥感水汽总量的可行性试验

在940 nm水汽弱吸收带和其附近窗区选取若干探测通道, 采取不同通道组合, 模拟计算通道反射率比值, 并建立了该比值与水汽含量之间的统计关系。用探空观测独立样本检验水汽含量模拟计算结果, 相对误差小于6%。     

DGSC—203型液动射流冲击器在地热井的试验

介绍了新研制的DGSC－203石油钻井液动射液冲击器的性能参数及结构设计上的创新点，测试所获得的排量与压降之间的关系曲线可指导冲击器的使用。生产性试验证明该冲击器工作稳定，可大幅度提高硬地层钻井效率，克服钻柱振动，延长钻柱的使用寿命，具有良好应用前景。     

A mathematical hysteretic model for elastomeric isolation bearings

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Damaging properties of ground motions and prediction of maximum response of structures based on momentary energy response

Dynamic damaging potential of ground motions must be evaluated by the response behaviour of structures, and it is necessary to indicate what properties of ground motions are most appropriate for evaluation. For that purpose, the behaviour of energy input process and hysteretic energy dissipation are investigated in this study. It is found that the momentary input energy that is an index for the intensity of input energy is related to the characteristics of earthquakes such as cyclic or impulsive, and to the response displacement of structures immediately. On the basis of these results, a procedure is proposed to predict inelastic response displacement of structures by corresponding earthquake input energy to structural dissipated damping and hysteretic energy. In this procedure the earthquake response of structures is recognized as an input and dissipation process of energy, and therefore structural properties and damaging properties of ground motions can be taken into account more generally. Lastly, the studies of the pseudodynamic loading test of reinforced concrete structure specimens subjected to ground motions with different time duration are shown. The purpose of this test is to estimate the damaging properties of ground motions and the accuracy of the proposed prediction procedure. Copyright © 2002 John Wiley & Sons, Ltd.     

Study on effects of damping in laminated rubber bearings on seismic responses for a ⅛ scale isolated test structure

The effects of damping in various laminated rubber bearings (LRB) on the seismic response of a ?‐scale isolated test structure are investigated by shaking table tests and seismic response analyses. A series of shaking table tests of the structure were performed for a fixed base design and for a base isolation design. Two different types of LRB were used: natural rubber bearings (NRB) and lead rubber bearings (LLRB). Three different designs for the LLRB were tested; each design had a different diameter of lead plug, and thus, different damping values. Artificial time histories of peak ground acceleration 0.4g were used in both the tests and the analyses. In both shaking table tests and analyses, as expected, the acceleration responses of the seismically isolated test structure were considerably reduced. However, the shear displacement at the isolators was increased. To reduce the shear displacement in the isolators, the diameter of the lead plug in the LLRB had to be enlarged to increase isolator damping by more than 24%. This caused the isolator stiffness to increase, and resulted in amplifying the floor acceleration response spectra of the isolated test structure in the higher frequency ranges with a monotonic reduction of isolator shear displacement. Copyright © 2002 John Wiley & Sons, Ltd.